Explore the vast range of titles available.

Recent green manufacturing demands have boosted the development of new biodegradable lubricants to replace petroleum-based lubricants. In this regard, water-based lubricants have been at the vanguard of recent research for a wide range of industrial applications, including metalworking fluids (MWFs). In this work, we present an experimental investigation on the performance of novel green MWFs based on aqueous nopal mucilage solutions. For this, fully biodegradable solutions with different mucilage concentrations (2.29, 4.58, and 6.85 mg/mL) were evaluated in terms of rheological, tribological, thermal stability, and turning (minimum quantity lubrication) performance and compared to a commercial semisynthetic oil-based MWF (Cimstar 60). Mucilage solutions exhibited viscoelastic shear-thinning behavior, which was enhanced along with mucilage concentration. The solution with the highest mucilage content studied resulted in the lowest wear, friction, and temperature in comparison to the other solutions and neat water in extreme pressure four-ball tests and a similar level of lubricity as compared to the commercial MWF in cutting tests. This performance is associated with the enhanced viscosity and elasticity of the solution, as well as the contents of lipids with fatty acids in the mucilage. Overall, the present results reveal the relevance of the viscoelastic behavior of the lubricant, elasticity in particular, in lubrication processes and point to nopal mucilage as an effective green additive to produce innocuous MWFs.

This work explores experimentally the effects of DC electrical currents on lubricant film thickness alteration in lubricated sliding steel contacts in the boundary and mixed regime as measured by ultrasound. The experiments were performed in a two-electrode cell-based pin-on-disk tester instrumented with ultrasonic transducers. Unelectrified and electrified tribological tests were conducted on steel flat-on-flat contacts under various speeds and loads using both a mineral base oil and a gear oil. Film thickness, coefficient of friction (CoF), and electrical contact resistance (ECR) were measured during short experiments (30 s) in unelectrified and electrified (1.5 and 3 A) conditions. The results suggest that film thickness, CoF, and all ECR are altered by passing DC currents through the contact. In particular, film thickness increased and decreased, respectively, by applying electricity at the different speeds and loads tested. These alterations were majorly ascribed to oil viscosity decrease by local heat and surface oxidation caused by electrical discharge and break down at the interface.

Up to date, most metalworking fluids (MWFs) are emulsions made of petroleum-derived oil bases and sodium petroleum sulphonate emulsifiers. They are not readily biodegradable, and their waste is hazardous for users and the environment. Therefore, green MWFs are required for achieving cleaner production processes. Recently, various MWFs have been developed using vegetable oil bases to meet biodegradability to some extent. However, the emulsifier has been scarcely replaced by a green product. This research aims to produce and evaluate Pickering emulsions made of Jatropha oil (JO) and partially deacetylated and fibrillated chitin (PDFC) as emulsifiers at different concentrations. JO is a non-edible biodegradable oil with remarkable lubricity properties, while PDFC is produced by extracting chitin from waste heads and shells of the shrimp species Litopenaeus vannameii, followed by partial deacetylation and further fibrillation, which improves wettability and stabilization. The prepared emulsions were characterized in terms of creaming index and size of emulsion droplets and evaluated as MWFs in actual turning operations of AISI 1018 steel bars via minimum quantity lubrication (MQL) technique. The findings suggest PDFC as a potential eco-friendly emulsifier to form green MWFs with acceptable stability generating low cutting forces and significant workpiece finishing and chips quality.