Catalogue Search | MBRL
Are you sure you want to remove the book from the shelf?
{{itemTitle}}
24
result(s) for
"Quan, Yi-ji"
Sort by:
Drought-induced alterations in photosynthetic, ultrastructural and biochemical traits of contrasting sugarcane genotypes
Drought is an important factor which limits growth of sugarcane. To elucidate the physiological and biochemical mechanisms of tolerance, a pot experiment was conducted at Sugarcane Research Institute, Kaiyuan, China. Two genotypes (Yuetang 93-159-sensitive and Yunzhe 05-51-tolerant), were subjected to three treatments; 70±5% (control), 50±5% (moderate drought) and 30±5% (severe drought) of soil field capacity. The results demonstrated that drought induced considerable decline in morpho-physiological, biochemical and anatomical parameters of both genotypes, with more pronounced detrimental effects on Yuetang 93-159 than on Yunzhe 05-51. Yunzhe 05-51 exhibited more tolerance by showing higher dry biomass, photosynthesis and antioxidant enzyme activities. Compared with Yuetang 93-159, Yunzhe 05-51 exhibited higher soluble sugar, soluble protein and proline contents under stress. Yunzhe 05-51 illustrated comparatively well-composed chloroplast structure under drought stress. It is concluded that the tolerance of Yunzhe 05-51 was attributed to improved antioxidant activities, osmolyte accumulation and enhanced photosynthesis. These findings may provide valuable information for future studies on molecular mechanism of tolerance.
Journal Article
Effect of cutting depth during sugarcane (Saccharum spp. hybrid) harvest on root characteristics and yield
Ratooning is an important cultivation practice in sugarcane production around the world, with underground buds on the remaining stalk acting as the source for establishment of a subsequent ratoon crop. However, the optimal depth of cutting during harvest in terms of yield and root growth remains unknown. We carried out a two-year field study to determine the effects of three cutting depths (0, 5 and 10 cm below the surface) ratoon cane root and yield. Results showed that cutting to a depth of 5 cm increased the root fresh weight and root volume by 21–59% and 41–127%, respectively, compared to cutting depths of 0 and 10 cm. Remarkably, cutting to a depth of 5 cm also had a significant effect on the development of fine roots, which is closely linked to cane yield. The effect was particularly noticeable in terms of two root traits, root volume and the surface area of roots with a diameter of 1.0–2.0mm, and root length and the number of root tips in roots with a diameter of 0–0.5mm. As a result, a cutting depth of 5 cm below the surface increased cane yield by 43 and 28% compared to depths of 0 and 10 cm below the surface, respectively. Overall, these findings suggest that a cutting depth of 5 cm is optimal in terms of sugarcane yield, largely due to the enhanced effect on root traits, especially the development of fine roots. These findings will help optimize sugarcane ratoon management and improve the ratoon cycle.
Journal Article
Correction: Effect of cutting depth during sugarcane (Saccharum spp. hybrid) harvest on root characteristics and yield
[This corrects the article DOI: 10.1371/journal.pone.0238085.].
Journal Article
Effect of cutting depth during sugarcane
Ratooning is an important cultivation practice in sugarcane production around the world, with underground buds on the remaining stalk acting as the source for establishment of a subsequent ratoon crop. However, the optimal depth of cutting during harvest in terms of yield and root growth remains unknown. We carried out a two-year field study to determine the effects of three cutting depths (0, 5 and 10 cm below the surface) ratoon cane root and yield. Results showed that cutting to a depth of 5 cm increased the root fresh weight and root volume by 21-59% and 41-127%, respectively, compared to cutting depths of 0 and 10 cm. Remarkably, cutting to a depth of 5 cm also had a significant effect on the development of fine roots, which is closely linked to cane yield. The effect was particularly noticeable in terms of two root traits, root volume and the surface area of roots with a diameter of 1.0-2.0mm, and root length and the number of root tips in roots with a diameter of 0-0.5mm. As a result, a cutting depth of 5 cm below the surface increased cane yield by 43 and 28% compared to depths of 0 and 10 cm below the surface, respectively. Overall, these findings suggest that a cutting depth of 5 cm is optimal in terms of sugarcane yield, largely due to the enhanced effect on root traits, especially the development of fine roots. These findings will help optimize sugarcane ratoon management and improve the ratoon cycle.
Journal Article
Effects of irrigation water salinity on soil salt content distribution, soil physical properties and water use efficiency of maize for seed production in arid Northwest China
In order to explore the use of groundwater resources, field experiments were conducted for three consecutive years during 2012-2014 in the Shiyang River basin of Northwest China. Irrigation was conducted using four different water salinity levels that were arranged in a split plot design. These four water salinity levels were s0, s3, s6 and s9 (0.71, 3, 6 and 9 g/L, respectively). The soil salt content, soil bulk density, soil porosity, saturated hydraulic conductivity, plant height, leaf area index and yield of maize for seed production were measured for studying the effects of saline water irrigation on soil salt content distribution, soil physical properties and water use efficiency. It was observed that higher salinity level of irrigation water and long duration of saline water irrigation resulted in more salt accumulation. Compared to initial values, the soil salt accumulation in 0-100 cm soil layer after three years of experiments for s0, s3, s6 and s9 was 0.189 mg/cm3, 0.654 mg/cm3, 0.717 mg/cm3 and 1.135 mg/cm3, respectively. Both greater salt levels in the irrigation water and frequent saline water irrigation led to greater soil bulk density, but poorer soil porosity and less saturated hydraulic conductivity. The saturated hydraulic conductivity decreased with increase in soil bulk density, but increased with improvement in soil porosity. It was noted that the maize height, leaf area index and maize yield gradually decreased with increase in water salinity. The maize yield decreased over 25% and the water use efficiency also gradually declined when irrigated with water containing 6 g/L and 9 g/L salinity levels. However, maize yield following saline water irrigation with 3 g/L decreased less than 20% and the decline in water use efficiency was not significant during the three-year experiment period. The results demonstrate that irrigation with saline water at the level of 6 g/L and 9 g/L in the study area is not suitable, while saline water irrigation with 3 g/L would be acceptable for a short duration together with salt leaching through spring irrigation before sowing.
Journal Article
Clinical outcome of treating intractable hematospermia using holmium laser incision through a ureteroscope
Aconventional procedure for treating hematospermia is to insert a ureteroscope or seminal vesiculoscope into the prostatic utr/de through the urethra, and then dilate the ejaculatory duct opening using the scope or the catheter. However, the ejaculatory duct stenosis may occur after the simple ureteroscopy. We compared the outcomes of treating hematospermia using holmium laser incision through a ureteroscope and using simple ureteroscopy. Retrospective method was used to analyze 67 intractable hematospermia cases. Varying degrees of ejaculatory duct stenosis or obstruction were observed in all the patients. Postoperative follow-up was conducted for 6 months up to 3 years. Two patients who underwent the simple ureteroscopy experienced hematospermia recurrence in 6 and 8 months, respectively. No recurrence was found in all the patients who underwent the holmium laser incision. We have found that the holmium laser incision through a ureteroscope shows a better outcome than the simple ureteroscop~
Journal Article
Effect of cutting depth during sugarcane harvest on root characteristics and yield
Ratooning is an important cultivation practice in sugarcane production around the world, with underground buds on the remaining stalk acting as the source for establishment of a subsequent ratoon crop. However, the optimal depth of cutting during harvest in terms of yield and root growth remains unknown. We carried out a two-year field study to determine the effects of three cutting depths (0, 5 and 10 cm below the surface) ratoon cane root and yield. Results showed that cutting to a depth of 5 cm increased the root fresh weight and root volume by 32-40% and 49-85%, respectively, compared to cutting depths of 0 and 10 cm. Remarkably, cutting to a depth of 5 cm also had a significant effect on the development of fine roots, which is closely linked to cane yield. The effect was particularly noticeable in terms of two root traits, root volume and the surface area of roots with a diameter of 1.0-2.0mm, and root length and the number of root tips in roots with a diameter of 0-0.5mm. As a result, a cutting depth of 5 cm below the surface increased cane yield by 35 and 25% compared to depths of 0 and 10 cm below the surface, respectively. Overall, these findings suggest that a cutting depth of 5 cm is optimal in terms of sugarcane yield, largely due to the enhanced effect on root traits, especially the development of fine roots. These findings will help optimize sugarcane ratoon management and improve the ratoon cycle.
Paper
Growth kinetics of cubic carbide free layers in graded cemented carbides
In order to reveal the formation mechanism of cubic carbide free layers （CCFL）, graded cemented carbides with CCFL in the surface zone were fabricated by a one-step sintering procedure in vacuum, and the analysis on microstructure and element distribution were performed by scanning electron microscopy （SEM） and electron probe micro-analyzer （EPMA）, respectively. A new physical model and ki- netic equation were established based on experimental results. Being different f~om previous models, this model suggests that nitrogen diffu- sion outward is only considered as an induction factor, and the diffusion of titanium through liquid phase plays a dominative role. The driving force of diffusion is expressed as the differential value between nitrogen partial pressure and nitrogen equilibrium pressure essentially. Simulation results by the kinetic equation are in good agreement with experimental values, and the effect of process parameters on the growth kinetics of CCFL can also be explained reasonably by the current model.
Journal Article