Explore the vast range of titles available.

In this study, the influence of phenolic compounds on the sensory scores attributed to extra virgin olive oil (EVOO) by panel test was investigated. Two model olive oils (MOOs) with identical concentrations of volatile compounds, differing only in the amount of biophenols (297 vs. 511 mg kg−1), were analysed by two official panels and by SPME-GC/MS. Six other MOOs set up by the two previous models were also tested and analysed. They were formulated separately with the addition of three off-flavours (‘rancid’, ‘winey–vinegary’ and ‘fusty–muddy’). While high levels of EVOO phenolic compounds did not produce any effect on the headspace concentration of volatile compounds, they did affect the scores of both positive and negative sensory attributes of EVOO, due to the well-known in-mouth interactions between EVOO phenols, saliva and volatile compounds. In particular, a decrease of about 39% in the positive fruity score was found in the presence of a higher concentration of phenols. Regarding EVOO off-flavours, the higher level of phenolic compounds decreased by about 23% the score of ‘fusty–muddy’ defect and increased the score of ‘winey–vinegary’ defect about 733%. No important effect of EVOO phenolics on the perceived intensity of the ‘rancid’ defect was found. These findings could be helpful in explaining some discrepancies of panel test responses observed during extra virgin olive oil shelf life.

The 70% worldwide surface of olive orchards is irrigated. The evaluation of non-conventional water resources and water-saving techniques has gained importance during the last decades in arid and semiarid environments. This study evaluated the effects of irrigation with two water sources: low-cost water DEsalination and SEnsoR Technology (DESERT) desalinated water (DW) ECw ∼1 dS m−1) and reclaimed water (RW) (ECw ∼ 3 dS m−1) combined with two irrigation strategies: full irrigation (FI) (100% of ETc) and regulated deficit irrigation (RDI, 50% of ETc) on fruit yield, ripening indices, and oil yield and quality of olive trees cv Arbosana planted in Mediterranean conditions. Our results showed that RW without water restrictions increased the fruit yield by 35% due to a slight increase in the fruit weight and, mainly, to a greater fruit set than the control trees; although this did not result in a higher oil yield (g tree−1) since the oil content per fruit dry weight was reduced. The RDI strategy did not decrease the fruit yield despite the fact that olive weight tended to decrease, and it increased the oil yield by ∼14.5%. The combination of both stresses (RW and RDI) neither decreased the fruit yield; however, it significantly reduced oil yield (25% less in 2018) since oil content per fruit dry weight was strongly reduced (40%) compared to control trees. Both RDI treatments, regardless water source, determined acidity levels in olive paste lower than in FI treatments; however, it reduced oil extractability and fatty yield. The finding about oil quality indicated that olive exposure to RW, regardless of the water amount, decreased oil quality mainly due to the reduction of oleic acid and the increase of C18:2/C18:3 ratio and peroxides; on the contrary, both RW and RDI improved the total polyphenols. In all cases, the parameters met the legislation. In short, with appropriate management, RW and RDI have great potential to manage oil olive production; nevertheless, studies subjected to long-term use of these techniques should be experienced to ensure the sustainability of oil yields and quality.

‘Oliva di Gaeta’ is almost certainly the most important and well-known PDO denomination for table olives in Italy. Their production is based on a specific two-stage trade preparation called the ‘Itrana’ method. In this work, we investigated how variations in the duration of the initial water fermentation (i.e., 15 and 30 days) and the salt concentration (i.e., 6% and 8% NaCl) influence the chemical features, microbial dynamics, polyphenols, volatile organic compounds, and sensory features of ‘Oliva di Gaeta’. The time of the addition of salt did not affect the final concentration in the brine, but a longer initial water fermentation (before salt addition) led to lower pH values. The bacterial count constantly increased until the salt addition (i.e., either 15 or 30 days), while the yeast population peaked on day 30. Generally, the two different salt concentrations did not affect the count of microorganisms at the end of fermentation, with the only exception being a higher lactic acid bacteria count for the treatment with 6% salt added at 30 days. At commercial maturity, the crucial bitter tastant oleuropein was not completely removed from the drupes, and differences in salt concentration and the length of the first-stage water fermentation did not influence its content at the end of olive curing. Richer volatile profiles of olives were detected with higher-salt treatments, while the combination of low salt and early saline treatment provided a more distinct profile. Longer initial water fermentation caused a small increase in some phenolic compounds (e.g., iso-verbascoside, verbascoside, and hydroxytyrosol-glucoside). A panel test indicated that salt application at 30 days resulted in a more “Sour” and “Bitter” taste, irrespective of the salt concentration. The low salt concentration coupled with the late saline treatment resulted in more “Fruity” notes, probably due to the higher production of esters by lactobacilli. The slightly bitter perception of the olives was consistent with the partial removal of oleuropein. Our work revealed the characteristics of the ‘Itrana’ method and that the variation in salt concentration and its time of application changes parameters ranging from the microbial dynamics to the sensory profile. Specifically, our data indicate that 6% NaCl coupled with a longer initial water fermentation is the most different condition: it is less effective in blocking microbial growth but, at the same time, is more potent in altering the nutritional (e.g., polyphenols) and sensorial qualities (e.g., bitterness and fruitiness) of ‘Oliva di Gaeta’.

Using a range of chromatographic, spectroscopic, and mass spectrometric analytical techniques, we characterized one of the “edible items” found at the Vesuvius archeological sites and guarded at the National Archaeological Museum of Naples (MANN) in Naples, Italy. We authenticated the specimen contained in a glass bottle (Mann-S1 sample) as originally olive oil and mapped the deep evolution throughout its 2000 years of storage. Triacylglycerols were completely hydrolyzed, while the resulting (hydroxy) fatty acids had partly condensed into rarely found estolides. A complex pattern of volatile compounds arose mainly from breakdown of oleic acid. With excellent approximation, radiocarbon dating placed the find at the time of the Plinian Mount Vesuvius eruption in 79 A.D., indicating that Mann-S1 is probably the oldest residue of olive oil in the world found in bulk amount (nearly 0.7 L).

The role of ocean energy is expected to grow rapidly in the coming years, and techno-economic analysis will play a crucial role. Nowadays, despite strong assumptions, the vast majority of studies model costs using a top-down approach (the TdA) that leads to an unrepresentative economic model. WEC developers usually go through the the TdA approach because more detailed cost data are not available at an earlier design stage. At a very advanced design stage, some studies have also proposed techno-economic optimisation based on the bottom-up approach (BuA). This entails that the detailed cost metrics presented in the literature are very specific to the WEC type (hence not applicable to other cases) or unrepresentative. This lack of easily accessible detailed cost functions in the current state of the art leads to ineffective optimisations at an earlier stage of WEC development. In this paper, a BuA for WECs is proposed that can be used for techno-economic optimisation at the early design stage. To achieve this goal, cost functions of most common components in the WEC field are retrieved from the literature, exposed, and critically compared. The large number of components considered allows the results of this work to be applied to a vast pool of WECs. The novelty of the presented cost functions is their parameterization with respect to the technological specifications, which already enables their adoption in the design optimisation phase. With the goal of quantifying the results and critically discuss the differences between the TdA and the BuA, the developed methodology and cost functions are applied to a case study and specifically adopted for the calculation of the capital cost of PeWEC (pendulum wave energy converter). In addition, a hybrid approach (HyA) is presented and discussed as an intermediate approach between the TdA and the BdA. Results are compared in terms of capital expenditure (CapEx) and pie cost distribution: the impact of adopting different cost metrics is discussed, highlighting the role that reliable cost functions can have on early stage technology development. This paper proposes more than 50 cost functions for WEC components. Referring to the case study, it is shown that while the total cost differs only slightly (11%), the pie distribution changes by up to 22%. Mooring system and power take-off are the cost items where the TdA and the HyA differ more from the BuA cost estimate.

This case report describes the orthodontic treatment of a woman, aged 15 years, with permanent dentition, brachyfacial typology, with congenitally missing maxillary lateral incisors. Multibracket straightwire fixed appliance was used to open the space for dental implant placement, and treat the impaired occlusion. The missing lateral incisors were substituted with oral implants.