Explore the vast range of titles available.

Sensitive real-time detection of vapors produced by the precursors, reagents and solvents used in the illegal drugs manufacture represents a priority nowadays. Acetic anhydride (AA) is the key chemical used as acetylation agent in producing the illegal drugs heroin and methaqualone. This study was directed towards quick detection and quantification of AA in air, using two fast and very sensitive analytical techniques: photoionization detection (PID) and ion mobility spectrometry (IMS). Results obtained indicated that both PID and IMS can sense AA at ultra-trace levels in air, but while PID produces a non-selective response, IMS offers richer information. Ion mobility spectrometric response in the positive ion mode presented one product ion, at reduced ion mobility K0 of 1.89 cm2 V−1 s−1 (almost overlapped with positive reactant ion peak), while in the negative ion mode two well separated product ions, with K0 of 1.90 and 1.71 cm2 V−1 s−1, were noticed. Our study showed that by using a portable, commercial IMS system (model Mini IMS, I.U.T. GmbH Berlin) AA can be easily measured at concentrations of 0.05 ppmv (0.2 mg m−3) in negative ion mode. Best selectivity and sensitivity of the IMS response were therefore achieved in the negative operation mode.

Natural flavonoids and xanthone glycosides display several biological activities, with the glycoside moiety playing an important role in the mechanism of action of these metabolites. Herein, to give further insights into the inhibitory activity on cell growth of these classes of compounds, the synthesis of four flavonoids (5, 6, 9, and 10) and one xanthone (7) containing one or more acetoglycoside moieties was carried out. Acetyl groups were introduced using acetic anhydride and microwave irradiation. The introduction of one or two acetoglycoside moieties in the framework of 3,7-dihydroxyflavone (4) was performed using two synthetic methods: the Michael reaction and the Koenigs-Knorr reaction. The in vitro cell growth inhibitory activity of compounds 5, 6, 7, 9, and 10 was investigated in six human tumor cell lines: A375-C5 (malignant melanoma IL-1 insensitive), MCF-7 (breast adenocarcinoma), NCI-H460 (non-small cell lung cancer), U251 (glioblastoma astrocytoma), U373 (glioblastoma astrocytoma), and U87MG (glioblastoma astrocytoma). The new flavonoid 3-hydroxy-7-(2,3,4,6-tetra-O-acetyl-β-glucopyranosyl) flavone (10) was the most potent compound in all tumor cell lines tested, with GI50 values < 8 μM and a notable degree of selectivity for cancer cells.

The ability of commercial immobilized lipase from Thermomyces lanuginosus (Lipozyme TL IM) to catalyze the acetylation of essential clove oil with acetic anhydride in a solvent-free system was studied, and the antimicrobial activity of the ester formed was evaluated as well. Experimental design based on two variables (eugenol to acetic anhydride molar ratio and temperature) was employed to evaluate the experimental conditions of eugenyl acetate ester production. The maximum conversion yield (92.86 %) was obtained using Lipozyme TL IM (5 wt%, based on the total amount of substrates), with eugenol to acetic anhydride molar ratio of 1:5 at 70 °C. The chemical structure of the eugenyl acetate ester obtained at the optimized condition, and purified, was confirmed by the proton nuclear magnetic resonance (¹H-NMR) analysis. The antimicrobial activity of eugenyl acetate ester was proven effective on Gram-positive and Gram-negative bacteria, with means of 16.62 and 17.55 mm of inhibition halo.

In this manuscript, the remarkable NMR signal enhancement that can be provided by dynamic nuclear polarization (DNP) was combined with the reactivity of acetic anhydride with amines to perform rapid, high SNR analyses of amino acid mixtures and to hyperpolarize new biomolecules of interest. [1,1-¹³C] acetic anhydride is an excellent substrate for DNP hyperpolarization because it can be well polarized in only 30 min and has a relatively long T₁ relaxation time (33.9 s at 11.7 T and 37 °C). The secondary hyperpolarization approach developed in this project takes advantage of the preferential reaction of acetic anhydride with amine nucleophiles, which occurs much more rapidly than hydrolysis to produce hyperpolarized N-acetyl adducts. This new approach was used to reproducibly and near-quantitatively (mean yield - 89.8%) resolve a mixture of amino acids Gly, Ser, Val, Leu, and Ala in a single acquisition (3 s) with a signal enhancement of up to 1,400-fold as compared with thermal equilibrium. Secondary hyperpolarization was performed for several small peptides and N-acetylcysteine, a drug administered intravenously to treat acetaminophen overdose. Although, in general the T₁ of the N-acetyl adducts decreased with increasing molecular weight of the biomolecules, the T₁ values were still on the order of 10 s, and the correlation of T₁ with molecular weight was not exact suggesting the potential of secondarily polarizing relatively large biomolecules. This study demonstrates the feasibility of using prepolarized [1,1-¹³C] acetic anhydride and rapid chemical reactions to provide high SNR NMR spectra of amino acid derivatives and other biomolecules.

The acceptor-donor-acceptor (A–D–A) or A–DA’D–A structured small molecule acceptors (SMAs) have triggered substantial progress for polymer solar cells (PSCs). However, the high−cost of the SMAs impedes the commercial viability of such renewable energy, as their synthesis via the classical pyridine-catalyzed Knoevenagel condensation usually suffers from low reaction efficiency and tedious purifying work-up. Herein, we developed a simple and cheap boron trifluoride etherate-catalyzed Knoevenagel condensation for addressing this challenge, and found that the coupling of the aldehyde-terminated D unit and the A-end groups could be quantitatively finished in the presence of acetic anhydride within 15 minutes at room temperature. Compared with the conventional method, the high reaction efficiency of our method is related to the germinal diacetate pathway that is thermodynamically favorable to give the final products. For those high performing SMAs (such as ITIC-4F and Y6), the cost could be reduced by 50% compared with conventional preparation. In addition to the application in PSCs, our synthetic approach provides a facile and low-cost access to a wide range of D–A organic semiconductors for emerging technologies. The high−cost of the acceptor-donor-acceptor structured small molecule acceptors impedes its commercial viability for polymer solar cells. To address this problem, here, the authors developed a simple and cheap boron trifluoride etherate-catalyzed Knoevenagel condensation with high reaction efficiency.

Enzymatic esterification of eugenol is a matter of great scientific and technological interest due to the well-known drawbacks of the chemical-catalyzed route as well as the potential use of produced compounds as natural antimicrobials. This work reports the maximization of eugenil acetate production by esterification of eugenol and acetic anhydride in a solvent-free system using Novozym 435 as catalyst. The antimicrobial activity of eugenol and eugenil acetate was also determined. The operating conditions that maximized eugenil acetate production were 50 °C, eugenol to acetic anhydride of 1:3, 150 rpm, and 5.5 wt% of enzyme, with a conversion of 99 %. A kinetic study was performed to assess the influence of substrates molar ratio, enzyme concentration, and temperature on eugenil acetate yield. Results show that an excess of anhydride, low enzyme concentration (1 wt%), and 60 °C afforded nearly complete conversion after 6 h of reaction. The highest antimicrobial activity of eugenil acetate was observed against Acinetobacter sp. (48.66 mm) at concentration of 20 μL. Results indicate that the esterification of eugenol improved its antimicrobial properties. New experimental data on enzymatic esterification of eugenol and acetic anhydride are reported in this work, showing a promising perspective to overcome the inconvenient of the chemical-catalyzed route for obtaining antimicrobial natural compounds.

α-Amylase catalyzes hydrolysis of starch to oligosaccharides, which are further degraded to simple sugars. The enzyme has been widely used in food and textile industries and recently, in generation of renewable energy. An α-amylase from yeast Saccharomycopsis fibuligera R64 (Sfamy) is active at 50 °C and capable of degrading raw starch, making it attractive for the aforementioned applications. To improve its characteristics as well as to provide information for structural study ab initio, the enzyme was chemically modified by acid anhydrides (nonpolar groups), glyoxylic acid (GA) (polar group), dimethyl adipimidate (DMA) (cross-linking), and polyethylene glycol (PEG) (hydrophilization). Introduction of nonpolar groups increased enzyme stability up to 18 times, while modification by a cross-linking agent resulted in protection of the calcium ion, which is essential for enzyme activity and integrity. The hydrophilization with PEG resulted in protection against tryptic digestion. The chemical modification of Sfamy by various modifiers has thereby resulted in improvement of its characteristics and provided systematic information beneficial for structural study of the enzyme. An in silico structural study of the enzyme improved the interpretation of the results.

Enaminonitrile pyridine derivative was used as a precursor for preparation of fourteen heterocyclic compounds using both conventional thermal and microwave techniques. Diverse organic reagents, such as chloroacetyl chloride, acetic anhydride, chloroacetic acid, carbon disulfide, p -toluene sulfonyl chloride, maleic anhydride, phthalic anhydride, were used. The chemical formulae and structures of isolated derivatives were obtained using different analytical and spectroscopic techniques such as IR, 1 H-, 13 C-NMR as well as mass spectrometry. The spectroscopic analyses revealed diverse structure arrangements for the products. Molecular structure optimization of certain compounds were performed by the density functional theory (DFT/B3LYP) method and the basis set 6–31 G with double zeta plus polarization (d,p). The antimicrobial inhibition and the antioxidant activity of the reported compounds were screened. Compounds 5 , 6 , 11 and 13 exhibited the highest antibacterial inhibition, while compound 8 gave the highest scavenging activity (IC 50  43.39 µg/ml) against the DPPH radical. Structure–activity relationship of the reported compounds were correlated with the data of antibacterial and the antioxidant activity. The global reactivity descriptors were also correlated with the biological properties of compounds. The molecular docking studies of reported compounds were investigated, and the analysis showed that the docked compounds have highly negative values for the functional binding scores. The binding interaction was found to be correlated with the substituent fragments of the compounds.

The effect of the chemical treatment of paper mill sludge fibers and polypropylene molecular weight were studied relative to the physical, mechanical, and morphological properties of a novel cellulosic biocomposite. Paper mill sludge fibers were treated with acetic anhydride, and succinic anhydride was mixed with maleic anhydride polypropylene (MAPP) and coupling agent (0 and 3%). The ratio of fibers and polymer materials was considered 30 to 70, which was manufactured by the hot-pressing method at 180 °C. Water absorption, volume swelling, and contact angle were examined on each specimen according to ASTM standards, while Fourier transform infrared spectroscopy (FTIR) and scanning electron microscopy (SEM) explored the efficiency of chemical modification of fibers and the morphology of biocomposites, respectively. The results showed that chemical treatment of fibers reduced the water absorption and volumetric swelling. Both tensile and flexural strength were increased with chemical treatment using the coupling agent. Comparison of fibers treated with succinic acid and acetic acid showed that the succinic acid enhanced the mechanical properties better than the acetic acid treatment. Finally, FTIR analysis showed that the hydroxyl groups decreased, and SEM images indicated the interface between fibers and polypropylene improved via chemical treatment of sludge fibers.

Chitin was extracted from Polybius henslowii, a swimming crab, captured in large quantities throughout the Portuguese coast by purse seine vessels as bycatch. After standard chitin extraction procedures, water-soluble chitosan products were obtained via two different methods: (1) N-acetylation with the addition of acetic anhydride and (2) a reaction with hydrogen peroxide. The chemical structure and molecular weight of chitosan derivatives, water-soluble chitosan (WSC) and chitooligosaccharides (COS), were confirmed by Fourier Transform Infrared Spectroscopy (FT-IR) and gel permeation chromatography (GPC). Antioxidant and metal chelation activities were evaluated, and the growth inhibition capacity was tested on four phytopatogens. The chitooligosaccharides from pereopods (pCOS) and shell body parts (sCOS) inhibited all fungal species tested, particularly Cryphonectria parasitica with 84.7% and 85.5%, respectively. Both radical scavenging and antifungal activities proved to be dose-dependent. Chitooligosaccharides with a low molecular weight (2.7, 7.4, and 10.4 Kg·mol−1) showed the highest activity among all properties tested. These results suggested that chitosan derivatives from P. henslowii raw material could potentially be used against phytopathogens or as ingredient in cosmetics and other products related to oxidative stress.