Explore the vast range of titles available.

The experiments reported in this study give deeper insight into the crystallization of milk fat in Emmental cheese, which is the most widely consumed hard cheese in France. Differential scanning calorimetry (DSC) was used to monitor the thermal properties of milk fat after the main stages involved during manufacture of Emmental cheese. By heating the samples to 60°C to eliminate their thermal history and cooling them at 2°C/min, the liquid → solid phase transition of fat was investigated. Confocal laser scanning microscopy was used to characterize in situ the supramolecular organization of milk fat dispersed in the casein matrix. The destabilization of fat globules by aggregation or coalescence and the formation of free fat during the manufacture altered the thermal properties of milk fat by increasing the initial temperature of crystallization and by the formation of 2 overlapping exotherms. The melting properties of the crystalline structures formed by fat at the temperatures used for ripening (12, 21, and 4°C) were examined. Differential scanning calorimetry was used to determine the ratio of solid to liquid fat; that is, the amount of fat that is crystallized, by dividing the partial enthalpy of melting of the fat for ripening temperature by the total enthalpy of melting of the same fat extracted from cheese. This study shows, for the first time, that milk fat is partially crystallized in Emmental cheese: about 55.7±3.5% of fat is solid at 4°C at the end of ripening. Polymorphic phase transitions of milk fat are also suggested during ripening of Emmental cheese.

The structure development of a soft cheese curd model has been studied in relationship to its rheological properties and its biochemical characteristics (pH, amount and partition of minerals, casein proteolysis) at different technical steps including cutting, drawing, three turns and demoulding. Scanning electron microscopy was used to observe structural changes during the drainage of a fat-free soft cheese. The micrographs provided visual evidence of changes in the casein matrix from casein particles aggregated in clusters to uniform strands observed at the demoulding. The initial increase of loss tangent and of the exponent of the power law between G′ and G′′ and frequency (that were maximal at the second turn) was related to the solubilization of micellar calcium phosphate, while intact caseins and large casein fragments accumulated in the curd. After the second turn, the strength, Youngs' and loss moduli of the curd increased greatly. The hydrolysis of αs1-casein into αs1-I-CN f(24–199) may facilitate the rearrangement of casein particles within the curd. The pH-induced solubilization of calcium phosphate continued throughout the manufacture process but was unexpectedly incomplete at the end of the drainage. Combination of electron microscopic observations with dynamic rheological measurements and chemical and biochemical assessments provided increased knowledge about the structure of soft cheese during drainage, an important but poorly understood cheese making stage.