Explore the vast range of titles available.

TiO2-reduced graphene oxide composite-modified glassy carbon electrodes (TiO2–ErGO–GCE) for the sensitive detection of tartrazine were prepared by drop casting followed by electrochemical reduction. The as-prepared material was characterized by transmission electron microscopy (TEM) and X-ray diffraction (XRD). Cyclic voltammetry and second-order derivative linear scan voltammetry were performed to analyze the electrochemical sensing of tartrazine on different electrodes. The determination conditions (including pH, accumulation potential, and accumulation time) were optimized systematically. The results showed that the TiO2–ErGO composites increased the electrochemical active area of the electrode and enhanced the electrochemical responses to tartrazine significantly. Under the optimum detection conditions, the peak current was found to be linear for tartrazine concentrations in the range of 2.0 × 10−8–2.0 × 10−5 mol/L, with a lower detection limit of 8.0 × 10−9 mol/L (S/N = 3). Finally, the proposed TiO2–ErGO–GCEs were successfully applied for the detection of trace tartrazine in carbonated beverage samples.

In this paper, a nanocomposite of cuprous oxide and electrochemically reduced graphene oxide (Cu2O–ERGO) was prepared by a simple and low-cost method; hereby, a new method for the electrochemical determination of tryptophan (Trp) by this composite modified glassy carbon electrode (GCE) is proposed. The prepared materials and modified electrodes were characterized by scanning electron microscopy (SEM), X-ray diffraction (XRD), and cyclic voltammetry (CV). The results showed that Cu2O–ERGO/GCE had good electrocatalytic activity for Trp. The effects of supporting electrolyte, scanning rate, accumulation potential, and accumulation time on the determination of Trp were studied. Under the optimum experimental conditions, Trp was quantitatively analyzed by square-wave voltammetry (SWV). The oxidation peak current of Trp had a good linear relationship with its concentration in the range of 0.02–20 μM, and the detection limit was 0.01 μM (S/N = 3). In addition, the modified electrode has high sensitivity, good repeatability, and long-term stability. Finally, the proposed method has been successfully applied in the determination of Trp concentration in practical samples.

4-nitrophenol (4-NP) is a hazardous waste and a priority toxic pollutant identified by US Environmental Protection Agency (EPA). Hence, in this paper, a voltammetric sensor was proposed for the direct and sensitive detection of 4-nitrophenol (4-NP) at nanomolar level in complex matrices by using graphene and acetylene black paste hybridized electrode (GR/ABPE). Under optimal conditions, the calibration curve demonstrates a linear relationship for 4-NP in the range from 20 nM to 8.0 μM and 8.0 μM to 0.1 mM separately with the detection limit of 8.0 nM. In addition to it, the performance of the GR/ABPE in practical applications was evaluated by detecting 4-NP in various water samples, and satisfactory recoveries were realized. Therefore, GR/ABPE may have a great potential application for facile and sensitive detection of 4-NP in complex matrices at nanomolar level.

Due to their unique properties, such as good biocompatibility, excellent conductivity, effective catalysis, high density, and high surface-to-volume ratio, gold nanoparticles (AuNPs) are widely used in the field of bioassay. Mainly, AuNPs used in optical biosensors have been described in some reviews. In this review, we highlight recent advances in AuNP-based non-optical bioassays, including piezoelectric biosensor, electrochemical biosensor, and inductively coupled plasma mass spectrometry (ICP-MS) bio-detection. Some representative examples are presented to illustrate the effect of AuNPs in non-optical bioassay and the mechanisms of AuNPs in improving detection performances are described. Finally, the review summarizes the future prospects of AuNPs in non-optical biosensors.

Amine-modified magnetite (NH2–Fe3O4)/reduced graphene oxide nanocomposite modified glassy carbon electrodes (NH2–Fe3O4/RGO/GCEs) were developed for the sensitive detection of dopamine (DA). The NH2-Fe3O4/RGO/GCEs were fabricated using a drop-casting method followed by an electrochemical reduction process. The surface morphologies, microstructure and chemical compositions of the NH2–Fe3O4 nanoparticles (NPs), reduced graphene oxide (RGO) sheets and NH2–Fe3O4/RGO nanocomposites were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-Ray diffraction (XRD) and Fourier-transform infrared (FTIR) spectroscopy. The electrochemical behaviors of DA on the bare and modified GCEs were investigated in phosphate buffer solution (PBS) by cyclic voltammetry (CV). Compared with bare electrode and RGO/GCE, the oxidation peak current (ipa) on the NH2–Fe3O4/RGO/GCE increase significantly, owing to the synergistic effect between NH2–Fe3O4 NPs and RGO sheets. The oxidation peak currents (ipa) increase linearly with the concentrations of DA in the range of 1 × 10−8 mol/L – 1 × 10−7 mol/L, 1 × 10−7 mol/L – 1 × 10−6 mol/L and 1 × 10−6 mol/L – 1 × 10−5 mol/L. The detection limit is (4.0 ± 0.36) ×10−9 mol/L (S/N = 3). Moreover, the response peak currents of DA were hardly interfered with the coexistence of ascorbic acid (AA) and uric acid (UA). The proposed NH2–Fe3O4/RGO/GCE is successfully applied to the detection of dopamine hydrochloride injections with satisfactory results. Together with low cost, facile operation, good selectivity and high sensitivity, the NH2–Fe3O4/RGO/GCEs have tremendous prospects for the detection of DA in various real samples.

A new electrochemical sensor for nanomolar rutin detection based on amine-functionalized Fe3O4 nanoparticles and electrochemically reduced graphene oxide nanocomposite modified glassy carbon electrode (NH2-Fe3O4 NPs-ErGO/GCE) was fabricated through a simple method, and the X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), scanning electron microscope (SEM), transmission electron microscope (TEM), vibrating sample magnetometer (VSM) and electrochemical technique were used to characterize the modified electrode. The electrochemical behavior of rutin on the Fe3O4 NPs-ErGO/GCE was studied in detail. The electrochemical response of rutin at this modified electrode was remarkably higher than that of the bare GCE or other modified GCE (GO/GCE, Fe3O4 NPs-GO/GCE, and ErGO/GCE). Under the optimum determination conditions, Fe3O4 NPs-ErGO/GCE provided rutin with a broader detection range of 6.0 nM–0.1 µM; 0.1–8.0 µM and 8.0–80 µM, a minimum detectable concentration of 4.0 nM was obtained after 210 s accumulation. This novel method was applied in determination of rutin in pharmaceutical tablets and urine samples with satisfactory results.

Atomic diffusion by the vacancy defect of L12-Al3M (M = Sc, Zr, Er, Y) was investigated based on a first-principles calculation. The point defect formation energies were firstly evaluated. Then, the migration energy for different diffusion paths was obtained by the climbing-image nudged elastic band (CI-NEB) method. The results showed that Al atomic and M atomic diffusions through nearest-neighbor jump (NNJ) mediated by Al vacancy (VAl) were, respectively, the preferred diffusion paths in Al3M phases under both Al-rich and M-rich conditions. The other mechanisms, such as six-jump cycle (6JC) and next-nearest-neighbor jump (NNNJ), were energetically inhibited. The order of activation barriers for NNJ(Al-VAl) was Al3Zr < Al3Y < Al3Er < Al3Sc. The Al3Sc phase had high stability with a high self-diffusion activation barrier, while the Al3Zr and Al3Y phases were relatively unstable with a low self-diffusion activation energy. Moreover, the atomic-diffusion behavior between the core and shell layers of L12-Al3M was also further investigated. Zr atoms were prone to diffusion into the Al3Y core layer, resulting in no stable core-shelled Al3(Y,Zr), which well agreed with experimental observation.

In this study, S-doped graphitic carbon nitride (S-C3N4) was prepared using the high-temperature polymerization method, and then S-C3N4/AgCdS heterojunction photocatalyst was obtained using the chemical deposition method through loading Ag-doped CdS nanoparticles (AgCdS NPs) on the surface of S-C3N4. Experimental results show that the AgCdS NPs were evenly dispersed on the surface of S-C3N4, indicating that a good heterojunction structure was formed. Compared to S-C3N4, CdS, AgCdS and S-C3N4/CdS, the photocatalytic performance of S-C3N4/AgCdS has been significantly improved, and exhibits excellent photocatalytic degradation performance of Rhodamine B and methyl orange. The doping of Ag in collaboration with the construction of a Z-scheme heterojunction system promoted the effective separation and transport of the photogenerated carriers in S-C3N4/AgCdS, significantly accelerated its photocatalytic reaction process, and thus improved its photocatalytic performance.

Titania/electro-reduced graphene oxide nanohybrids (TiO2/ErGO) were synthesized by the hydrolysis of titanium sulfate in graphene oxide suspension and in situ electrochemical reduction. It provides a facile and efficient method to obtain nanohybrids with TiO2 nanoparticles (TiO2 NPs) uniformly coated by graphene nanoflakes. TiO2/ErGO nanohybrids were characterized by transmission electron microscopy, X-ray diffraction, cyclic voltammogram, and electrochemical impedance spectroscopy in detail. Compared with pure ErGO and TiO2 NPs, TiO2/ErGO nanohybrids greatly enhanced the electrocatalytic activity and voltammetric response of Allura Red. In the concentration range of 0.5–5.0 μM, the anodic peak currents of Allura Red were linearly correlated to their concentrations. However, the linear relationship was changed to the semi-logarithmic relationship at a higher concentration region (5.0–800 μM). The detection limit (LOD) was 0.05 μM at a signal-to-noise ratio of 3. The superior sensing performances of the proposed sensor can be ascribed to the synergistic effect between TiO2 NPs and ErGO, which provides a favorable microenvironment for the electrochemical oxidation of Allura Red. The proposed TiO2/ErGO/GCE showed good reproducibility and stability both in determination and in storage, and it can accurately detect the concentration of Allura Red in milk drinks, providing an efficient platform for the sensitive determination of Allura Red with high reliability, simplicity, and rapidness.

Al–Mg–Zn alloys reinforced by T–Mg32(Al,Zn)49 phase had higher structure stability and strength than Al–Zn–Mg–(Cu) alloys reinforced by MgZn2 phase, but the reasons for these two kind of alloys was not well-known. To reveal the discrepancy between T phase and MgZn2 phase, the lattice parameters, cohesive energy, and electronic structure as well as the elastic properties were investigated based on density functional theory. Four types of T phase unit cell were employed according to symmetry of space group. The calculated lattice constants well-agreed with experimental data. Compared to MgZn2 phase, T phases obtained lower cohesive energy owing to their partial covalent bond, which may result in a higher structure stability. The elastic modulus E of T phase depended on the occupation of Al atom, and the effect of the occupation of Al atom on the structure and properties of T phase was also discussed.