Explore the vast range of titles available.

Linear low-density polyethylene (LLDPE) blown films fabricated under two different processing conditions, namely a non-stalk bubble configuration and a stalk bubble configuration, were investigated. Morphological characterization was performed using small-angle X-ray scattering, transmission electron microscopy, infrared dichroism, and differential scanning calorimetry. The findings on crystal orientation characteristics of the films suggest that modification on the widely accepted row orientation model of Keller and Machin may be needed. In comparison to the conventional non-stalk bubble geometry for LLDPE film blowing, the stalk bubble configuration can produce a more randomly orientated lamellar texture, resulting in less anisotropy in mechanical properties and a higher dart impact resistance. A good correlation between mechanical properties and morphological features was found.

Photopolymerizable diacrylate monomers dissolved in fluid-layer smectic A and smectic C liquid crystal (LC) hosts exhibited significant spatial segregation and orientation that depend strongly on monomer structure. Small, flexible monomers such as 1,6-hexanediol diacrylate (HDDA) oriented parallel to the smectic layers and intercalated, whereas rod-shaped mesogen-like monomers such as 1,4-di-(4-(6-acryloyloxyhexyloxy)benzoyloxy)-2-methylbenzene (C6M) oriented normal to the smectic layers and collected within them. Such spatial segregation caused by the smectic layering dramatically enhanced photopolymerization rates; for HDDA, termination rates were reduced, whereas for C6M, both the termination and propagation rates were increased. These polymerization precursor structures suggest novel materials-design paradigms for gel LCs and nanophase-separated polymer systems.