Explore the vast range of titles available.

Maize bran is an abundant cereal byproduct and a promising source of ferulated arabinoxylan biopolymers (FAXs). In this study, alkaline hydrolysis was optimized for FAX extraction from maize bran using a design-of-experiments approach evaluating alkali concentration, extraction time, and temperature. Purified FAXs were characterized for their chemical composition, phenolic and ferulic acid content, antioxidant activity, microstructure, and functional properties using GC–MS, HPLC, FT-IR, SEM, and standard antioxidant and functional assays. The FAX yields ranged from 14.7 to 18.9%, producing arabinose- and xylose-rich polymers (A/X ratio 0.68–0.74) with a high proportion of bound ferulic acid. Antioxidant assays (FRAP, ABTS, and DPPH) showed that alkaline-extracted and bound phenolic fractions exhibited substantially higher antioxidant capacity (p ≤ 0.05) than free phenolics, highlighting the importance of phenolic association with the arabinoxylan backbone. The FAX 3 extract also showed high activity in both the alkaline-extracted phenolic compounds (905.0 μg/g TE) and fraction II (286.5 μg/g TE), indicating that specific structural features may contribute to its bioactivity. In addition, FAXs demonstrated high water-holding capacity and favorable emulsifying properties. These results support the recovery of maize bran-derived FAXs as functional, antioxidant-active ingredients for food and related applications.

Bitterness often associated with whole wheat products may be related to phenolics in the bran. Cyclodextrins (CDs) are known to form inclusion complexes. The objective was to form inclusion complexes between β-CD and wheat phenolics. Pure phenolic acids (trans-ferulic acid (FA), caffeic acid (CA), and p-coumaric acid (CO)) and phenolic acids from wheat bran were used to investigate complex formation potential. Complexes were characterized by spectroscopy techniques, and a computational and molecular modeling study was carried out. The relative amount of complex formation between β-CD and wheat bran extract was CA > CO > FA. The phenolic compounds formed inclusion complexes with β-CDs by non-covalent bonds. The quantum-mechanical calculations supported the experimental results. The most stable complex was CO/β-CD complex. The ΔH value for CO/β-CD complex was −11.72 kcal/mol and was about 3 kcal/mol more stable than the other complexes. The QSPR model showed good correlation between binding energy and 1H NMR shift for the H5 signal. This research shows that phenolics and β-CD inclusion complexes could be utilized to improve the perception of whole meal food products since inclusion complexes have the potential to mask the bitter flavor and enhance the stability of the phenolics in wheat bran.

Non-biodegradable plastic materials pose environmental hazards and contribute to pollution. Arabinoxylan (AX) films have been created for applications in food packaging to replace these materials. The water interaction characteristics of biodegradable AX films were assessed following the extraction of AX from dry-milled corn bran (DCB), wet-milled corn bran (WCB), and dried distiller’s grains with solubles (DDGS). Films were prepared with laccase and sorbitol before surface modification with lipase–vinyl acetate. Water solubility of the modified DCB films was significantly reduced (p < 0.05); however, the water solubility of modified WCB films decreased insignificantly (p > 0.05) compared to unmodified films. Water vapor permeability of the modified AX films from WCB and DDGS was significantly reduced (p < 0.05), unlike their unmodified counterparts. The biodegradation rates of the modified WCB AX and DDGS films increased after 63 and 99 days, respectively, compared to the unmodified films. The hydrophilic nature of AX polymers from WCB and DDGS enhances the biodegradability of the films. This study found that the modified WCB AX film was more hydrophobic, and the modified DDGS AX film was more biodegradable than the modified DCB AX film. Overall, surface modifications have potential for improving hydrophobicity of biopolymer films.

Bread is considered a staple food worldwide, and therefore there is much interest in research around the topic. The bread industry is usually looking for ways to improve its formulations. Therefore, other ingredients such as dough conditioners, crumb softeners, emulsifiers, and surfactants can be added to enhance bread quality. These ingredients perform functions such as helping standardize processes in the industry, reducing dough-mixing time, increasing water absorption, improving bread quality, and extending its shelf life. Consumers are concerned about the effect of these ingredients on their health, and this has increased the popularity of clean-label bread formulations. A clean label generally indicates that a product is free of chemical additives, has an ingredient list that is easy to understand, has undergone natural or limited processing, and/or is organic and free of additives or preservatives. However, there is no scientific definition of the term “clean label.” Researchers have focused on these clean-label initiatives to replace dough strengtheners and preservatives in bread formulations and give consumers what they perceive as a healthier product.

The genetic gain in yield and quality are two major targets of wheat breeding programs around the world. In this study, a high density genetic map consisting of 10,172 SNP markers identified a total of 43 genomic regions associated with three quality traits, three yield traits and two agronomic traits in hard red spring wheat (HRSW). When compared with six grain shape and size traits, the quality traits showed mostly independent genetic control (~18% common loci), while the yield traits showed moderate association (~53% common loci). Association of genomic regions for grain area (GA) and thousand-grain weight (TGW), with yield suggests that targeting an increase in GA may help enhancing wheat yield through an increase in TGW. Flour extraction (FE), although has a weak positive phenotypic association with grain shape and size, they do not share any common genetic loci. A major contributor to plant height was the Rht8 locus and the reduced height allele was associated with significant increase in grains per spike (GPS) and FE, and decrease in number of spikes per square meter and test weight. Stable loci were identified for almost all the traits. However, we could not find any QTL in the region of major known genes like GPC-B1, Ha, Rht-1, and Ppd-1. Epistasis also played an important role in the genetics of majority of the traits. In addition to enhancing our knowledge about the association of wheat quality and yield with grain shape and size, this study provides novel loci, genetic information and pre-breeding material (combining positive alleles from both parents) to enhance the cultivated gene pool in wheat germplasm. These resources are valuable in facilitating molecular breeding for wheat quality and yield improvement.

This research explores the extraction of ferulated arabinoxylans (FAXs) from maize bran and their incorporation into wheat flour to assess their impact on rheological and pasting properties. Flour blends were prepared with FAX concentrations of 0%, 2%, 4%, 6%, 8%, and 10%, and these blends were then evaluated using farinograph, mixograph, micro-extensibility, and viscosity analyses. The results indicated that farinograph water absorption increased significantly (p ≤ 0.05), ranging from 54.9% to 60.5%, as the FAX content rose, correlating with higher gel-forming potential. Notably, the 2% FAX treatment (FAX2) exhibited the longest dough development time at 24.7 min. Stability and mixing time index (MTI) values also varied significantly (p ≤ 0.05) among treatments, with FAX2 displaying a longer mixing time of 14.4 ± 3.3 min. A pasting analysis revealed a significant decrease in peak and hot paste viscosity (p < 0.05) with increasing FAX concentrations, suggesting an association between lower hot paste viscosity and reduced breakdown. Micro-extensibility measures further indicated that blends with 0% and 2% FAX had greater extensibility, while the 4% FAX blend showed higher resistance. Overall, this research aims to advance the understanding of how these components can enhance flour functionality and contribute to the development of healthier, higher-quality baked products.

There is growing interest in the application of natural ingredients to replace chemical dough improvers in bread formulations in order to meet consumer demands of clean label products. The goal of this study was to evaluate the dough quality and baking quality of hard red spring (HRS) wheat flour blends to replace commercial dough improvers. Hard red winter (HRW) wheat flour is commonly used in bread and diner roll formulations. In this study, doughs were prepared by adding 10%, 20%, 30%, and 40% of HRS wheat flour to HRW wheat base-flour to compare the dough quality and baking quality relative to different levels of commercial improvers. Additional to commercial HRS flour, two commonly grown HRS wheat varieties (Glenn and Linkert) were included in the study. All of the HRS wheat flour blends had significantly (p < 0.05) higher farinograph stability and extensograph resistance at 135 min than doughs containing most of the commercial additives. Bread flour with 40% Glenn and 40% Linkert showed the highest loaf volumes of 920 cm3 and 950 cm3, respectively with the firmness of 1553.50 and 1525.50 mN, respectively. Baking quality of HRS wheat flour blends also showed significant (p < 0.05) correlation with dough rheology but commercial additives did not have the correlations. Therefore, HRS wheat flour may be used as a replacement for dough improvers, as it had better dough and bread properties compared to commercial additives and provides a great alternative for “clean-label” bread products.

Arabinoxylan (AX)-based films can improve the mechanical characteristics of biodegradable materials when utilized for food packaging. However, the mechanical properties of AX films for food packaging applications require thorough investigation to establish their viability. In this study, AX was extracted from corn bran coproducts of dry-milling (DCB), wet-milling (WCB), and dried distiller’s grains with solubles (DDGS) using an acid–alkali method. Packaging materials were produced using these AX extracts, each combined with laccase and sorbitol, forming the basis for three different films. These films were then modified by immersing the surface in a lipase–acetate solution. We evaluated their mechanical characteristics, including thickness, tensile properties, tear resistance, and puncture resistance. The thickness and tensile properties of the modified AX films derived from DCB and DDGS showed significant improvements (p < 0.05) compared to the unmodified AX films. In contrast, the modified AX films from WCB showed no significant changes (p > 0.05) in thickness and tensile properties compared to the unmodified WCB AX films. A significant increase in tear resistance (p < 0.05) was observed in all modified AX films after immersion in the lipase–acetate mixture. While puncture resistance was enhanced in the modified AX films, the improvement was not statistically significant (p > 0.05) compared to the unmodified films. The presence of hydroxyl (OH) and carbonyl (CO) groups on the surfaces of AX films from DCB and DDGS, modified by the lipase–acetate solution, suggests excellent biodegradability properties. The modification process positively affected the AX films, rendering them more bendable, flexible, and resistant to deformation when stretched, compared to the unmodified AX films.

Plant-derived proteins, such as those from sesame seeds, have the potential to be used as versatile food ingredients. End-use functionality can be further improved by high-intensity ultrasound treatments. The effects of high-intensity ultrasound on the properties of sesame protein isolates from cold-pressed sesame cake were evaluated. The SDS-PAGE demonstrated no significant changes in the molecular weight of proteins. Ultrasound treatments resulted in decreased particle size with a more uniform distribution, resulting in the exposure of hydrophobicity and free −SH groups and increased zeta potential. Although FTIR spectra of proteins were similar after ultrasonication, a partial increase in the intensity of the amide A band was observed. The ultrasound significantly (p < 0.05) affected the secondary structure of proteins. While optical micrographics revealed a dispersed structure with smaller particles after treatments, microstructural observations indicated more rough and irregular surfaces. Water solubility was improved to 80.73% in the sample subjected to 6 min of ultrasonication. Sesame protein solutions treated for 4 and 6 min exhibited viscoelastic structure (storage modulus (G′) > loss modulus (G′′)). In addition, the gelation temperature of proteins decreased to about 60–65 °C with increasing treatment time. Overall, ultrasound is a useful technique for the modification of sesame protein isolates.

Heat treatment is used as a pre-processing step to beneficially change the starch properties of wheat flour to enhance its utilisation in the food industry. Heat-treated wheat flour may provide improved eating qualities in final wheat-based products since flour properties predominantly determine the texture and mouthfeel. Dry heat treatment of wheat kernels or milled wheat products involves heat transfer through means of air, a fluidising medium, or radiation—often resulting in moisture loss. Heat treatment leads to changes in the chemical, structural and functional properties of starch in wheat flour by inducing starch damage, altering its molecular order (which influences its crystallinity), pasting properties as well as its retrogradation and staling behaviour. Heat treatment also induces changes in gluten proteins, which may alter the rheological properties of wheat flour. Understanding the relationship between heat transfer, the thermal properties of wheat and the functionality of the resultant flour is of critical importance to obtain the desired extent of alteration of wheat starch properties and enhanced utilisation of the flour. This review paper introduces dry heat treatment methods followed by a critical review of the latest published research on heat-induced changes observed in wheat flour starch chemistry, structure and functionality.