Explore the vast range of titles available.

Description of risks associated with (a) the technical installations above ground at the well site, (b) the transport of environmentally hazardous substances on roads and in pipelines, and (c) the technical design of the wellbore that can arise during specified normal operation and any deviations therefrom (accident). The assessment is based on a worst-case scenario approach that allows for definition of the measures necessary to avoid accidents and limit their consequences, in accordance with the state-of-the-art requirements [Best available technology (BAT)]. The measures, thus, defined were then compared with given technical and organizational preventive measures for a typical installation, and the completeness and suitability of these measures were evaluated. The investigation is based on information and documentation that were provided by ExxonMobil Production Deutschland GmbH on selected drilling sites, as well as on the literature. Simulations were run for eight main scenarios and 28 subsidiary scenarios. The state-of-the-art (BAT) and good management practice were defined for measures aimed at preventing drilling site incidents and limiting their effects, and were then compared with and assessed in light of standard practices. The said comparison then formed the basis for the formulation of recommendations aimed at improving protection of the population and environment. The main recommendation is that hydrofracking operations should be conducted in accordance with prevailing chemical industry standards, even if adherence to these requirements is not prescribed by law. This especially pertains to requirements concerning the following: the manner in which substances that are hazardous to water are handled; pipeline requirements for natural gas, backflow water and formation water transport; and instituting modern cultures of safety, including providing information concerning risks and the elaboration of risk management action plans. Recommendations were also made as regards well integrity testing, in view of the mission critical nature of this matter and the need for integrated risk communication.

The article discusses the problems of the development of technological regulation of objects that have a negative impact on the environment in urban planning in the Russian Federation. On the one hand, the measures taken in this area are aimed at improving the regulation system in the field of environmental protection in general and reducing the technogenic load on the Russian regions, and on the other, at increasing the efficiency and competitive ability of Russian enterprises.

This study presents a procedure, called EICS (Enterprise IPPC Compatibility Study) aimed at evaluating, by means of the calculation of three indexes, the compliance of the processes performed in an industrial plant with the guidelines provided by BREFs (BAT References) Documents. In fact, according to European Directive 2010/75/EU (concerning the Integrated Pollution Prevention and Control and repealing European Directive 2008/01/EC), industrial plants must require authorizations to the competent authority stating the conformity of their activity, in order to obtain this conformity they are advised to Best Available Technologies (BAT). The aim of the BATs is to avoid or minimize the impact of an industrial activity on the environment through the prevention of the atmospheric emissions, wastewater discharge and energetic consumption, and the correct waste management thus improving the efficiency of the plant. The procedure shown in the present paper has been tested on several types of industrial plant (cement plants, secondary smelt foundries, paper-mill, and automotive industries as regards their paint lines). In this paper, the application of EICS method to a cement plant is presented: the obtained results highlight a good correlation between the index values and the real situation of the plant.

Economic evaluations of alternative electric generating technologies typically rely on comparisons between their expected “levelized cost” per MWh supplied. I demonstrate that this metric is inappropriate for comparing intermittent generating technologies like wind and solar with dispatchable generating technologies like nuclear, gas combined cycle, and coal. It overvalues intermittent generating technologies compared to dispatchable base load generating technologies. It also likely overvalues wind generating technologies compared to solar generating technologies. Integrating differences in production profiles, the associated variations in wholesale market prices of electricity, and life-cycle costs associated with different generating technologies is necessary to provide meaningful comparisons between them.

The first part of this investigation studied complex nature of chemical oxygen demand (COD ) parameter on local and overall effluents, which were obtained from two pulp and paper mills, located in the Northwest region of Russia. Contribution of individual compounds and fractions of matters having different chemical nature to COD for these effluents was established. The second part of this study shows that, qualitative and quantitative characteristics of priority pollutants and their contribution to COD for different pulp and paper mills are not the same, though these mills use similar technologies and produce similar products.

Grounded in the technology-organization-environment (TOE) framework, we develop a research model for assessing the value of e-business at the firm level. Based on this framework, we formulate six hypotheses and identify six factors (technology readiness, firm size, global scope, financial resources, competition intensity, and regulatory environment) that may affect value creation of e-business. Survey data from 612 firms across 10 countries in the financial services industry were collected and used to test the theoretical model. To examine how e-business value is influenced by economic environments, we compare two subsamples from developed and developing countries. Based on structural equation modeling, our empirical analysis demonstrates several key findings: (1) Within the TOE framework, technology readiness emerges as the strongest factor for e-business value, while financial resources, global scope, and regulatory environment also significantly contribute to e-business value. (2) Firm size is negatively related to e-business value, suggesting that structural inertia associated with large firms tends to retard e-business value. (3) Competitive pressure often drives firms to adopt e-business, but e-business value is associated more with internal organizational resources (e.g., technological readiness) than with external pressure to adopt. (4) While financial resources are an important factor in developing countries, technological capabilities become far more important in developed countries. This suggests that as firms move into deeper stages of e-business transformation, the key determinant of e-business value shifts from monetary spending to higher dimensions of organizational capabilities. (5) Government regulation plays a much more important role in developing countries than in developed countries. These findings indicate the usefulness of the proposed research model and theoretical framework for studying e-business value. They also provide insights for both business managers and policy-makers.

Background With the increasing global population and increasing demand for food, the generation of food waste and animal manure increases. Anaerobic digestion is one of the best available technologies for food waste and pig manure management by producing methane-rich biogas. Dry co-digestion of food waste and pig manure can significantly reduce the reactor volume, capital cost, heating energy consumption and the cost of digestate liquid management. It is advantageous over mono-digestion of food waste or pig manure due to the balanced carbon/nitrogen ratio, high pH buffering capacity, and provision of trace elements. However, few studies have been carried out to study the roles of and interactions among microbes in dry anaerobic co-digestion systems. Therefore, this study aimed to assess the effects of different inocula (finished digestate and anaerobic sludge taken from wastewater treatment plants) and substrate compositions (food waste to pig manure ratios of 50:50 and 75:25 in terms of volatile solids) on the microbial community structure in food waste and pig manure dry co-digestion systems, and to examine the possible roles of the previously poorly described bacteria and the interactions among dry co-digestion-associated microbes. Results The dry co-digestion experiment lasted for 120 days. The microbial profile during different anaerobic digestion stages was explored using high-throughput 16S rRNA gene amplicon sequencing. It was found that the inoculum factor was more significant in determining the microbial community structure than the substrate composition factor. Significant correlation was observed between the relative abundance of specific microbial taxa and digesters’ physicochemical parameters. Hydrogenotrophic methanogens dominated in dry co-digestion systems. Conclusions The possible roles of specific microbial taxa were explored by correlation analysis, which were consistent with the literature. Based on this, the anaerobic digestion-associated roles of 11 bacteria, which were previously poorly understood, were estimated here for the first time. The inoculum played a more important role in determining the microbial community structure than substrate composition in dry co-digestion systems. Hydrogenotrophic methanogenesis was a significant methane production pathway in dry co-digestion systems.

As the assessment of the economic, environmental, institutional, and social sustainability of wastewater treatment systems may have several conceivable goals and intended recipients, there are numerous different approaches. This paper surveys certain aspects of sustainability assessment that may be of interest to the planners of wastewater treatment systems. Here, the key criteria assess the system’s costs and financing, including its affordability for the users, the environmental impact, the benefits for health and hygiene, the cultural acceptance of the system and its recycled products, the technical functioning, and the administrative, political, and legal framework for its construction and operation. A multi-criteria approach may then be used to analyze possible trade-offs and identify the most suitable system for a certain location.

Informal recycling of waste (including e-waste) is an emerging source of environmental pollution in India. Polychlorinated biphenyls (PCBs), polychlorinated diphenyl ethers (PBDEs), and heavy metals, among other substances, are a major health concern for workers engaged in waste disposal and processing, and for residents living near these facilities, and are also a detriment to the natural environment. The main objective of this review article was to evaluate the status of these impacts. The review found that, huge quantity of e-waste/waste generated, only a small amount is treated formally; the remainder is processed through the informal sector. We also evaluated the exposure pathways, both direct and indirect, and the human body load markers (e.g., serum, blood, breast milk, urine, and hair), and assessed the evidence for the association between these markers and e-waste exposure. Our results indicated that the open dumping and informal e-waste recycling systems should be replaced by the best available technology and environmental practices, with proper monitoring and regular awareness programs for workers and residents. Further and more detailed investigation in this area is also recommended.

Perfluorooctanoic acid (PFOA) and perfluorooctane sulfonic acid (PFOS) are receiving global attention due to their persistence in the environment through wastewater effluent discharges and past improper industrial waste disposal. They are resistant to biological degradation and if present in wastewater are discharged into the environment. The US Environmental Protection Agency (USEPA) issued drinking water Health Advisories for PFOA and PFOS at 70 ng/L each and for the sum of the two. The need for an enforceable primary drinking water regulation under the Safe Drinking Water Act (SDWA) is currently being assessed. The USEPA faces stringent legal constraints and technical barriers to develop a primary drinking water regulation for PFOA and PFOS. This review synthesizes current knowledge providing a publicly available, comprehensive point of reference for researchers, water utilities, industry, and regulatory agencies to better understand and address cross-cutting issues associated with regulation of PFOA and PFOS contamination of drinking water.