Explore the vast range of titles available.

Objective and Impact Statement. There is a need to develop platforms delineating inflammatory biology of the distal human lung. We describe a platform technology approach to detect in situ enzyme activity and observe drug inhibition in the distal human lung using a combination of matrix metalloproteinase (MMP) optical reporters, fibered confocal fluorescence microscopy (FCFM), and a bespoke delivery device. Introduction . The development of new therapeutic agents is hindered by the lack of in vivo in situ experimental methodologies that can rapidly evaluate the biological activity or drug-target engagement in patients. Methods . We optimised a novel highly quenched optical molecular reporter of enzyme activity (FIB One) and developed a translational pathway for in-human assessment. Results . We demonstrate the specificity for matrix metalloproteases (MMPs) 2, 9, and 13 and probe dequenching within physiological levels of MMPs and feasibility of imaging within whole lung models in preclinical settings. Subsequently, in a first-in-human exploratory experimental medicine study of patients with fibroproliferative lung disease, we demonstrate, through FCFM, the MMP activity in the alveolar space measured through FIB One fluorescence increase (with pharmacological inhibition). Conclusion . This translational in situ approach enables a new methodology to demonstrate active drug target effects of the distal lung and consequently may inform therapeutic drug development pathways.

[This corrects the article DOI: 10.34133/2021/9834163.].

Numerous optodes, with fluorophores as the chemical sensing element and optical fibres for light delivery and collection, have been fabricated for minimally invasive endoscopic measurements of key physiological parameters such as pH. These flexible miniaturised optodes have typically attempted to maximize signal-to-noise through the application of high concentrations of fluorophores. We show that high-density attachment of carboxyfluorescein onto silica microspheres, the sensing elements, results in fluorescence energy transfer, manifesting as reduced fluorescence intensity and lifetime in addition to spectral changes. We demonstrate that the change in fluorescence intensity of carboxyfluorescein with pH in this “high-density” regime is opposite to that normally observed, with complex variations in fluorescent lifetime across the emission spectra of coupled fluorophores. Improved understanding of such highly loaded sensor beads is important because it leads to large increases in photostability and will aid the development of compact fibre probes, suitable for clinical applications. The time-resolved spectral measurement techniques presented here can be further applied to similar studies of other optodes.

Immunostimulating complexes (ISCOM)-type nanocapsules have been functionalized with lipid vinyl sulfones that anchor to them via the hydrophobic zone of their structure and can be charged with pharmacologically active molecules or macromolecules. These functionalized nanocapsules can incorporate protein A and bind to G immunoglobulins (IgGs) to make vehicles directed at the surface antigens of infectious agents, tumor cells, or receptor cells and deliver the encapsulated molecules in a highly specific way. They may be of particular use in pharmacological treatments with highly toxic molecules that should not be used in solution whenever it can be avoided. When bound to antibodies they can be used in biological processes that require the delivery or presentation of macromolecules to certain specific cells, in immunization processes for instance, or in diagnostic immunological techniques, as they are able to transport both the secondary antibodies and the reaction labels. We describe the preparation of ISCOMs, the binding to the ISCOMS of newly synthesized compounds composed of chain alkyl vinyl sulfone, and the subsequent binding of the vinyl-sulfone compounds to IgGs. Within this context, a compound deriving from cholesterol functionalized with vinyl sulfone and used together with cholesterol in varying proportions has been linked to the structure of the ISCOMs and bound to protein A-IgG. This functionalization in no way altered the form or structure of the ISCOMs and allowed the nanocapsules carrying the specific IgGs to bind to forms of Trypanosoma cruzi against which antibodies had been developed. The fact that functionalized ISCOMs containing antibodies could deliver actinomycin D directly to the parasite meant that the effective dose of the antibiotic could be reduced very significantly. We have developed ISCOM-type nanocapsules functionalized with lipid vinyl sulfone capable of anchoring to the surface of functional IgGs, which favors the recognition and transport of these nanocapsules precisely to certain kinds of cell.

Cathepsin D is a protease that is an effector in the immune response of macrophages, yet to date, only a limited number of probes have been developed for its detection. Herein, we report a water soluble, highly sensitive, pH insensitive fluorescent probe for the detection of Cathepsin D activity that provides a strong OFF/ON signal upon activation and with bright emission at 515 nm. The probe was synthesised using a combination of solid and solution-phase chemistries, with probe optimisation to increase its water solubility and activation kinetics by addition of a long PEG chain (5 kDa) at the C -terminus. A BODIPY fluorophore allowed detection of Cathepsin D across a wide pH range, important as the protease is active both at the low pH found in lysosomes and also in higher pH phagolysosomes, and in the cytosol. The probe was successfully used to detect Cathepsin D activity in macrophages challenged by exposure to bacteria. Cathepsin D (CatD) is an aspartic acid protease involved in the immune response of macrophages to bacterial infection, and the development of pH insensitive CatD probes is vital in order to detect its activity across multiple cellular components. Here, the authors develop a water soluble and pH insensitive FRET-based fluorescent probe for the sensitive detection of CatD.

Two novel, water-soluble, merocyanine fluorophores were readily prepared by microwave-assisted synthesis. Full optical characterization was performed in a series of protic and aprotic solvents, and the dyes displayed fluorescence in the red region with up to a 20-fold decrease in brightness in water, demonstrating a strong environmental sensitivity hereby termed as solvato-fluorogenicity (to distinguish from solvatochromism). Shorter fluorescent lifetimes were also measured in water, which confirmed this character. These dyes were conjugated to a modified polymyxin scaffold that allowed fluorescence “switch-on” upon binding to Gram-negative bacterial membranes, and selective fluorescence detection of bacteria in a wash-free protocol.

The optimization of an undergraduate experiment for Organic Chemistry students is described to explore the concept of click chemistry. The preparation of a terminal fluorescent alkyne and an organic azide is reported consisting of simple steps. These are employed in the Cu(I)-catalized azide-alkyne cycloaddition to obtain a novel molecule containing a triazole ring whose characterization allows the students to practice a variety of techniques: NMR ( 1 H, 13 C, COSY and HSQC), melting point, thin layer chromatography, IR, fluorescence spectroscopy and mass spectrometry to confirm the structure of their obtained product. An alternative methodology in a one-pot reaction is also explored and a full laboratory manual provided.

Water use has been increasing globally by 1% per year, and recycling and re-use are critical issues compromised by the presence of pollutants. In this context, the design of novel materials and/or procedures for the large scale-removal of pollutants must be economically and environmentally feasible in order to be considered as part of the solution by emerging economies. We demonstrate that the cross-linking of biodegradable polysaccharides such as starch, dextrin, or dextrin and β-cyclodextrin with divinyl sulfone is an innovative strategy for synthesizing insoluble and eco-friendly sorbent polymers, including pSt, pDx and pCD-Dx. The evaluation of these polymers’ ability to remove ciprofloxacin (CIP), a prime example of antibiotic pollution, revealed that pSt, with a Kd of 1469 L/kg and a removal rate higher than 92%, is a favorable material. Its sorption is pH-dependent and enhanced at a mildly alkaline pH, allowing for the desorption (i.e., cleaning) and reuse of pSt through an environmentally friendly treatment with 20 mM AcONa pH 4.6. The facts that pSt (i) shows a high affinity for CIP even at high NaCl concentrations, (ii) can be obtained from affordable starting materials, and (iii) is synthesized and regenerated through organic, solvent-free procedures make pSt a novel sustainable material for inland water and seawater remediation, especially in less developed countries, due to its simplicity and low cost.

Water recycling and reuse are cornerstones of water management, which can be compromised by the presence of pollutants. Among these, pharmaceuticals can overcome standard water treatments and require sophisticated approaches to remove them. Sorption is an economically viable alternative limited by the need for sorbents with a sorption coefficient (Kd) higher than 500 L/kg. The cross-linking of dextrin (Dx) with divinyl sulfone (DVS) in the presence of 1 mmol or 5 mmol of ibuprofen (IBU) yields the insoluble polymers pDx1 and pDx5 with improved affinity for IBU and high selectivity towards erythromycin (ERY) and ERY Kd higher than 4 × 103 L/kg, when tested against a cocktail of six drugs. Characterization of the polymers shows that both pDx1 and pDx5 have similar properties, fast sorption kinetics, and ERY Kd of 13.3 × 103 for pDx1 and 6.4 × 103 for pDx5, representing 26.6 and 12.0 times the 500 L/kg threshold. The fact that new affinities and improvements in Kd can be achieved by cross-linking Dx in the presence of other molecules that promote pre-organization expands the applications of DVS cross-linked polysaccharides as sustainable, scalable, and environmentally friendly sorbents with a potential application in wastewater treatment plants (WTPs).