Explore the vast range of titles available.

The verification of mathematical models for multistage reciprocating compressors is crucial for ensuring their accuracy and reliability. In this study, we used different machine learning (ML) models to verify the results of MATLAB-based models of single-stage reciprocating compressors, multistage reciprocating compressors without intercoolers, and multistage reciprocating compressors with intercoolers to simulate the real-world operating conditions of a reciprocating compressor. The verification focuses on key performance indicators, such as the pressure–volume (PV) graph, outlet temperature graph, volumetric efficiency, and pressure ratio graph. The MATLAB model computes thermodynamic parameters, such as the power required, outlet pressure, and outlet temperature for various operating conditions. The MATLAB model produced the following results for single-stage compressor: the outlet pressure increased by 1.6 times the inlet pressure of the compressor, the volume reduced by 20% of the volume at the inlet of the single-stage compressor, and the outlet temperature increased by 30% of the inlet temperature. In the case of a multistage compressor without an intercooler, the outlet pressure increased by about 3.3–3.6 times the inlet pressure of the compressor; the volume reduced by 60% of the volume at the inlet, and the outlet temperature increased by 35% in comparison to the inlet temperature of the multistage compressor without an intercooler. Subsequently, in the case of a multistage compressor with an intercooler at the first stage of compression, the pressure increased by three times the inlet pressure; at the second stage of compression, the pressure increased by six times the inlet pressure of the compressor, the volume was reduced by approximately 80%, and the intercooler maintained the increase in outlet temperature by 30%, limiting it and preventing excessive expansion of air in the compressor and increasing the efficiency of the compressor by 12% in comparison to the multistage compressor without an intercooler. In addition, the results generated by all the machine learning models used in the study were in correlation with the results generated by the MATLAB model for all three compressors, with an accuracy of approximately 90% or more for almost all the models implemented for prediction. By comparing the predicted outputs from the ML model with the MATLAB-generated results, the accuracy and consistency of the simulation were assessed. This study aims to bridge the gap between traditional mathematical modeling and modern data-driven validation techniques to ensure robustness in compressor performance predictions.