Explore the vast range of titles available.

In the quest for the faint primordial B-mode polarization of the Cosmic Microwave Background, three are the key requirements for any present or future experiment: an utmost sensitivity, excellent control over instrumental systematic effects and over Galactic foreground contamination. Bolometric Interferometry (BI) is a novel technique that matches them all by combining the sensitivity of bolometric detectors, the control of instrumental systematics from interferometry and a software-based, tunable, in-band spectral resolution due to its ability to perform band-splitting during data analysis (spectral imaging). In this paper, we investigate how the spectral imaging capability of BI can help in detecting residual contamination in case an over-simplified model of foreground emission is assumed in the analysis. To mimic this situation, we focus on the next generation of ground-based CMB experiment, CMB-S4, and compare its anticipated sensitivities, frequency and sky coverage with a hypothetical version of the same experiment based on BI, CMB-S4/BI, assuming that lineof-sight (LOS) frequency decorrelation is present in dust emission but is not accounted for during component separation. We show results from a Monte-Carlo analysis based on a parametric component separation method (FGBuster), highlighting how BI has the potential to diagnose the presence of foreground residuals in estimates of the tensor-to-scalar ratio r in the case of unaccounted Galactic dust LOS frequency decorrelation.

The Q & U Bolometric Interferometer for Cosmology (QUBIC) is a cosmology experiment that aims to measure the B-mode polarization of the cosmic microwave background (CMB). Measurements of the primordial B-mode pattern of the CMB polarization are in fact among the most exciting goals in cosmology as it would allow testing of the inflationary paradigm. Many experiments are attempting to measure the B-modes, from the ground and the stratosphere, using imaging Stokes polarimeters. The QUBIC collaboration developed an innovative concept to measure CMB polarization using bolometric interferometry. This approach mixes the high sensitivity of bolometric detectors with the accurate control of systematics due to the interferometric layout of the instrument. We present the calibration results for the Technological Demonstrator, before its commissioning in the Argentinian observing site and preparation for first light.

QUBIC is a ground-based experiment aiming to measure the B-mode polarization of the cosmic microwave background. The developed instrument is an innovative two-frequency band bolometric interferometer that will operate at 300 mK with NbSi TES arrays. In this paper, we describe the fabrication process of the detectors.

Q & U Bolometric Interferometer for Cosmology (QUBIC) is an international ground-based experiment dedicated in the measurement of the polarized fluctuations of the Cosmic Microwave Background. It is based on bolometric interferometry, an original detection technique which combines the immunity to systematic effects of an interferometer with the sensitivity of low-temperature incoherent detectors. QUBIC will be deployed in Argentina, at the Alto Chorrillos mountain site near San Antonio de los Cobres, in the Salta Province. The QUBIC detection chain consists in 2048 NbSi transition edge sensors (TESs) cooled to 350 mK.The voltage-biased TESs are read out with time domain multiplexing based on Superconducting QUantum Interference Devices at 1 K and a novel SiGe application-specific integrated circuit at 60 K allowing to reach an unprecedented multiplexing factor equal to 128. The QUBIC experiment is currently being characterized in the laboratory with a reduced number of detectors before upgrading to the full instrument. I will present the last results of this characterization phase with a focus on the detectors and readout system.

The Q & U Bolometric Interferometer for Cosmology, QUBIC, is an innovative experiment designed to measure the polarization of the cosmic microwave background and in particular the signature left therein by the inflationary expansion of the Universe. The expected signal is extremely faint; thus, extreme sensitivity and systematic control are necessary in order to attempt this measurement. QUBIC addresses these requirements using an innovative approach combining the sensitivity of transition-edge sensor cryogenic bolometers, with the deep control of systematics characteristic of interferometers. This makes QUBIC unique with respect to others' classical imagers experiments devoted to the CMB polarization. In this contribution, we report a description of the QUBIC instrument including recent achievements and the demonstration of the bolometric interferometry performed in laboratory. QUBIC will be deployed at the observation site in Alto Chorrillos, in Argentina, at the end of 2019.

Issue Title: The Multi-Messenger Approach to High-Energy Gamma-Ray Sources: Third Workshop on the Nature of Unidentified High-Energy Sources LS I +61 303 has been detected by the Cherenkov telescope MAGIC at very high energies, presenting a variable flux along the orbital motion with a maximum clearly separated from the periastron passage. In the light of the new observational constraints, we revisit the discussion of the production of high-energy gamma rays from particle interactions in the inner jet of this system. The hadronic contribution could represent a major fraction of the TeV emission detected from this source. The spectral energy distribution resulting from pp interactions is recalculated. Opacity effects introduced by the photon fields of the primary star and the stellar decretion disk are shown to be essential in shaping the high-energy gamma-ray light curve at energies close to 200 GeV. We also present results of Monte Carlo simulations of the electromagnetic cascades developed very close to the periastron passage. We conclude that a hadronic microquasar model for the gamma-ray emission in LS I +61 303 can reproduce the main features of its observed high-energy γ-ray flux. [PUBLICATION ABSTRACT]

We discuss on the modelling of blazar jets as emitters of multiwavelength radiation with the implementation of a lepto-hadronic treatment. Assuming that injection of non-thermal electrons and protons can take place at the base of the jet, the stationary particle distributions can be found using an inhomogeneous one-dimensional transport equation with cooling and convection. The goal of this approach is to replace the widely used one-zone purely leptonic approximation by a more realistic model. We argue that the rapid variability observed in emission from blazars can be obtained as a result of interaction of the jet with obstacles, i.e., molecular clouds and stars. Long term variability is likely related to changes in the injection and physical conditions in the acceleration region.

With the continuous advance of technology, new challenges arise in the face of innovative learning models and their theoretical-practical representation, in which we seek to strengthen effective teaching methods and maximize academic and experiential performance. Therefore, this article describes the development of an electronic distiller for basic natural science laboratories as a result of the research process, which allows teachers and students to perform experimental practices by means of simple distillation. The team developed, involves the concepts of Electronic and Systems Engineering, to improve the efficiency of the simple distillation process, solving needs in terms of assembly time and resource utilization, and optimizing the learning experience. This allows for automatic control of the boiling point of the substances and the quantity of grams to be distilled as the final product. This, thanks to the instrumentation and control modules that interpret the sensor signals, in order to control the actuators such as, the heating, pumping and cooling water system. The processes are visualized thanks to an Android graphic interface application, which allows monitoring and configuring the Setpoint of the measured variables.

Measurements of cosmic microwave background (CMB) polarization may reveal the presence of a background of gravitational waves produced during cosmic inflation, providing thus a test of inflationary models. The Q&U Bolometric Interferometer for Cosmology (QUBIC) is an experiment designed to measure the CMB polarization. It is based on the novel concept of bolometric interferometry, which combines the sensitivity of bolometric detectors with the properties of beam synthesis and control of calibration offered by interferometers. To modulate and extract the input polarized signal of the CMB, QUBIC exploits Stokes polarimetry based on a rotating half-wave plate (HWP). In this work, we illustrate the design of the QUBIC instrument, focusing on the polarization modulation system, and we present preliminary results of beam calibrations and the performance of the HWP rotator at 300 K.

We present a catalog of cross-correlated radio, infrared and X-ray sources using a very restrictive selection criteria with an IDL-based code developed by us. The significance of the observed coincidences was evaluated through Monte Carlo simulations of synthetic sources following a well-tested protocol. We found 3320 coincident radio/X-ray sources with a high statistical significance characterized by the sum of error-weighted coordinate differences. For 997 of them, 2MASS counterparts were found. The percentage of chance coincidences is less than 1%. X-ray hardness ratios of well-known populations of objects were used to provide a crude representation of their X-ray spectrum and to make a preliminary diagnosis of the possible nature of unidentified X-ray sources. The results support the fact that the X-ray sky is largely dominated by Active Galactic Nuclei at high galactic latitudes (| b |≥10°). At low galactic latitudes (| b |≤10°) most of unidentified X-ray sources (∼94%) lie at | b |≤2°. This result suggests that most of the unidentified sources found toward the Milky Way plane are galactic objects. Well-known and unidentified sources were classified in different tables with their corresponding radio/infrared and X-ray properties. These tables are intended as a useful tool for researchers interested in particular identifications.