Explore the vast range of titles available.

One-dimensional ZnMn2O4 nanowires have been prepared and investigated as anode materials in Li rechargeable batteries. The highly crystalline ZnMn2O4 nanowires about 15 nm in width and 500 nm in length showed a high specific capacity of about 650 mAh.g-1 at a current rate of 100 mA.g-1 after 40 cycles. They also exhibited high power capability at elevated current rates, i.e., 450 and 350 mAh.g 1 at current rates of 500 and 1000 mA.g 1, respectively. Formation of Mn3O4 and ZnO phases was identified by ex situ X-ray diffraction （XRD） and transmission electron microscopy （TEM） studies after the initial discharge-charge cycle, which indicates that the ZnMn2O4 phase was converted to a nanocomposite of Mn3O4 and ZnO phases immediately after the electrochemical conversion reaction.

The morphology and electronic structure of a Li4Ti5012 anode are known to determine its electrical and electrochemical properties in lithium rechargeable batteries. Ag-Li4Ti5012 nanofibers have been rationally designed and synthesized by an electrospinning technique to meet the requirements of one-dimensional （1D） morphology and superior electrical conductivity. Herein, we have found that the 1D Ag-Li4Ti5012 nanofibers show enhanced specific capacity, rate capability, and cycling stability compared to bare Li4Ti5012 nanofibers, due to the Ag nanoparticles （〈5 nm）, which are mainly distributed at interfaces between Li4Ti5O12 primary particles. This structural morphology gives rise to 20% higher rate capability than bare Li4Ti5O12 nanofibers by facilitating the charge transfer kinetics. Our findings provide an effective way to improve the electrochemical performance of Li4Ti5O12 anodes for lithium rechargeable batteries.

The amount of spent rechargeable lithium batteries (RLBs) is growing rapidly owing to wide application of these batteries in portable electronic devices and electric vehicles, which obliges that spent RLBs should be handled properly. Identification of spent RLBs can supply fundamental information for spent RLBs recycling. This study aimed to determine the differences of physical components and chemical compositions among various spent RLBs. All the samplings of RLBs were rigorously dismantled and measured by an inductive coupled plasma atomic emission spectrometer. The results indicate that the average of total weight of the separator, the anode and the cathode accounted for over 60% of all the RLBs. The weight ratio of valuable metals ranged from 26% to 76%, and approximately 20% of total weight was Cu and Al. Moreover, no significant differences were found among different manufacturers, applications, and electrolyte types. And regarding portable electronic devices, there is also no significant difference in the Co-Li concentration ratios in the leaching liquid of RLBs.

Through in situ redox deposition and growth of MnO2 nanostructures on hierarchically porous carbon （HPC）, a MnOR/HPC hybrid has been synthesized and employed as cathode catalyst for non-aqueous Li-O2 batteries. Owing to the mild synthetic conditions, MnO2 was uniformly distributed on the surface of the carbon support, without destroying the hierarchical porous nanostructure. As a result, the as-prepared MnO2/HPC nanocomposite exhibits excellent Li-O2 battery performance, including low charge overpotential, good rate capacity and long cycle stability up to 300 cycles with controlling capacity of 1,000 mAh·g^-1. A combination of the multi-scale porous network of the shell-connected carbon support and the highly dispersed MnO2 nanostructure benefits the transportation of ions, oxygen and electrons and contributes to the excellent electrode performance.