Explore the vast range of titles available.

A significant effort has been dedicated to the synthesis of Cu–Zn oxide nanoparticles as a robust photocathode material for photoelectrochemical water splitting. Cu–Zn oxide nanoparticles were formed by controlled anodization of German silver (Cu–Zn–Ni) alloy in an aqueous electrolyte. Scanning electron microscopy (SEM) demonstrates the dependence of the obtained nanostructures on the anodization time. The X-ray diffraction (XRD) patterns showed the formation of copper oxide (CuO) and zinc oxide (ZnO) nanoparticles with good stability. This was also confirmed by the compositional X-ray photoelectron spectroscopy (XPS) analysis. The obtained polyhedral nanoparticles showed high optical activity with adequate bandgap energy. These optimized nanoparticles achieved boosted photocurrent of − 0.55 mA/cm 2 at − 0.6 V vs. SCE under AM 1.5 illumination, confirming the role of the optimized dealloying and thermal treatment in tuning the photoelectrochemical performance of the material.

PurposeTo determine the short-term safety of human recombinant decorin protein in preventing proliferative vitreoretinopathy (PVR) in perforating injuries.MethodsThis is a prospective, single-center, open-label, interventional case series. Single intravitreal injection of decorin 200 μg (n = 4) or 400 μg (n = 8) was given 48 h after injury. At the tenth day, pars plana vitrectomy was done whenever indicated. Flash electroretinogram (ERG) was done before and 3 months post-injection. We assessed ocular inflammation, ERG changes, and retinal layer integrity by optical coherence tomography (OCT). Systemic and vitreous pharmacokinetics were also evaluated.ResultsTwelve patients (12 eyes) with perforating globe injuries (zone III) were included and followed for a median of 6 months. Intravitreal decorin injection was well tolerated with no ocular or systemic safety adverse events. Decorin retinal safety was demonstrated anatomically by intact retinal layer by OCT, and functionally by flash ERG which did not show any significant worsening during the study and the final mean logMAR best-corrected visual acuity (BCVA) which was 1.15 (20/280) and 0.7 (20/100) for groups A and B, respectively, and ≥ 20/200 in 75% of all eyes. Decorin serum and vitreous levels were elevated following trauma, with higher and extended levels following intravitreal injection.ConclusionsNo short-term safety concerns were detected after a single intravitreal injection of decorin in patients with perforating injuries.Trial registrationClinicalTrials.gov ID: NCT02865031

Aim To investigate the OCT macular changes in type 1 ROP one month following Ranibizumab injections. Methods Preterm infants with type 1 ROP indicated for Ranibizumab injections were included in this study. Handheld OCT imaging was performed at baseline, 1 week, and 1 month post injection. Central full thickness (CFT), inner retinal layer (IRL), and outer retinal layer (ORL) thickness measurements were taken from foveal center and parafoveal region. Results 24 eyes of 12 infants were included in this study. There were no significant changes in the mean CFT and IRL thickness at 1 month (p = 0.5 and 0.1 respectively). However, there was significant increase in the mean ORL thickness at 1 month (69.9 ± 16, 96.1 ± 25 at baseline and one month respectively, p < 0.001), with differentiation (appearance of IS/OS junction ± ELM) in 55.6% of eyes. Macular edema (ME) was observed in 12 eyes (50%) and was associated with smaller birth weight (p = 0.0290). There was no significant decrease in mean CFT in eyes with ME at 1 month (p = 0.13), with complete resolution in only 6 eyes (50%) during the study period. Regression of plus was associated with lower CFT (1 week and 1 month; p = 0.02 and 0.03, respectively). Conclusion Ranibizumab treated eyes in type 1 show ORL thickening and differentiation but with inadequate resolution of ME.

Background PACK-CXL (photo-activated chromophore for keratitis–corneal cross-linking) is an alternative option in treatment of corneal infections. It inhibits corneal melting by increasing the stromal resistance, besides the microbicidal effect of photo-activated riboflavin. Methods Corneal infection with Pseudomonas aeruginosa and Staph aureus bacteria was induced in 20 eyes of 10 rabbits after 6 weeks of corneal cross-linking in half of the eyes, while the other acted as control group. Clinical and corneal histopathological examination was done to evaluate the extent of inflammation, ulceration, organism penetration, and depth of corneal stromal affection. Results The control eyes developed severe inflammation compared to the cross-linked eyes. Corneal melting occurred in 6 eyes in the control versus none in cross-linked group. Histopathological examination showed that the inflammation was confined to the superficial part of the stroma with localization of the inflammation in the cross-linked eyes in contrast to the control eyes that showed deep infiltration. Conclusion PACK-CXL provides infection localization through increasing the corneal rigidity and resistance to enzymatic digestion, even in the absence of the riboflavin microbicidal role. So, early PACK-CXL is worth to be considered in the IK treatment algorithm.

PurposeTo investigate the long-term effect of scleral buckling on corneal biomechanics and the effect of change of scleral properties on intraocular pressure (IOP) measurements.MethodsThis is a prospective case series, patients with rhegmatogenous retinal detachment prepared for scleral buckling were included. Goldmann applanation tonometry was used to measure IOP (GAT IOP). Ocular Response Analyzer (ORA) was used to measure corneal hysteresis (CH), corneal resistance factor (CRF), goldmann-corrected IOP (IOPg), and corneal-compensated IOP (IOPcc) preoperatively, and 1, 3, and 6 months postoperatively. ResultsThirty-three eyes included in the final analysis, with an average age 38.4 ± 16.2 years. CH and CRF decreased significantly at first, third, sixth months post-scleral buckling; however, this effect decreased with time as follows; preoperative: 8.9 ± 1.5 and 8.5 ± 2.1, first month: 6.8 ± 1.6 and 7.1 ± 1.8 (P value = 0.00, 0.002), third month: 7.8 ± 1.5 and 7.6 ± 1.6 (P value = 0.001, 0.008), and sixth month: 7.7 ± 1.3 and 7.6 ± 1.7 (P value = 0.002, 0.055). IOP cc was 19.3 ± 3.6, 17.1 ± 4, and 17.6 ± 2.9 at 1, 3, and 6 months, and these readings were significantly higher than GAT (13.6 ± 7.6, 12.4 ± 5.1, and 12.1 ± 2.9, P values = 0.00) and IOPg (14.9 ± 3.6, 13.5 ± 4.1, and 13.9 ± 3.5, P values = 0.00). The change in CH at each visit is correlated with the difference between the IOPcc and GAT measurements.ConclusionThe conventional Goldmann applanation tonometry underestimates post buckle IOP measurements due corneal biomechanics changes. ORA might be an alternative and accurate method of measurement; however, further investigation is warranted.

Purpose:To evaluate anatomic and functional outcomes of patients treated with pars plana vitrectomy (PPV) with scleral buckling versus PPV with inferior retinectomy for treatment of cases of primary rhegmatogenous retinal detachment (RRD) associated with proliferative vitreoretinopathy (PVR) and inferior retinal breaks.Methods:Retrospective, comparative, interventional, single-center study. Fifty-one eyes of fifty-one patients with primary RRD associated with inferior breaks and PVR grade C1 or more were reviewed over 3 years. Twenty-one eyes underwent PPV with encircling band 360° and thirty eyes underwent PPV with primary inferior retinectomy. The primary outcome was final anatomic success. Secondary outcomes included change in visual acuity, primary anatomical success, the mean number of operations, and incidence of postoperative complications.Results:Primary anatomical success of 85.7% was achieved in buckle group compared to 83.3% in retinectomy group (p = 0.82). Mean duration of follow-up and mean number of operations was 9.8 ± 2.26 and 9.97 ± 2.44 months; 1.24 ± 0.62 and 1.3 ± 0.75 in buckle group and retinectomy group, respectively, achieving final anatomical success of 95.2% for the buckle group and 90% for the retinectomy group with no statistical significant difference (p = 0.49). Although visual acuity (logMAR) was better in the buckle group in the 1st month, it became nearly equal thereafter during the follow-up period (p = 0.5).Conclusion:Similar anatomical and functional outcomes were achieved by combining PPV with scleral buckle or inferior retinectomy for treatment of primary RRD with PVR and inferior breaks.

The use of synthetic strong acid catalysts or lewis acid catalysts from metals often causes environmental problems at the end of a chemical reaction. In this research offers an alternative solution using kelubi fruit extract (Eleiodoxa conferta) as a green catalyst, especially in the synthesis of 3,4-dihydropyrimidin-2 (1H)-ones derivatives which are reported to be active as therapeutic and bioorganic chemistry. So the purpose of this research was to develop a green catalyst from natural fruit for the synthesis of 3,4-dihydropyrimidin-2 (1H)-ones using kelubi fruit. The Green catalysts are obtained from water extracts of kelubi fruit that are ripe. Then the catalyst is added to the reagent for the synthesis of pyrimidine derivatives that consist of urea, benzaldehyde, and ethyl acetoacetate (equivalent). As a comparison, HCl is used as an acid catalyst. The result is the highest yield (67,7%) at the use of 0,2 ml green catalyst and reaction time 180 minutes. Spectrum UV-Vis of characteristics compound has a maximum wavelength of 306 nm.

Employing electromagnetic fields (EMFs) in new wireless communication and sensing technologies has substantially increased the level of human exposure to EMF waves. This paper presents a useful insight into the interaction of electromagnetic fields with biological media that is defined by the heat generation due to induced currents and dielectric loss. The specific absorption rate (SAR) defines the heating amount in a biological medium that is irradiated by an electromagnetic field value. The paper reviews the radio frequency hazards due to the SAR based on various safety standards and organisations, including a detailed investigation of previously published work in terms of modelling and measurements. It also summarises the most common techniques utilised between 1978 and 2021, in terms of the operational frequency spectrum, bandwidth, and SAR values.

The global importance of food safety is not fully appreciated by many public health authorities despite a constant increase in the prevalence of foodborne illness. Numerous devastating outbreaks of salmonellosis, cholera, enterohaemorrhagic Escherichia coli infections, hepatitis A and other diseases have occurred in both industrialized and developing countries. In addition, many of the re-emerging or newly recognized pathogens are foodborne or have the potential of being transmitted by food and/or drinking water. More foodborne pathogens can be expected because of changing production methods, processes, practices and habits. During the early 21st century, foodborne diseases can be expected to increase, especially in developing countries, in part because of environmental and demographic changes. These vary from climatic changes, changes in microbial and other ecological systems, to decreasing freshwater supplies. However, an even greater challenge to food safety will come from changes resulting directly in degradation of sanitation and the immediate human environment. These include the increased age of human populations, unplanned urbanization and migration and mass production of food due to population growth and changed food habits. Mass tourism and the huge international trade in food and feed is causing food and feedborne pathogens to spread transnationally. As new toxic agents are identified and new toxic effects recognized, the health and trade consequences of toxic chemicals in food will also have global implications. Meeting the huge challenge of food safety in the 21st century will require the application of new methods to identify, monitor and assess foodborne hazards. Both traditional and new technologies for assuring food safety should be improved and fully exploited. This needs to be done through legislative measures where suitable, but with much greater reliance on voluntary compliance and education of consumers and professional food handlers. This will be an important task for the primary health care system aiming at \"health for all\".