Catalogue Search | MBRL
Search Results Heading
Explore the vast range of titles available.
MBRLSearchResults
-
DisciplineDiscipline
-
Is Peer ReviewedIs Peer Reviewed
-
Item TypeItem Type
-
SubjectSubject
-
YearFrom:-To:
-
More FiltersMore FiltersSourceLanguage
Done
Filters
Reset
656
result(s) for
"Haggerty, J. S."
Sort by:
The sPHENIX Micromegas Outer Tracker
2024
The sPHENIX Time Projection Chamber Outer Tracker (TPOT) is a Micromegas based detector. It is a part of the sPHENIX experiment that aims to facilitate the calibration of the Time Projection Chamber, in particular the correction of the time-averaged and beam-induced distortions of the electron drift. This paper describes the detector mission, setup, construction, installation, commissioning and performance during the first year of sPHENIX data taking.
A Comparison of the Effects of Neutron and Gamma Radiation in Silicon Photomultipliers
2019
The effects of radiation damage in silicon photomultipliers (SiPMs) from gamma rays have been measured and compared with the damage produced by neutrons. Several types of MPPCs from Hamamatsu were exposed to gamma rays and neutrons at the Solid State Gamma Ray Irradiation Facility (SSGRIF) at Brookhaven National Lab and the Institute for Nuclear Research (Atomki) in Debrecen, Hungary. The gamma ray exposures ranged from 1 krad to 1 Mrad and the neutron exposures ranged from 10\\(^8\\) n/cm\\(^2\\) to 10\\(^{12}\\) n/cm\\(^2\\). The main effect of gamma ray damage is an increase in the noise and leakage current in the irradiated devices, similar to what is seen from neutron damage, but the level of damage is considerably less at comparable high levels of exposure. In addition, the damage from gamma rays saturates after a few hundred krad, while the damage from neutrons shows no sign of saturation, suggestive of different damage mechanisms in the two cases. The change in optical absorption in the window material of the SiPMs due to radiation was also measured. This study was carried out in order to evaluate the use of SiPMs for particle physics applications with moderate levels of radiation exposures.
Measurement of charged hadron multiplicity in Au+Au collisions at s NN $$ \\sqrt{{\\textrm{s}}_{\\textrm{NN}}} $$ = 200 GeV with the sPHENIX detector
by
E. W. Cline
,
W. Goodman
,
G. Adawi
in
Heavy Ion Experiments
,
Heavy-Ion Collision
,
Quark Gluon Plasma
2025
Abstract The pseudorapidity distribution of charged hadrons produced in Au+Au collisions at a center-of-mass energy of s NN $$ \\sqrt{{\\textrm{s}}_{\\textrm{NN}}} $$ = 200 GeV is measured using data collected by the sPHENIX detector. Charged hadron yields are extracted by counting cluster pairs in the inner and outer layers of the Intermediate Silicon Tracker, with corrections applied for detector acceptance, reconstruction efficiency, combinatorial pairs, and contributions from secondary decays. The measured distributions cover |η| < 1.1 across various centralities, and the average pseudorapidity density of charged hadrons at mid-rapidity is compared to predictions from Monte Carlo heavy-ion event generators. This result, featuring full azimuthal coverage at mid-rapidity, is consistent with previous experimental measurements at the Relativistic Heavy Ion Collider, thereby supporting the broader sPHENIX physics program.
Journal Article
Design and Beam Test Results for the 2D Projective sPHENIX Electromagnetic Calorimeter Prototype
2021
sPHENIX is a new experiment under construction for the Relativistic Heavy Ion Collider at Brookhaven National Laboratory which will study the quark-gluon plasma to further the understanding of QCD matter and interactions. A prototype of the sPHENIX electromagnetic calorimeter (EMCal) was tested at the Fermilab Test Beam Facility in Spring 2018 as experiment T-1044. The EMCal prototype corresponds to a solid angle of \\( \\Delta \\eta \\times \\Delta \\phi = 0.2 \\times 0.2\\) centered at pseudo-rapidity \\(\\eta = 1\\). The prototype consists of scintillating fibers embedded in a mix of tungsten powder and epoxy. The fibers project back approximately to the center of the sPHENIX detector, giving 2D projectivity. The energy response of the EMCal prototype was studied as a function of position and input energy. The energy resolution of the EMCal prototype was obtained after applying a position dependent energy correction and a beam profile correction. Two separate position dependent corrections were considered. The EMCal energy resolution was found to be \\(\\sigma(E)/\\langle E\\rangle = 3.5(0.1) \\oplus 13.3(0.2)/\\sqrt{E}\\) based on the hodoscope position dependent correction, and \\(\\sigma(E)/\\langle E\\rangle = 3.0(0.1) \\oplus 15.4(0.3)/\\sqrt{E}\\) based on the cluster position dependent correction. These energy resolution results meet the requirements of the sPHENIX physics program.
Design and Beam Test Results for the sPHENIX Electromagnetic and Hadronic Calorimeter Prototypes
2018
The super Pioneering High Energy Nuclear Interaction eXperiment (sPHENIX) at the Relativistic Heavy Ion Collider (RHIC) will perform high precision measurements of jets and heavy flavor observables for a wide selection of nuclear collision systems, elucidating the microscopic nature of strongly interacting matter ranging from nucleons to the strongly coupled quark-gluon plasma. A prototype of the sPHENIX calorimeter system was tested at the Fermilab Test Beam Facility as experiment T-1044 in the spring of 2016. The electromagnetic calorimeter (EMCal) prototype is composed of scintillating fibers embedded in a mixture of tungsten powder and epoxy. The hadronic calorimeter (HCal) prototype is composed of tilted steel plates alternating with plastic scintillator. Results of the test beam reveal the energy resolution for electrons in the EMCal is \\(2.8\\%\\oplus~15.5\\%/\\sqrt{E}\\) and the energy resolution for hadrons in the combined EMCal plus HCal system is \\(13.5\\%\\oplus 64.9\\%/\\sqrt{E}\\). These results demonstrate that the performance of the proposed calorimeter system satisfies the sPHENIX specifications.