Explore the vast range of titles available.

Magnetic skyrmions are localized and topologically protected spin configurations, which are of both fundamental and applied interests for future electronics. In this work, we propose a voltage-gated skyrmion transistor within the well-established framework of micromagnetics. Its operating conditions and processes have been theoretically investigated and demonstrated, in which the gate voltage can be used to switch on/off a circuit. Our results provide the first time guidelines for practical realization of hybrid skyrmionic-electronic devices.

A regional haze episode occurred in the Beijing, Tianjin and Hebei province (BTH) area in the North China Plain (NCP) from 16 to 19 January 2010. Data were collected and analyzed during the time frame of 14 through 23 January 2010 to include the haze event. The increase of secondary inorganic pollutants (SO42−, NO3−, NH4+) in PM2.5 was observed simultaneously at four sites, especially in the plain area of the BTH, which could be identified as a common characteristic of pollution haze in east China. The sulfate and nitrate in PM2.5 were mainly formed through the heterogeneous reaction process in the urban area. The organic matter (OM) increased more significantly at the Chengde (CD) site than the other three sites in the plain area. The secondary organic aerosols only existed during haze days at CD but in both haze and non-haze days at the other three sites, which suggested the greater regional impact of secondary formation process during the haze episode. The secondary formation of aerosol was one important formation mechanism of haze. The strong temperature inversion and descending air motions in the planetary boundary layer (PBL) allowed pollutants to accumulate in a shallow layer. The weak surface wind speed produced high pollutants concentration within source regions. The accumulation of pollutants was one main factor in the haze formation. The enhanced southwest wind in the last period of this episode transported pollutants to the downwind area and expanded the regional scope of the haze.

Membrane biofilm reactors (MBfRs) deliver gaseous substrates to biofilms that develop on the outside of gas-transfer membranes. When an MBfR delivers electron donors hydrogen (H2) or methane (CH4), a wide range of oxidized contaminants can be reduced as electron acceptors, e.g., nitrate, perchlorate, selenate, and trichloroethene. When O2 is delivered as an electron acceptor, reduced contaminants can be oxidized, e.g., benzene, toluene, and surfactants. The MBfR’s biofilm often harbors a complex microbial community; failure to control the growth of undesirable microorganisms can result in poor performance. Fortunately, the community’s structure and function can be managed using a set of design and operation features as follows: gas pressure, membrane type, and surface loadings. Proper selection of these features ensures that the best microbial community is selected and sustained. Successful design and operation of an MBfR depends on a holistic understanding of the microbial community’s structure and function. This involves integrating performance data with omics results, such as with stoichiometric and kinetic modeling.

In order to study the temporal and spatial variations of PM2.5 and its chemical compositions in the region of Beijing, Tianjin, and Hebei (BTH), PM2.5 samples were collected at four urban sites in Beijing (BJ), Tianjin (TJ), Shijiazhuang (SJZ), and Chengde (CD), and also one site at Shangdianzi (SDZ) regional background station over four seasons from 2009 to 2010. The samples were weighted for mass concentrations and analyzed in the laboratory for chemical profiles of 19 elements (Al, As, Ba, Ca, Cd, Co, Cr, Cu, Fe, K, Mg, Mn, Ni, P, Pb, Sr, Ti, V, and Zn), eight water-soluble inorganic ions (Na+ , NH4+ , K+ , Mg2+ , Ca2+ , Cl- , NO3- , and SO42- , and carbon fractions (OC and EC). The concentrations of PM2.5 and its major chemical species were season dependent and showed spatially similar characteristics in the plain area of BTH. The average annual concentrations of PM2.5 were 71.8-191.2 μg m-3 at the five sites, with more than 90% of sampling days exceeding 50 μg m-3 at BJ, TJ, and SJZ. PM2.5 pollution was most serious at SJZ, and the annual concentrations of PM2.5 , secondary inorganic ions, OC, EC, and most crustal elements were all highest. Due to stronger photochemical oxidation, the sum of concentrations of secondary inorganic ions (NH4+ , NO3- , and SO42- was highest in the summer at SDZ, BJ, TJ, and CD. Analysis of electric charges of water-soluble inorganic ions indicated the existence of nitric acid or hydrochloric acid in PM2.5 . For all five sites, the concentrations of OC, EC and also secondary organic carbon (SOC) in the spring and summer were lower than those in the autumn and winter. SOC had more percentages of increase than primary organic carbon (POC) during the winter. The sums of crustal elements (Al, Ca, Fe, Mg, Ti, Ba, and Sr) were higher in the spring and autumn owing to more days with blowing or floating dust. The concentrations of heavy metals were at higher levels in the BTH area by comparison with other studies. In Shijiazhuang and Chengde, the PM2.5 pollution was dominated by coal combustion. Motor vehicle exhausts and coal combustion emissions both played important roles in Tianjin PM2.5 pollution. However, motor vehicle exhausts had played a more important role in Beijing owing to the reduction of coal consumption and sharp increase of cars in recent years. At SDZ, regional transportation of air pollutants from southern urban areas was significant.

As a crucial role in various aspects of quantum transport, quantum pumping usually refers to the controlled movement of particles through external manipulation. This work reports a unique occurrence of self-organized quantum pumping for photons without any external driving in a spin–cavity system, where an assemble of quantum emitters interact with photonic modes confined in two tunneling-coupled cavities. Specifically, undermirror-symmetry breaking of cavity dissipations and spin–cavity coupling strengths, a steady photon current spontaneously emerges between the two cavities when the system reaches its superradiant phase. Investigation shows that cavity dissipation, which acts as a pump, assists the system to sustainably extract photons from the surroundings and generate a superradiant photon current with photon loss via dissipation channels. Generating with Z2 spontaneous symmetry breaking, this kind of counter-intuitive photon current provides a spontaneous regime for the occurrence of current in real space.

The post-dynamic recrystallization behavior of ultrafine-grained (UFG: 0.44 μm) cp-Ti under annealing, room temperature (RT) monotonic and cyclic loading was investigated across a range of temperatures and deformation rates wherever appropriate. By characterizing the grain and boundary structures, it was confirmed that recrystallization and grain growth occurred due to annealing (≥ 600 °C) and R = − 1 fatigue at RT. There was a noticeable 30 deg aggregation in misorientation distribution, along with the increased grain size. However, the hypothetical correlation between 30 deg aggregation and Σ13a or the other characteristic coincidence site lattice boundaries was found to be weak. The fatigue-induced grain growth is particularly intriguing for two reasons. First, the large monotonic deformation with low strain rate cannot trigger grain growth. Second, fatigue sharpened the basal intensity around the ND and caused a weaker texture component close to TD (load axis along the LD, perpendicular to the TD–ND plane). By contrast, high-temperature annealing only strengthened the UFG processing induced basal pole but without affecting its location. Novel insights into this fatigue-induced texture evolution in UFG cp-Ti has been provided. The lattice rotation during fatigue can be attributed to the combined effect of activation of prismatic ⟨a⟩ slip parallel to LD, and basal ⟨a⟩ slip perpendicular to it. The theoretically calculated stress to activate dislocation slip by assuming a non-equilibrium grain boundary state lent support to the above assertion. Moreover, the TEM observation evidently showed the characteristics of dislocation cross-slip and multiple slip in the grain interior.

A multitude of micro- and nanoparticles have been developed to improve the delivery of systemically administered pharmaceuticals, which are subject to a number of biological barriers that limit their optimal biodistribution. Bioinspired drug-delivery carriers formulated by bottom-up or top-down strategies have emerged as an alternative approach to evade the mononuclear phagocytic system and facilitate transport across the endothelial vessel wall. Here, we describe a method that leverages the advantages of bottom-up and top-down strategies to incorporate proteins derived from the leukocyte plasma membrane into lipid nanoparticles. The resulting proteolipid vesicles—which we refer to as leukosomes—retained the versatility and physicochemical properties typical of liposomal formulations, preferentially targeted inflamed vasculature, enabled the selective and effective delivery of dexamethasone to inflamed tissues, and reduced phlogosis in a localized model of inflammation. Lipid nanoparticles incorporating proteins from the leukocyte plasma membrane retain the properties of liposomal formulations and enable delivery of drugs to inflamed tissues.

In this study, We demonstrated that Bax mitochondrial translocation plays a vital role in the initiation of the mitochondrial signaling pathway upon activation by heat stress. In addition, both p53 mitochondrial translocation and Ca 2+ signal mediated MPTP opening activate Bax mitochondrial translocation. Employing pifithrin-α (a p53 mitochondrial translocation inhibitor) and CsA (a permeability transition pore (MPTP) inhibitor), we found that heat stress induced Bax mitochondrial translocation was significantly inhibited in cells pretreated with both PFT and CsA. Furthermore, we demonstrated that generation of reactive oxygen species (ROS) is a critical mediator in heat stress induced apoptosis and that the antioxidant MnTBAP significantly decreased heat stress induced p53 mitochondrial translocation and Ca 2+ signal mediated MPTP opening, as well as the subsequent Bax mitochondrial translocation and activation of the caspase cascade. Taken together, our results indicate that heat stress induces apoptosis through the mitochondrial pathway with ROS dependent mitochondrial p53 translocation and Ca 2+ dyshomeostasis and the ensuing intro Bax mitochondrial translocation as the upstream events involved in triggering the apoptotic process observed upon cellular exposure to heat stress.

Periodontitis is a major threat to oral health, prompting scientists to continuously study new treatment techniques. The nanofibrous membrane prepared via electrospinning has a large specific surface area and high porosity. On the one hand, electrospun nanofibers can improve the absorption capacity of proteins and promote the expression of specific genes. On the other hand, they can improve cell adhesion properties and prevent fibroblasts from passing through the barrier membrane. Therefore, electrospinning has unique advantages in periodontal treatment. At present, many oral nanofibrous membranes with antibacterial, antiinflammatory, and tissue regeneration properties have been prepared for periodontal treatment. First, this paper introduces the electrospinning process. Then, the commonly used polymers of electrospun nanofibrous membranes for treating periodontitis are summarized. Finally, different types of nanofibrous membranes prepared via electrospinning for periodontal treatment are presented, and the future evolution of electrospinning to treat periodontitis is described. Keywords: periodontitis, electrospinning, barrier membrane, antibacterial, anti- inflammatory, tissue regeneration

On Nov 21, 2016, the European Medicines Agency (EMA) hosted a workshop to discuss its draft guideline on qualification and reporting of physiologically based pharmacokinetic (PBPK) analysis.1 Published on July 21, 2016, the draft PBPK guideline is currently under the period of public comments.