Explore the vast range of titles available.

In this study, the fluorescence properties of Lumisis, a phosphor that can be easily applied to ultrafine wires, were evaluated. By evaluating the wavelength characteristics of Lumisis phosphor, we investigated the possibility of applying it to a dual-wavelength laser-induced fluorescence (LIF) measurement system and evaluated the accuracy of temperature measurements. The difference between the decrease in the percentage intensities of the red and green fluorescence of Lumisis phosphors showed that two-color LIF was possible. The Lumisis phosphor–mixture ratio was optimized as 1:1.25, and the average measurement error of the fluorescent wire was 0.20 K, as evaluated through uncertainty analysis. Finally, the application of this measurement method to hot air jet phenomena showed that this method accurately captures the temperature changes in hot air, thus proving its validity.

In this study, an optical sensor using thermo-sensitive phosphor and its measurement system for visualizing and measuring the temperature distribution in an arbitrary cross-section of transmission oil using one type of phosphor, whose peak wavelength changes with temperature, is proposed. Because the intensity of the excitation light is gradually attenuated by the scattering of the laser light owing to microscopic impurities in the oil, we attempted to reduce the scattering effect by increasing the excitation light wavelength. Therefore, Pyrromethene 597 was selected as the optical sensor using thermo-sensitive phosphor, and a DPSS (Diode Pumped Solid State) laser with a wavelength of 532 nm was used as the excitation light. Using this measurement system, we measured the temperature distribution of a vertical buoyant jet of transmission oil and validated the measurement method. In addition, it was shown that this measurement system could be applied to the measurement of the temperature distribution in transmission oil with cavitation foaming.

In a typical coding method for particle streak velocimetry, the streak shape is divided into two dots and one line by controlling the illumination timing. In this study, several parameters were formulated to optimize the streak shape in a uniform flow using a theoretical approach. In contrast, for non-uniform flows, the formulation of optimal conditions does not provide a common criterion for all flow fields. Therefore, we developed a streak simulation technique based on a two-dimensional flow field and investigated a numerical approach to identify the optimization conditions for non-uniform flows. The test flow fields considered were the Couette flow, von Karman vortex, and Rankine vortex, with the streak number considered one of the parameters affecting the failure of the streak shape, increasing from 100 to 1300. In addition, another parameter, the magnification factor acting on the mean velocity of the flow field, was increased from 0.2 to 1.2. Furthermore, five types of streak failure factors were identified and analyzed based on their frequency of occurrence. The results of the two-dimensional streak simulation showed that the condition for maximizing the number of non-failure streaks for each flow field was successfully identified, and an estimation of the optimal illumination time was obtained. Additionally, vector densities of 0.001 vectors per pixel were achieved for the von Karman and Rankine vortices. The streak simulation can be an effective tool for evaluating the availability of PSV. Graphical abstract

In this paper, we propose a temperature measurement method that uses ultrafine fluorescent wires to reduce the wire diameter to a much lesser extent than a thermocouple. This is possible because its structure is simple and any material can be used for the wire. Hence, ultrafine wires with a Reynolds number of less than 1.0 can be selected. Ultra-fine wires less than 50 µm in diameter were set in the test volume. The wire surfaces were coated with fluorescent paint. The test volume was illuminated using an ultraviolet light-emitting diode. The paint emits very tiny, orange-colored fluorescent light with an intensity that changes with the temperature of the atmosphere. The experimental results showed that the heating/cooling layers were well visualized and the temperature field was well analyzed.

This study presents an innovative hybrid geothermal air conditioning system that combines conventional air-based heat exchange with ground heat exchange technology. The system features a ground heat exchanger placed downstream from the outdoor unit heat exchanger, requiring minimal modifications to conventional air conditioners through the addition of bypass flow paths and a four-way valve. This design ensures that the ground heat exchanger consistently operates after the outdoor unit heat exchanger in both cooling and heating modes. The researchers evaluated the proposed system’s performance through both computational simulation (1D-CAE) and experimental testing. Simulation results demonstrated significant efficiency improvements, with the hybrid system achieving a coefficient of performance (COP) of 4.51 compared to just 1.24 for conventional air conditioners under extreme temperature conditions (38 °C). The experimental validation with a shallow-buried (20 cm) ground heat exchanger confirmed an approximately 20% COP improvement across various ambient temperatures. The main advantages of this hybrid system over conventional geothermal systems include reduced installation costs due to shorter borehole lengths, separate air conditioning units and underground piping, and compatibility with existing control systems. The design addresses skilled labor shortages while enabling large-scale demonstration operations with minimal initial investment. Future work will focus on optimizing the burial depth and conducting long-term durability testing to advance practical implementation.

A new monoacylglyceryltrimethylhomoserine, 21F121-A ( 1 ), was isolated from the culture of Penicillium glaucoroseum (21F00121) by LCMS-guided purification. The structure was elucidated by NMR and mass spectrometries. The absolute configuration of the homoserine moiety was analyzed by the ECD spectrum after acid hydrolysis, and the S -configuration of the glycerol moiety was determined based on the spectrum of the 1,2-dibenzoyl derivative after acid hydrolysis. Although a variety of diacylglyceryltrimethylhomoserine is distributed in lower plants and fungi, a limited number of studies on monoacyl derivatives have been reported. This is the fourth sample of monoacylglyceryltrimethylhomoserine discovered from a natural source, and the second sample isolated from a fungus. Compound 1 contains an unusual branched pentaene chain attached at the sn -1 position of glycerol and weakly inhibited the growth of HCT116 cells. Graphical abstract

A combination of LC–MS/MS and feature-based molecular networking analyses led to the isolation of a new adenopeptin analog, higapeptin ( 1 ), and four known peptides, adenopeptin ( 2 ), adenopeptins B and C ( 3 and 4 ), and acremopeptin ( 5 ), from the rice culture of the fungus Acremonium persicinum (18F04103) isolated from a mud flat of the Ariake Sea in Kyushu, Japan. The structure of 1 was determined by NMR and MS/MS fragmentation analyses. The absolute configuration of the constituent amino acids was determined by Marfey’s analysis after acid hydrolysis. The C-terminal residue was synthesized, and its absolute configuration was established by Marfey’s analysis. Compounds 1 and 2 were found to inhibit mitochondrial energy metabolism, similar to efrapeptin D ( 6 ), a known mitochondrial ATPase inhibitor. Graphical abstract

A Raman lidar with a deep ultraviolet laser was constructed to continuously monitor water vapor distributions in the atmospheric boundary layer for twenty-four hours. We employ a laser at a wavelength of 266 nm and detects the light separated into an elastic backscatter signal and vibrational Raman signals of oxygen, nitrogen, and water vapor. The lidar was encased in a temperature-controlled and vibration-isolated compact container, resistant to a variety of environmental conditions. Water vapor profile observations were made for twelve months from November 24, 2017, to November 29, 2018. These observations were compared with collocated radiosonde measurements for daytime and nighttime conditions.