Explore the vast range of titles available.

Power systems worldwide are experiencing rapid evolvements with a massive increase of renewable generation in order to meet the ambitious decarbonization targets. A significant amount of renewable generation is from Distributed Energy Resources (DERs), upon which the system operators often have limited visibility. This can bring significant challenges as the increasing DERs’ can lead to network constraints being violated, presenting critical risks for network security. Enhancing the visibility of DERs can be achieved via the provision of communication links, but this can be costly, particularly for real time applications. Digital Twin (DT) is an emerging technology that is considered as a promising solution for enhancing the visibility of a physical system, where only a limited set of data is required to be transmitted with the rest data of interest can be estimated via the DT. The development and demonstration of DTs requires realistic testing and validation enviorment in order to accelerate its adoption in the industry. This paper presents a real time simulation and hardware-in-the-loop (HiL) testing platform, specifically designed for prototyping, demonstrating and testing DTs of DERs. Within the proposed platform, a software-based communication emulator is developed, which allows the investigation of the impact of communication latency and jitter on the performance of DTs of the DERs. Case studies are presented to demonstrate the application of the developed DT prototyping process and testing platform to enable frequency control using the DTs, which provide valuable learnings and tools for enabling future DTs-based solutions.

Superconducting Radio-Frequency cavities are currently made out of niobium. Niobium cavities are limited by the magnetic field on the cavity walls due to the entry of vortices at the field of first vortex penetration, H vp . Low temperature baking in vacuum or low pressure gas atmosphere removes the strong decrease of the quality factor with accelerating gradient (high field Q-slope). Some cavities reach surface magnetic field above the lower critical field H c 1 . One hypothesis for this performance increase is that the outer layer affected by the treatments acts as a barrier for vortex penetration (effective bilayer). Using a vibrating sample magnetometer the field of first flux penetration (H vp ) was measured for Nb ellipsoids with various low temperature treatments. All H vp values were found to be consistent with the lower critical field, H c 1 , as predicted for clean niobium. This led to the conclusion that a metastable flux free state above H c 1 cannot be observed in DC magnetometry for low temperature baked niobium unlike for bilayers consisting of two superconductors as previously published. The effect of flux pinning differed significantly between treatments, suggesting that the high field Q-slope mitigation might be related to vortex pinning in the surface of the cavities.

Most of the UK Continental Shelf (UKCS) oil and gas (OG) installations have traditionally adopted in situ power generation, which is not only inefficient but also generating about 70% of the offshore CO2 emissions. The offshore wind and energy storage technologies for deep water are developing at a fast pace, enabling great opportunities for the OG installations located in the North Sea. In this paper, a pathway for the UKCS offshore OG installations electrification is introduced. The aim is to provide different power architectures that facilitate the OG installations’ electrification, while benefiting from the existing and planned UK offshore wind power. Four hypothetical case studies (based on real data) were created, along the UKCS, where the corresponding power architectures were proposed. The selection of each architecture power component (e.g., transformers, converters and cables), as well as the transmission and distribution technology (e.g., AC or DC), is also provided and justified. Further, an overview cost estimation is carried out to predict the architecture capital cost. It is concluded that the four architectures can be mimicked not only along the UKCS but also worldwide, promoting the UKCS potential for a world-leading offshore energy hub and fostering the UK offshore wind-energy resources.

Distributed control and optimization strategies are a promising alternative approach to centralized control within microgrids. In this paper, a multi-agent system is developed to deal with the distributed secondary control of islanded microgrids. Two main challenges are identified in the coordination of a microgrid: (i) interoperability among equipment from different vendors; and (ii) online re-configuration of the network in the case of alteration of topology. To cope with these challenges, the agents are designed to communicate with physical devices via the industrial standard IEC 61850 and incorporate a plug and play feature. This allows interoperability within a microgrid at agent layer as well as allows for online re-configuration upon topology alteration. A test case of distributed frequency control of islanded microgrid with various scenarios was conducted to validate the operation of proposed approach under controller and power hardware-in-the-loop environment, comprising prototypical hardware agent systems and realistic communications network.

The integration of smart grid technologies in interconnected power system networks presents multiple challenges for the power industry and the scientific community. To address these challenges, researchers are creating new methods for the validation of: control, interoperability, reliability of Internet of Things systems, distributed energy resources, modern power equipment for applications covering power system stability, operation, control, and cybersecurity. Novel methods for laboratory testing of electrical power systems incorporate novel simulation techniques spanning real-time simulation, Power Hardware-in-the-Loop, Controller Hardware-in-the-Loop, Power System-in-the-Loop, and co-simulation technologies. These methods directly support the acceleration of electrical systems and power electronics component research by validating technological solutions in high-fidelity environments. In this paper, members of the Survey of Smart Grid International Research Facility Network task on Advanced Laboratory Testing Methods present a review of methods, test procedures, studies, and experiences employing advanced laboratory techniques for validation of range of research and development prototypes and novel power system solutions.

The rapid development and growth of battery storage have heightened an interest in the co-location of battery energy storage systems (BESS) with renewable energy projects which enables the stacking of multiple revenue streams while reducing connection charges of BESS. To help wind energy industries better understand the coordinated operation of BESS and wind farms and its associated profits, this paper develops a simulation model to implement a number of coordination strategies where the BESS supplies enhanced frequency response (EFR) service and enables the time shift of wind generation based on the UK perspective. The proposed model also simulates the degradation of Lithium-Ion battery and incorporates a state of charge (SOC) dependent limit on the charge rate derived from a constant current-constant voltage charging profile. In addition, a particle swarm optimisation-based battery sizing algorithm is developed here on the basis of the simulation model to determine the optimal size of the co-located BESS along with SOC-related strategy variables that maximise the net present value of the wind + BESS system at the end of the EFR contract.

The hardware under test (HUT) in a power hardware in the loop (PHIL) implementation can have a significant effect on overall system stability. In some cases, the system under investigation will be unstable unless the HUT is already connected and operating. Accordingly, initialization of the real-time simulation can be difficult, and may lead to abnormal parameters of frequency and voltage. Therefore, a method to initialize the simulation appropriately without the HUT is proposed in this contribution. Once the initialization is accomplished a synchronization process is also proposed. The synchronization process depends on the selected method for initialization and therefore both methods need to be compatible. In this contribution, a recommended practice for the initialization of PHIL simulations for synchronous power systems is presented. Experimental validation of the proposed method for a Great Britain network case study demonstrates the effectiveness of the approach.

The transition to an inverter-dominated power system is expected with the large-scale integration of distributed energy resources (DER). To improve the dynamic response of DERs already installed within such a system, a non-intrusive add-on controller referred to as SPAACE (set point automatic adjustment with correction enabled), has been proposed in the literature. Extensive simulation-based analysis and supporting mathematical foundations have helped establish its theoretical prevalence. This paper establishes the practical real-world relevance of SPAACE via a rigorous performance evaluation utilizing a high fidelity hardware-in-the-loop systems test bed. A comprehensive methodological approach to the evaluation with several practical measures has been undertaken and the performance of SPAACE subject to representative scenarios assessed. With the evaluation undertaken, the fundamental hypothesis of SPAACE for real-world applications has been proven, i.e., improvements in dynamic performance can be achieved without access to the internal controller. Furthermore, based on the quantitative analysis, observations, and recommendations are reported. These provide guidance for future potential users of the approach in their efforts to accelerate the transition to an inverter-dominated power system.

This Editorial provides an introduction to the Special Issue “Methods and Concepts for Designing and Validating Smart Grid Systems”. Furthermore, it also provides an overview of the corresponding papers that where recently published in MDPI’s Energies journal. The Special Issue took place in 2018 and accepted a total of 19 papers from 19 different countries.

A dynamic equivalent black-box model, based on Prony analysis is presented. The proposed model is suitable for dynamic studies of microgrids, considering changes in the active and reactive powers, bus voltages, currents and frequency. The developed model is evaluated using simulation results obtained from a medium-voltage microgrid and test measurements recorded in a low-voltage microgrid laboratory test facility. Results from the proposed model are in good agreement with the corresponding responses obtained from both simulations and laboratory tests. The examined microgrid configurations include rotating machines and inverter interfaced units implementing different control strategies, thus verifying the robustness of the proposed model.