Explore the vast range of titles available.

The building sector is known to have a significant environmental impact, considering that it is the largest contributor to global greenhouse gas emissions of around 36% and is also responsible for about 40% of global energy consumption. Of this, about 50% takes place during the building operational phase, while around 10–20% is consumed in materials manufacturing, transport and building construction, maintenance, and demolition. Increasing the necessity of reducing the environmental impact of buildings has led to enhancing not only the thermal performances of building materials, but also the environmental sustainability of their production chains and waste prevention. As a consequence, novel thermo-insulating building materials or products have been developed by using both locally produced natural and waste/recycled materials that are able to provide good thermal performances while also having a lower environmental impact. In this context, the aim of this work is to provide a detailed analysis for the thermal characterization of recycled materials for building insulation. To this end, the thermal behavior of different materials representing industrial residual or wastes collected or recycled using Sardinian zero-km locally available raw materials was investigated, namely: (1) plasters with recycled materials; (2) plasters with natural fibers; and (3) building insulation materials with natural fibers. Results indicate that the investigated materials were able to improve not only the energy performances but also the environmental comfort in both new and in existing buildings. In particular, plasters and mortars with recycled materials and with natural fibers showed, respectively, values of thermal conductivity (at 20 °C) lower than 0.475 and 0.272 W/(m⋅K), while that of building materials with natural fibers was always lower than 0.162 W/(m⋅K) with lower values for compounds with recycled materials (0.107 W/(m⋅K)). Further developments are underway to analyze the mechanical properties of these materials.

In the present study, the daily dose in terms of submicron particle surface area received by children attending schools located in three different areas (rural, suburban, and urban), characterized by different outdoor concentrations, was evaluated. For this purpose, the exposure to submicron particle concentration levels of the children were measured through a direct exposure assessment approach. In particular, measurements of particle number and lung-deposited surface area concentrations at “personal scale” of 60 children were performed through a handheld particle counter to obtain exposure data in the different microenvironments they resided. Such data were combined with the time–activity pattern data, characteristics of each child, and inhalation rates (related to the activity performed) to obtain the total daily dose in terms of particle surface area. The highest daily dose was estimated for children attending the schools located in the urban and suburban areas (>1000 mm2), whereas the lowest value was estimated for children attending the school located in a rural area (646 mm2). Non-school indoor environments were recognized as the most influential in terms of children’s exposure and, thus, of received dose (>70%), whereas school environments contribute not significantly to the children daily dose, with dose fractions of 15–19% for schools located in urban and suburban areas and just 6% for the rural one. Therefore, the study clearly demonstrates that, whatever the school location, the children daily dose cannot be determined on the basis of the exposures in outdoor or school environments, but a direct assessment able to investigate the exposure of children during indoor environment is essential.

The guidelines of the European community towards a low-carbon economic society identify one of the most important scenarios in the energy efficiency of existing buildings. The discrepancy between the requirement and availability of free heat (endogenous heat, solar radiation) in certain hours of the day and operating conditions, makes the steady-state hypothesis generally inappropriate. In particular, the oscillating component of the transmitted flow, compared to the average temperature difference, is regressive in winter and dominant in summer. From this it follows the reliability of the stationary forecast models in winter and the need for dynamic forecast models in summer. The dominance of the continental climate in the EU, compared to the Mediterranean one, led to the actual delay in the development of dynamic models, especially at a regulatory level. In this paper, a methodology for assessing the dynamic properties of a building component is evaluated. The methodology, based on heat transmission equations implements a numerical model for existing building components whose input data can be obtained from experimental measurements. The developed model has been used to estimate the energetic and thermal behaviour of a building envelope subjected to energy efficiency measures.