Explore the vast range of titles available.

Lithium titanate oxide cells are gaining attention in electric vehicle applications due to their ability to support high-current charging and their enhanced thermal stability. However, despite these advantages, safety concerns, particularly thermal runaway, pose significant challenges during abuse conditions such as overcharging. In this study, we investigated the effectiveness of various dielectric fluids in mitigating thermal runaway during overcharge abuse tests of cylindrical LTO cells with a capacity of 10 Ah. The experimental campaign focused on overcharging fully charged cells (starting at 100% State of Charge) at a current of 40A (4C). The tests were conducted under two conditions: the first benchmark test involved a cell exposed to air, while the subsequent tests involved cells submerged in different dielectric fluids. These fluids included two perfluoropolyether fluorinated fluids (PFPEs) with boiling points of 170 °C and 270 °C, respectively, a synthetic ester, and a silicone oil. The results were analyzed to determine the fluids’ ability to delay possible thermal runaway and prevent catastrophic failures. The findings demonstrate that some dielectric fluids can delay thermal runaway, with one fluid showing superior performance with respect to the others in preventing fire during thermal runaway. The top-performing fluid was further evaluated in a simulated battery pack environment, confirming its ability to mitigate thermal runaway risks. These results provide important insights for improving the safety of battery systems in electric vehicles.

In this work, we present chemical stratigraphies of two sampling lines collected within a 4 m depth snow pit dug in Dome C during the Antarctic summer Campaign 2017/2018, 12 years after the last reported snow pit. The first sampling line was analyzed for nine anionic and cationic species using Ion Chromatography (IC); the second sampling line was analyzed for seven major elements in an innovative way with Inductively Coupled Plasma Optical Emission Spectroscopy (ICP-OES) after sample pre-concentration, allowing the study of deposition processes of new markers especially related to crustal source. This coupled analysis, besides confirming previous studies, allowed us to investigate the depositions of the last decades at Dome C, enriching the number of the detected chemical markers, and yielding these two techniques complementary for the study of different markers in this kind of matrix. As a result of the dating, the snow layers analyzed covered the last 50 years of snow depositions. The assessment of the accumulation rate, estimated about 9 cm yr−1, was accomplished only for the period 1992–2016, as the eruption of 1992 constituted the only tie-point found in nssSO42− depth profile. Na, the reliable sea salt marker, together with Mg and Sr, mainly arose from marine sources, whereas Ca, Al and Fe originated from crustal inputs. Post-depositional processes occurred on Cl− as well as on NO3− and methanesulfonic acid (MSA); compared to the latter, Cl− had a more gradual decrease, reporting a threshold at 2.5 m for the post-depositional process completion. For NO3− and MSA, instead, the threshold was shallower, at about 1 m depth, with a loss of 87% for NO3− and of 50% for MSA.

In remote marine areas, biogenic productivity and atmospheric particulate are coupled through dimethylsulfide (DMS) emission by phytoplankton. Once in the atmosphere, the gaseous DMS is oxidized to produce H2SO4 and methanesulfonic acid (MSA); both species can affect the formation of cloud condensation nuclei. This study analyses eight years of biogenic aerosol evolution and variability at two Arctic sites: Thule (76.5° N, 68.8° W) and Ny Ålesund (78.9° N, 11.9° E). Sea ice plays a key role in determining the MSA concentration in polar regions. At the beginning of the melting season, in April, up to June, the biogenic aerosol concentration appears inversely correlated with sea ice extent and area, and positively correlated with the extent of the ice-free area in the marginal ice zone (IF-MIZ). The upper ocean stratification induced by sea ice melting might have a role in these correlations, since the springtime formation of this surface layer regulates the accumulation of phytoplankton and nutrients, allowing the DMS to escape from the sea to the atmosphere. The multiyear analysis reveals a progressive decrease in MSA concentration in May at Thule and an increase in July August at Ny Ålesund. Therefore, while the MSA seasonal evolution is mainly related with the sea ice retreat in April, May, and June, the IF-MIZ extent appears as the main factor affecting the longer-term behavior of MSA.

Major explosive volcanic eruptions may significantly alter the global atmosphere for about 2–3 years. During that period, volcanic products (mainly H2SO4) with high residence time, stored in the stratosphere or, for shorter times, in the troposphere are gradually deposited onto polar ice caps. Antarctic snow may thus record acidic signals providing a history of past volcanic events. The high resolution sulphate concentration profile along a 197 m long ice core drilled at GV7 (Northern Victoria land) was obtained by Ion Chromatography on around 3500 discrete samples. The relatively high accumulation rate (241 ± 13 mm we yr −1) and the 5-cm sampling resolution allowed a preliminary counted age scale. The obtained stratigraphy covers roughly the last millennium and 24 major volcanic eruptions were identified, dated, and tentatively ascribed to a source volcano. The deposition flux of volcanic sulphate was calculated for each signature and the results were compared with data from other Antarctic ice cores at regional and continental scale. Our results show that the regional variability is of the same order of magnitude as the continental one.

While more and more studies are being conducted on carbonaceous fractions—organic carbon (OC) and elemental carbon (EC)—in urban areas, there are still too few studies about these species and their effects in polar areas due to their very low concentrations; further, studies in the literature report only data from intensive campaigns, limited in time. We present here for the first time EC–OC concentration long-time data records from the sea-level sampling site of Ny-Ålesund, in the High Arctic (5 years), and from Dome C, in the East Antarctic Plateau (1 year). Regarding the Arctic, the median (and the interquartile range (IQR)) mass concentrations for the years 2011–2015 are 352 (IQR: 283–475) ng/m3 for OC and 4.8 (IQR: 4.6–17.4) ng/m3 for EC, which is responsible for only 3% of total carbon (TC). From both the concentration data sets and the variation of the average monthly concentrations, the influence of the Arctic haze on EC and OC concentrations is evident. Summer may be interested by high concentration episodes mainly due to long-range transport (e.g., from wide wildfires in the Northern Hemisphere, as happened in 2015). The average ratio of EC/OC for the summer period is 0.05, ranging from 0.02 to 0.10, and indicates a clean environment with prevailing biogenic (or biomass burning) sources, as well as aged, highly oxidized aerosol from long-range transport. Contribution from ship emission is not evident, but this result may be due to the sampling time resolution. In Antarctica, a 1 year-around data set from December 2016 to February 2018 is shown, which does not present a clear seasonal trend. The OC median (and IQR) value is 78 (64–106) ng/m3; for EC, it is 0.9 (0.6–2.4) ng/m3, weighing for 3% on TC values. The EC/OC ratio mean value is 0.20, with a range of 0.06–0.35. Due to the low EC and OC concentrations in polar areas, correction for the blank is far more important than in campaigns carried out in other regions, largely affecting uncertainties in measured concentrations. Through the years, we have thus developed a new sampling strategy that is presented here for the first time: samplers were modified in order to collect a larger amount of particulates on a small surface, enhancing the capability of the analytical method since the thermo-optical analyzer is sensitive to carbonaceous aerosol areal density. Further, we have recently coupled such modified samplers with a sampling strategy that makes a more reliable blank correction of every single sample possible.

This paper presents the results of simultaneous high time-resolution measurements of biogenic aerosol (methane sulfonic acid (MSA), non-sea salt sulfate nssSO42-) with its gaseous precursor dimethylsulfide (DMS), performed at the Italian coastal base Mario Zucchelli Station (MZS) in Terra Nova Bay (MZS) during two summer campaigns (2018–2019 and 2019–2020). Data on atmospheric DMS concentration are scarce, especially in Antarctica. The DMS maximum at MZS occurs in December, one month earlier than at other Antarctic stations. The maximum of DMS concentration is connected with the phytoplanktonic senescent phase following the bloom of Phaeocystis antarctica that occurs in the polynya when sea ice opens up. The second plankton bloom occurs in January and, despite the high dimethylsufoniopropionate (DMSP) concentration in seawater, atmospheric DMS remains low, probably due to its fast biological turnover in seawater in this period. The intensity and timing of the DMS evolution during the two years suggest that only the portion of the polynya close to the sampling site produces a discernible effect on the measured DMS. The closeness to the DMS source area and the occurrence of air masses containing DMS and freshly formed oxidation products allow us to study the kinetic of biogenic aerosol formation and the reliable derivation of the branch ratio between MSA and nssSO42- from DMS oxidation that is estimated to be 0.84±0.06. Conversely, for aged air masses with low DMS content, an enrichment of nssSO42- with respect to MSA, is observed. We estimate that the mean contribution of freshly formed biogenic aerosol to PM10 is 17 % with a maximum of 56 %. The high contribution of biogenic aerosol to the total PM10 mass in summer in this area highlights the dominant role of the polynya on biogenic aerosol formation. Finally, due to the regional and year-to-year variability of DMS and related biogenic aerosol formation, we stress the need for long-term measurements of seawater and atmospheric DMS and biogenic aerosol along the Antarctic coast and in the Southern Ocean.

We present results from a systematic study of vertical profiles of aerosol number size distribution and black carbon (BC) concentrations conducted in the Arctic, over Ny-Ålesund (Svalbard). The campaign lasted 2 years (2011–2012) and resulted in 200 vertical profiles measured by means of a tethered balloon (up to 1200 m a.g.l.) during the spring and summer seasons. In addition, chemical analysis of filter samples, aerosol size distribution and a full set of meteorological parameters were determined at ground. The collected experimental data allowed a classification of the vertical profiles into different typologies, which allowed us to describe the seasonal phenomenology of vertical aerosol properties in the Arctic. During spring, four main types of profiles were found and their behavior was related to the main aerosol and atmospheric dynamics occurring at the measuring site. Background conditions generated homogenous profiles. Transport events caused an increase of aerosol concentration with altitude. High Arctic haze pollution trapped below thermal inversions promoted a decrease of aerosol concentration with altitude. Finally, ground-based plumes of locally formed secondary aerosol determined profiles with decreasing aerosol concentration located at different altitude as a function of size. During the summer season, the impact from shipping caused aerosol and BC pollution plumes to be constrained close to the ground, indicating that increasing shipping emissions in the Arctic could bring anthropogenic aerosol and BC in the Arctic summer, affecting the climate.

Ice core dating is the first step for a correct interpretation of climatic and environmental changes. In this work, we release the dating of the uppermost 197 m of the 250 m deep GV7(B) ice core (drill site, 70∘41′ S, 158∘52′ E; 1950 m a.s.l. in Oates Land, East Antarctica) with a sub-annual resolution. Chemical records of NO3-, MSA (methanesulfonic acid), non-sea-salt SO42- (nssSO42-), sea-salt ions and water stable isotopes (δ18O) were studied as candidates for dating due to their seasonal pattern. Different procedures were tested but the nssSO42- record proved to be the most reliable on the short- and long-term scales, so it was chosen for annual layer counting along the whole ice core. The dating was constrained by using volcanic signatures from historically known events as tie points, thus providing an accurate age–depth relationship for the period 1179–2009 CE. The achievement of the complete age scale allowed us to calculate the annual mean accumulation rate throughout the analyzed 197 m of the core, yielding an annually resolved history of the snow accumulation on site in the last millennium. A small yet consistent rise in accumulation rate (Tr = 1.6, p<0.001) was found for the last 830 years starting around mid-18th century.

Geothermal district heating development has been gaining momentum in Europe with numerous deep geothermal installations and projects currently under development. With the increasing density of geothermal wells, questions related to the optimal and sustainable reservoir exploitation become more and more important. A quantitative understanding of the complex thermo-hydraulic interaction between tightly deployed geothermal wells in heterogeneous temperature and permeability fields is key for a maximum sustainable use of geothermal resources. Motivated by the geological settings of the Upper Jurassic aquifer in the Greater Munich region, we develop a computational model based on finite element analysis and gradient-free optimization to simulate groundwater flow and heat transport in hot sedimentary aquifers, and numerically investigate the optimal positioning and spacing of multi-well systems. Based on our numerical simulations, net energy production from deep geothermal reservoirs in sedimentary basins by smart geothermal multi-well arrangements provides significant amounts of energy to meet heat demand in highly urbanized regions. Our results show that taking into account heterogeneous permeability structures and a variable reservoir temperature may drastically affect the results in the optimal configuration. We demonstrate that the proposed numerical framework is able to efficiently handle generic geometrical and geological configurations, and can be thus flexibly used in the context of multi-variable optimization problems. Hence, this numerical framework can be used to assess the extractable geothermal energy from heterogeneous deep geothermal reservoirs by the optimized deployment of smart multi-well systems.

Monolithic all-perovskite triple-junction solar cells have the potential to deliver power conversion efficiencies beyond those of state-of-art double-junction tandems and well beyond the detailed-balance limit for single junctions. Today, however, their performance is limited by large deficits in open-circuit voltage and unfulfilled potential in both short-circuit current density and fill factor in the wide-bandgap perovskite sub cell. Here we find that halide heterogeneity—present even immediately following materials synthesis—plays a key role in interfacial non-radiative recombination and collection efficiency losses under prolonged illumination for Br-rich perovskites. We find that a diammonium halide salt, propane-1,3-diammonium iodide, introduced during film fabrication, improves halide homogenization in Br-rich perovskites, leading to enhanced operating stability and a record open-circuit voltage of 1.44 V in an inverted (p–i–n) device; ~86% of the detailed-balance limit for a bandgap of 1.97 eV. The efficient wide-bandgap sub cell enables the fabrication of monolithic all-perovskite triple-junction solar cells with an open-circuit voltage of 3.33 V and a champion PCE of 25.1% (23.87% certified quasi-steady-state efficiency). Wide-bandgap perovskite solar cells are limited by losses in open-circuit voltage. Wang et al. show that diammonium halide salts promote a homogeneous distribution of halides in the perovskite, improving the performance of single- and triple-junction solar cells.