Explore the vast range of titles available.

An optical pH sensor that enables the non-destructive measurement of acetic acid and its distribution in a photovoltaic module during damp heat (DH) testing is reported. The sensor was fabricated by impregnating a solution of a pH-sensitive fluorescent dye into a fluororesin membrane filter, which was then dried. While conducting the DH test, fluorescence spectra from 20 pH sensors were periodically recorded and converted into pH values using a predetermined calibration curve. As a result, we succeeded in measuring changes in pH with a DH test time of up to 2000 h, and it was possible to obtain information on the pH distribution in the module. We also confirmed no change in pH in a module with a silicone encapsulant free from acetic acid, and revealed that the sensor that we developed does not respond to moisture and heat, but only to acetic acid.

Potential‐induced degradation (PID) has been identified as a central reliability issue of photovoltaic (PV) cell modules. Several types of PID depend on the cell structure. Among those types, polarization‐type PID, which is characterized by reductions in short‐circuit current density (JSC) and open‐circuit voltage (VOC), is the fastest PID mode. Additionally, polarization‐type PID occurs readily at room temperature or at markedly low magnitudes of electric potential difference. Therefore, polarization‐type PID is a severe difficulty affecting silicon PV modules. Recently, degradation behavior, preventive measures, and mechanism have been investigated. As described herein, mechanistic aspects of polarization‐type PID are specifically examined and details of a recently proposed model involving a charge accumulation process at K centers in SiNx dielectric layers: the K‐center model are discussed. The K‐center model consistently explains previously reported results of experimentation, which indicates the validity of this model. Discussions presented herein are expected to improve the mechanistic understanding of polarization‐type PID in the PV community and to stimulate further discussions and verifications of the model. Potential‐induced degradation (PID) is a central issue related to photovoltaic module reliability. Several types of PID depend on the cell structure. Among them, polarization‐type PID is the fastest PID mode. This study examines mechanistic aspects of polarization‐type PID, with detailed discussion of the recently proposed model involving a charge accumulation process at K centers in SiNx layers: the K‐center model.

Background In the literature, factors associated with postoperative venous thromboembolisms (VTEs) after anterior cruciate ligament reconstruction (ACLR) are limited. This study aimed to investigate the incidence of venous thromboembolisms (VTEs) after anterior cruciate ligament reconstruction (ACLR) and to identify risk and predictive factors for VTEs. Methods This retrospective study included 136 patients who underwent arthroscopic ACLR with mechanical prophylaxis between April 2012 and July 2022. Contrast-enhanced computed tomography (CT) was applied to detect VTEs comprising deep venous thromboses and pulmonary embolisms 7 days after surgery. Data including age, sex, body mass index, concomitant treatments, graft types, smoking status, operative and tourniquet times, postoperative D-dimer levels, and other laboratory test results, were collected for analyses. The incidence of radiographically confirmed VTEs and the associated risk factors, such as age, sex, body mass index, concomitant treatments, graft types, smoking status, operative and tourniquet times, postoperative D-dimer levels, and other laboratory test results, were analyzed. Results The overall incidence of radiographic VTEs was 11.0% (15 cases) in 136 patients. There was one symptomatic patient who had Homan’s sign. Multivariable analysis indicated that postoperative D-dimer level was an independent factor related to a radiographic VTE after ACLR, although there was no association between radiographic VTEs and preoperative status or operation status. The optimal cutoff value for postoperative D-dimer level was 2.8 μg/ml according to the receiver operating characteristic curve analysis, with a sensitivity of 80.0% and specificity of 83.5%. Conclusion The incidence of ACLR-associated radiographical VTEs (deep venous thrombosis and pulmonary embolism) under mechanical prophylaxis was 11.0% in this study. An elevated D-dimer level at 7 days after surgery is an independent predictor of VTE in patients undergoing ACLR. The postoperative D-dimer level is a more reliable marker for identifying VTE in patients who underwent ACLR.

(1) Background: Protein stimulates the secretion of glucagon (GCG), which can affect glucose metabolism. This study aimed to analyze the metabolic effect of a high-protein diet (HPD) in the presence or absence of proglucagon-derived peptides, including GCG and GLP-1. (2) Methods: The response to HPD feeding for 7 days was analyzed in mice deficient in proglucagon-derived peptides (GCGKO). (3) Results: In both control and GCGKO mice, food intake and body weight decreased with HPD and intestinal expression of Pepck increased. HPD also decreased plasma FGF21 levels, regardless of the presence of proglucagon-derived peptides. In control mice, HPD increased the hepatic expression of enzymes involved in amino acid metabolism without the elevation of plasma amino acid levels, except branched-chain amino acids. On the other hand, HPD-induced changes in the hepatic gene expression were attenuated in GCGKO mice, resulting in marked hyperaminoacidemia with lower blood glucose levels; the plasma concentration of glutamine exceeded that of glucose in HPD-fed GCGKO mice. (4) Conclusions: Increased plasma amino acid levels are a common feature in animal models with blocked GCG activity, and our results underscore that GCG plays essential roles in the homeostasis of amino acid metabolism in response to altered protein intake.

This study investigated how the SiNx refractive index (RI) and SiO2 thickness, dox, of stacked SiNx/SiO2 passivation layers of the front p+emitters of n‐type crystalline‐silicon (c‐Si) photovoltaic (PV) cells affect their polarization‐type potential‐induced degradation (PID) behaviors. We prepared six n‐type c‐Si PV cells with an RI of 2.0 or 2.2 and with dox of 9, 2, or 1 nm. Then PV modules fabricated from the cells were subjected to PID tests during which a bias of −1000 V was applied to cells with respect to the front cover glass surface. For dox of 9 or 2 nm, rapid polarization‐type PID was observed, irrespective of the RI. However, for dox of 1 nm, the RI markedly affected the degradation behavior, and cells with an RI of 2.2 showed no degradation. These findings are attributable to carrier transport between the high RI (Si‐rich) SiNx and the c‐Si substrates, which can readily occur only when the SiO2 layer is sufficiently thin for electrons to tunnel through the SiO2 layer. These results are important for elucidating polarization‐type PID mechanisms and for developing preventive measures against polarization‐type PID. We investigated how the SiNx refractive index (RI) and SiO2 thickness, dox, of SiNx/SiO2 layers of n‐type crystalline‐silicon photovoltaic cells affect polarization‐type potential‐induced degradation. For dox greater than 2 nm, rapid degradation was observed irrespective of the RI. However, for dox of 1 nm, the RI strongly affected degradation, and 2.2‐RI cells showed no degradation.

The aim of this study is to investigate the effects of a low-carbohydrate staple food (i.e., low-carbohydrate bread) on glucose and lipid metabolism and pancreatic and enteroendocrine hormone secretion in comparison with meals containing normal-carbohydrate bread, without consideration of the carbohydrate content of the side dishes. T2DM patients (n = 41) were provided meals containing low-carbohydrate bread (LB) together with side dishes or normal-carbohydrate bread (NB) together with side dishes every other day as a breakfast. Blood glucose levels were evaluated by using a continuous glucose monitoring system; blood samples were collected before and 1 and 2 h after the breakfast. Postprandial blood glucose levels, plasma insulin, plasma glucose-dependent insulinotropic polypeptide (GIP) and plasma triglyceride were significantly lower and plasma glucagon levels were significantly higher in LB compared with those in NB. Plasma glucagon-like peptide-1 (GLP-1) levels did not differ in the LB and NB groups. These results indicate that changing only the carbohydrate content of the staple food has benefits on glucose and lipid metabolism in T2DM patients concomitant with the decrease of insulin and GIP secretion, which ameliorate body weight gain and insulin resistance.

The peptide-N ⁴-(N-acetyl-β-D-glucosaminyl) asparagine amidase F (PNGase F) catalyzes the cleavage of N-linked oligosaccharides between the innermost GlcNAc and asparagine residues of high mannose, hybrid and complex oligosaccharides from glycoproteins. The PNGase F has broad substrate specificity and thus is extensively used for the structural and functional studies of the glycoproteins. In this study, we tried to produce active recombinant PNGase F as secreted and intracellular-expressed forms using baculovirus expression vector system (BEVS) through silkworm larvae or cultured cells. PNGase F itself contains potential N-linked glycosylation sites and we found that it was N-glycosylated when PNGase F secreted from silkworm cells. Intriguingly, the secreted recombinant PNGase F has the lower catalytic activity and self-digests its N-linked glycans and therefore this secreted form of this enzyme produced from BEVS is not appropriate for carbohydrate chain analysis. Instead, we successfully mass-produced (2.1 mg/20 silkworm larvae) and purified active recombinant PNGase F as an intracellular protein without N-glycosylations. Besides, we confirmed by directed mutagenesis that several amino acid residues are crucial for the function of PNGase F. Our results provide an alternative method for the mass production of active enzymes involved in the study of glycoproteins.

Osteoporosis patients with chronic kidney disease (CKD) are becoming common in our superaging society. Renal dysfunction causes phosphorus accumulation in the circulating plasma and leads to the development of CKD-mineral bone disorder (MBD). We have previously reported that type III Pi transporter-overexpressing transgenic (Pit-1 TG) rats manifest phosphate (Pi)-dependent podocyte injury. In the present study, we explored the effect of risedronate on Pi-induced podocyte injury in vivo. Pit-1 TG rats and wild-type rats at 5 weeks old were divided into a risedronate-treated group and an untreated group. We subcutaneously administered 5 μg/kg body weight of risedronate or saline twice a week during the experimental period. Risedronate did not alter serum creatinine levels at 5, 8, and 12 weeks of age. However, electron microscopy images showed that thickening of the glomerular basement membrane was improved in the risedronate treatment group. Furthermore, immunostaining for podocyte injury markers revealed that both desmin- and connexin43-positive areas were smaller in the risedronate-treated group than in the untreated group, suggesting that bisphosphonates could rescue Pi-induced podocyte injury. In conclusion, our findings suggest that risedronate could maintain glomerular barrier function by rescuing Pi-induced podocyte injury.

The double-stranded RNA (dsRNA) mediated RNA interference (RNAi) is widely employed in silkworm and its tissue-derived cell lines for gene function analysis. Baculovirus expression vector system (BEVS) has an advantage for large-scale protein expression. Previously, combining these useful tools, we improved traditional AcMNPV-Sf9 BEVS to produce modified target glycoproteins, where the ectopic expression of Caenorhabditis elegans systemic RNAi defective-1 (SID-1) was found to be valuable for soaking RNAi. In current study, we applied CeSID-1 protein to a Bombyx mori NPV (BmNPV)-hypersensitive Bme21 cell line and investigated its properties both in soaking RNAi ability and recombinant protein expression. The soaking RNAi-mediated suppression in the Bme21 cell enables us to produce modified glycoproteins of interest in BmNPV–Bme21 BEVS.

Recently there has been increased interest in using thermoplastic encapsulant materials in photovoltaic modules, but concerns have been raised about whether these would be mechanically stable at high temperatures in the field. Recently, this has become a significant topic of discussion in the development of IEC 61730 and IEC 61215. We constructed eight pairs of crystalline‐silicon modules and eight pairs of glass/encapsulation/glass thin‐film mock modules using different encapsulant materials, of which only two were formulated to chemically crosslink. One module set was exposed outdoors with thermal insulation on the back side in Mesa, Arizona, in the summer (hot‐dry), and an identical module set was exposed in environmental chambers. High‐precision creep measurements (±20 μm) and electrical performance measurements indicate that despite many of these polymeric materials operating in the melt or rubbery state during outdoor deployment, no significant creep was seen because of their high viscosity, lower operating temperature at the edges, and/or the formation of chemical crosslinks in many of the encapsulants with age despite the absence of a crosslinking agent. Only an ethylene‐vinyl acetate (EVA) encapsulant formulated without a peroxide crosslinking agent crept significantly. In the case of the crystalline‐silicon modules, the physical restraint of the backsheet reduced creep further and was not detectable even for the EVA without peroxide. Because of the propensity of some polymeric materials to crosslink as they age, typical thermoplastic encapsulants would be unlikely to result in creep in the vast majority of installations. High‐precision creep measurements (±20 µm) and electrical performance measurements indicate that despite many of these polymeric materials operating in the melt or rubbery state during outdoor deployment, no significant creep was seen because of their high viscosity, lower operating temperature at the edges, and/or the formation of chemical crosslinks in many of the encapsulants with age despite the absence of a crosslinking agent. Only an ethylene‐vinyl acetate (EVA) encapsulant formulated without a peroxide crosslinking agent crept significantly. In the case of the crystalline‐silicon modules, the physical restraint of the backsheet reduced creep further and was not detectable even for the EVA without peroxide.