Explore the vast range of titles available.

Advancements in next-generation sequencing technology have enabled whole genome re-sequencing in many species providing unprecedented discovery and characterization of molecular polymorphisms. There are limitations, however, to next-generation sequencing approaches for species with large complex genomes such as barley and wheat. Genotyping-by-sequencing (GBS) has been developed as a tool for association studies and genomics-assisted breeding in a range of species including those with complex genomes. GBS uses restriction enzymes for targeted complexity reduction followed by multiplex sequencing to produce high-quality polymorphism data at a relatively low per sample cost. Here we present a GBS approach for species that currently lack a reference genome sequence. We developed a novel two-enzyme GBS protocol and genotyped bi-parental barley and wheat populations to develop a genetically anchored reference map of identified SNPs and tags. We were able to map over 34,000 SNPs and 240,000 tags onto the Oregon Wolfe Barley reference map, and 20,000 SNPs and 367,000 tags on the Synthetic W9784×Opata85 (SynOpDH) wheat reference map. To further evaluate GBS in wheat, we also constructed a de novo genetic map using only SNP markers from the GBS data. The GBS approach presented here provides a powerful method of developing high-density markers in species without a sequenced genome while providing valuable tools for anchoring and ordering physical maps and whole-genome shotgun sequence. Development of the sequenced reference genome(s) will in turn increase the utility of GBS data enabling physical mapping of genes and haplotype imputation of missing data. Finally, as a result of low per-sample costs, GBS will have broad application in genomics-assisted plant breeding programs.

Advances in next generation technologies have driven the costs of DNA sequencing down to the point that genotyping-by-sequencing (GBS) is now feasible for high diversity, large genome species. Here, we report a procedure for constructing GBS libraries based on reducing genome complexity with restriction enzymes (REs). This approach is simple, quick, extremely specific, highly reproducible, and may reach important regions of the genome that are inaccessible to sequence capture approaches. By using methylation-sensitive REs, repetitive regions of genomes can be avoided and lower copy regions targeted with two to three fold higher efficiency. This tremendously simplifies computationally challenging alignment problems in species with high levels of genetic diversity. The GBS procedure is demonstrated with maize (IBM) and barley (Oregon Wolfe Barley) recombinant inbred populations where roughly 200,000 and 25,000 sequence tags were mapped, respectively. An advantage in species like barley that lack a complete genome sequence is that a reference map need only be developed around the restriction sites, and this can be done in the process of sample genotyping. In such cases, the consensus of the read clusters across the sequence tagged sites becomes the reference. Alternatively, for kinship analyses in the absence of a reference genome, the sequence tags can simply be treated as dominant markers. Future application of GBS to breeding, conservation, and global species and population surveys may allow plant breeders to conduct genomic selection on a novel germplasm or species without first having to develop any prior molecular tools, or conservation biologists to determine population structure without prior knowledge of the genome or diversity in the species.

ABSTRACT Plant breeding and genetics research is an inherently data‐driven enterprise. Typical experiments and breeding nurseries can contain thousands of unique entries and programs will often evaluate tens of thousands of plots each year. To function efficiently on this scale, electronic data management becomes essential. Many research programs, however, continue to operate by scribing and transcribing massive amounts of data on paper field books. While effective, this form of data management places heavy burdens on human resources, decreases data integrity, and greatly limits future utilization of data and the ability to expand the breeding program. To help address these constraints, we have developed an open‐source application for electronic data capture that runs on consumer‐grade Android tablets. By focusing on a simple, stand‐alone application with an intuitive and customized interface, we attempt to decrease both the technological and cost barriers that hinder adoption of electronic data management in breeding programs. The simplicity of Field Book allows adoption of the technology without a steep learning curve. With low‐cost, accessible solutions, the vision of one handheld per breeder can become a reality for breeding programs around the world. Transformational capacity in electronic data collection and management will be essential to realizing a contemporary green revolution.

Quantitative resistance to plant pathogens, controlled by multiple loci of small effect is important for food production, food security, and food safety but is poorly understood. To gain insights into the genetic architecture of quantitative resistance in maize, we evaluated a 5,000-inbred-line nested association mapping population for resistance to northern leaf blight, a maize disease of global economic importance, twenty-nine quantitative trait loci were identified, and most had multiple alleles. The large variation in resistance phenotypes could be attributed to the accumulation of numerous loci of small additive effects. Genome-wide nested association mapping, using 1.6 million SNPs, identified multiple candidate genes related to plant defense, including receptor-like kinase genes similar to those involved in basal defense. These results are consistent with the hypothesis that quantitative disease resistance in plants is conditioned by a range of mechanisms and could have considerable mechanistic overlap with basal resistance.

Advances in next-generation sequencing offer high-throughput and cost-effective genotyping alternatives, including genotyping-by-sequencing (GBS). Results have shown that this methodology is efficient for genotyping a variety of species, including those with complex genomes. To assess the utility of GBS in cultivated hexaploid oat (Avena sativa L.), seven bi-parental mapping populations and diverse inbred lines from breeding programs around the world were studied. We examined technical factors that influence GBS SNP calls, established a workflow that combines two bioinformatics pipelines for GBS SNP calling, and provided a nomenclature for oat GBS loci. The high-throughput GBS system enabled us to place 45,117 loci on an oat consensus map, thus establishing a positional reference for further genomic studies. Using the diversity lines, we estimated that a minimum density of one marker per 2 to 2.8 cM would be required for genome-wide association studies (GWAS), and GBS markers met this density requirement in most chromosome regions. We also demonstrated the utility of GBS in additional diagnostic applications related to oat breeding. We conclude that GBS is a powerful and useful approach, which will have many additional applications in oat breeding and genomic studies.

Polyploid species have long been thought to be recalcitrant to whole-genome assembly. By combining high-throughput sequencing, recent developments in parallel computing, and genetic mapping, we derive, de novo, a sequence assembly representing 9.1 Gbp of the highly repetitive 16 Gbp genome of hexaploid wheat, Triticum aestivum, and assign 7.1 Gb of this assembly to chromosomal locations. The genome representation and accuracy of our assembly is comparable or even exceeds that of a chromosome-by-chromosome shotgun assembly. Our assembly and mapping strategy uses only short read sequencing technology and is applicable to any species where it is possible to construct a mapping population.

Gray leaf spot (GLS), caused by Cercospora zeae-maydis and Cercospora zeina, is one of the most important diseases of maize worldwide. The pathogen has a necrotrophic lifestyle and no major genes are known for GLS. Quantitative resistance, although poorly understood, is important for GLS management. We used genetic mapping to refine understanding of the genetic architecture of GLS resistance and to develop hypotheses regarding the mechanisms underlying quantitative disease resistance (QDR) loci. Nested association mapping (NAM) was used to identify 16 quantitative trait loci (QTL) for QDR to GLS, including seven novel QTL, each of which demonstrated allelic series with significant effects above and below the magnitude of the B73 reference allele. Alleles at three QTL, qGLS1.04, qGLS2.09, and qGLS4.05, conferred disease reductions of greater than 10%. Interactions between loci were detected for three pairs of loci, including an interaction between iqGLS4.05 and qGLS7.03. Near-isogenic lines (NILs) were developed to confirm and fine-map three of the 16 QTL, and to develop hypotheses regarding mechanisms of resistance. qGLS1.04 was fine-mapped from an interval of 27.0 Mb to two intervals of 6.5 Mb and 5.2 Mb, consistent with the hypothesis that multiple genes underlie highly significant QTL identified by NAM. qGLS2.09, which was also associated with maturity (days to anthesis) and with resistance to southern leaf blight, was narrowed to a 4-Mb interval. The distance between major leaf veins was strongly associated with resistance to GLS at qGLS4.05. NILs for qGLS1.04 were treated with the C. zeae-maydis toxin cercosporin to test the role of host-specific toxin in QDR. Cercosporin exposure increased expression of a putative flavin-monooxygenase (FMO) gene, a candidate detoxification-related gene underlying qGLS1.04. This integrated approach to confirming QTL and characterizing the potential underlying mechanisms advances the understanding of QDR and will facilitate the development of resistant varieties.

Core Ideas HTP platforms used to measure secondary traits across time Longitudinal data of secondary traits evaluated by SR, MT, and RR models, separately BLUPs of secondary traits used in the multivariate pedigree and genomic prediction Grain yield predictive ability was improved by 70% High‐throughput phenotyping (HTP) platforms can be used to measure traits that are genetically correlated with wheat (Triticum aestivum L.) grain yield across time. Incorporating such secondary traits in the multivariate pedigree and genomic prediction models would be desirable to improve indirect selection for grain yield. In this study, we evaluated three statistical models, simple repeatability (SR), multitrait (MT), and random regression (RR), for the longitudinal data of secondary traits and compared the impact of the proposed models for secondary traits on their predictive abilities for grain yield. Grain yield and secondary traits, canopy temperature (CT) and normalized difference vegetation index (NDVI), were collected in five diverse environments for 557 wheat lines with available pedigree and genomic information. A two‐stage analysis was applied for pedigree and genomic selection (GS). First, secondary traits were fitted by SR, MT, or RR models, separately, within each environment. Then, best linear unbiased predictions (BLUPs) of secondary traits from the above models were used in the multivariate prediction models to compare predictive abilities for grain yield. Predictive ability was substantially improved by 70%, on average, from multivariate pedigree and genomic models when including secondary traits in both training and test populations. Additionally, (i) predictive abilities slightly varied for MT, RR, or SR models in this data set, (ii) results indicated that including BLUPs of secondary traits from the MT model was the best in severe drought, and (iii) the RR model was slightly better than SR and MT models under drought environment.

Core Ideas Genomic selection applied for wheat quality in CIMMYT spring bread wheat breeding program. All wheat quality traits predicted and validated using forward genomic selection. Dough and loaf traits have moderately high predictive ability in CIMMYT breeding program. Genomic selection genetic gain 1.4 to 2.7 times higher than phenotypic selection. Wheat (Triticum aestivum L.) cultivars must possess suitable end‐use quality for release and consumer acceptability. However, breeding for quality traits is often considered a secondary target relative to yield largely because of amount of seed needed and expense. Without testing and selection, many undesirable materials are advanced, expending additional resources. Here, we develop and validate whole‐genome prediction models for end‐use quality phenotypes in the CIMMYT bread wheat breeding program. Model accuracy was tested using forward prediction on breeding lines (n = 5520) tested in unbalanced yield trials from 2009 to 2015 at Ciudad Obregon, Sonora, Mexico. Quality parameters included test weight, 1000‐kernel weight, hardness, grain and flour protein, flour yield, sodium dodecyl sulfate sedimentation, Mixograph and Alveograph performance, and loaf volume. In general, prediction accuracy substantially increased over time as more data was available to train the model. Reflecting practical implementation of genomic selection (GS) in the breeding program, forward prediction accuracies (r) for quality parameters were assessed in 2015 and ranged from 0.32 (grain hardness) to 0.62 (mixing time). Increased selection intensity was possible with GS since more entries can be genotyped than phenotyped and expected genetic gain was 1.4 to 2.7 times higher across all traits than phenotypic selection. Given the limitations in measuring many lines for quality, we conclude that GS is a powerful tool to facilitate early generation selection for end‐use quality in wheat, leaving larger populations for selection on yield during advanced testing and leading to better gain for both quality and yield in bread wheat breeding programs.

Background Wild relatives of wheat play a significant role in wheat improvement as a source of genetic diversity. Stem rust disease of wheat causes significant yield losses at the global level and stem rust pathogen race TTKSK (Ug99) is virulent to most previously deployed resistance genes. Therefore, the objective of this study was to identify loci conferring resistance to stem rust pathogen races including Ug99 in an Aegilops umbelluata bi-parental mapping population using genotype-by-sequencing (GBS) SNP markers. Results A bi-parental F 2:3 population derived from a cross made between stem rust resistant accession PI 298905 and stem rust susceptible accession PI 542369 was used for this study. F 2 individuals were evaluated with stem rust race TTTTF followed by testing F 2:3 families with races TTTTF and TTKSK. The segregation pattern of resistance to both stem rust races suggested the presence of one resistance gene. A genetic linkage map, comprised 1,933 SNP markers, was created for all seven chromosomes of Ae. umbellulata using GBS. A major stem rust resistance QTL that explained 80% and 52% of the phenotypic variations for TTTTF and TTKSK, respectively, was detected on chromosome 2U of Ae. umbellulata . Conclusion The novel resistance gene for stem rust identified in this study can be transferred to commercial wheat varieties assisted by the tightly linked markers identified here. These markers identified through our mapping approach can be a useful strategy to identify and track the resistance gene in marker-assisted breeding in wheat.