Explore the vast range of titles available.

Stable aluminosilicate zeolites with extra-large pores that are open through rings of more than 12 tetrahedra could be used to process molecules larger than those currently manageable in zeolite materials. However, until very recently 1 – 3 , they proved elusive. In analogy to the interlayer expansion of layered zeolite precursors 4 , 5 , we report a strategy that yields thermally and hydrothermally stable silicates by expansion of a one-dimensional silicate chain with an intercalated silylating agent that separates and connects the chains. As a result, zeolites with extra-large pores delimited by 20, 16 and 16 Si tetrahedra along the three crystallographic directions are obtained. The as-made interchain-expanded zeolite contains dangling Si–CH 3 groups that, by calcination, connect to each other, resulting in a true, fully connected (except possible defects) three-dimensional zeolite framework with a very low density. Additionally, it features triple four-ring units not seen before in any type of zeolite. The silicate expansion–condensation approach we report may be amenable to further extra-large-pore zeolite formation. Ti can be introduced in this zeolite, leading to a catalyst that is active in liquid-phase alkene oxidations involving bulky molecules, which shows promise in the industrially relevant clean production of propylene oxide using cumene hydroperoxide as an oxidant. We report a strategy that yields thermally and hydrothermally stable silicates by expansion of a one-dimensional silicate chain with an intercalated silylating agent that separates and connects the chains.

The consumption of acetophenone (AP) is increasing worldwide because of its applications in products such as alcohol, aldehydes, resins, esters, fragrances, and pharmaceuticals. AP is manufactured via several methods like decomposition of cumene hydroperoxide, Hock process, and Friedel–Crafts acylation reaction using homogeneous catalysts with solvent and oxidant. However, it causes several environmental problems that deteriorate the production of AP with these methods. Oxidation of ethylbenzene (EB) is one of the promising methods to synthesize AP in liquid and vapor phases reaction using heterogeneous catalysts, which plays a vital role for selective production of AP. In this review, numerous heterogeneous catalysts are discussed including transition metal nanoparticles, transition metal complexes, and metal free catalysts (carbon nanotubes) used in last 10 years for oxidation of EB. Additionally, catalyst activity along with reaction parameters and its effect, mechanisms, and kinetics study are summarized in this article. The future scope of this reaction is also highlighted. Moreover, this work identifies best catalysts for bulk production of AP with high yield to satisfy global requirement. Graphic Abstract

Curcumin has many pharmaceutical applications, many of which arise from its potent antioxidant properties. The present research examined the antioxidant activities of curcumin in polar solvents by a comparative study using ESR, reduction of ferric iron in aqueous medium and intracellular ROS/toxicity assays. ESR data indicated that the steric hindrance among adjacent big size groups within a galvinoxyl molecule limited the curcumin to scavenge galvinoxyl radicals effectively, while curcumin showed a powerful capacity for scavenging intracellular smaller oxidative molecules such as H₂O₂, HO•, ROO•. Cell viability and ROS assays demonstrated that curcumin was able to penetrate into the polar medium inside the cells and to protect them against the highly toxic and lethal effects of cumene hydroperoxide. Curcumin also showed good electron-transfer capability, with greater activity than trolox in aqueous solution. Curcumin can readily transfer electron or easily donate H-atom from two phenolic sites to scavenge free radicals. The excellent electron transfer capability of curcumin is because of its unique structure and different functional groups, including a β-diketone and several π electrons that have the capacity to conjugate between two phenyl rings. Therfore, since curcumin is inherently a lipophilic compound, because of its superb intracellular ROS scavenging activity, it can be used as an effective antioxidant for ROS protection within the polar cytoplasm.

Oxidative stress has been shown to induce cell death in a wide range of human diseases including cardiac ischemia/reperfusion injury, drug induced cardiotoxicity, and heart failure. However, the mechanism of cell death induced by oxidative stress remains incompletely understood. Here we provide new evidence that oxidative stress primarily induces ferroptosis, but not apoptosis, necroptosis, or mitochondria-mediated necrosis, in cardiomyocytes. Intriguingly, oxidative stress induced by organic oxidants such as tert-butyl hydroperoxide (tBHP) and cumene hydroperoxide (CHP), but not hydrogen peroxide (H 2 O 2 ), promoted glutathione depletion and glutathione peroxidase 4 (GPX4) degradation in cardiomyocytes, leading to increased lipid peroxidation. Moreover, elevated oxidative stress is also linked to labile iron overload through downregulation of the transcription suppressor BTB and CNC homology 1 (Bach1), upregulation of heme oxygenase 1 (HO-1) expression, and enhanced iron release via heme degradation. Strikingly, oxidative stress also promoted HO-1 translocation to mitochondria, leading to mitochondrial iron overload and lipid reactive oxygen species (ROS) accumulation. Targeted inhibition of mitochondrial iron overload or ROS accumulation, by overexpressing mitochondrial ferritin (FTMT) or mitochondrial catalase (mCAT), respectively, markedly inhibited oxidative stress-induced ferroptosis. The levels of mitochondrial iron and lipid peroxides were also markedly increased in cardiomyocytes subjected to simulated ischemia and reperfusion (sI/R) or the chemotherapeutic agent doxorubicin (DOX). Overexpressing FTMT or mCAT effectively prevented cardiomyocyte death induced by sI/R or DOX. Taken together, oxidative stress induced by organic oxidants but not H 2 O 2 primarily triggers ferroptotic cell death in cardiomyocyte through GPX4 and Bach1/HO-1 dependent mechanisms. Our results also reveal mitochondrial iron overload via HO-1 mitochondrial translocation as a key mechanism as well as a potential molecular target for oxidative stress-induced ferroptosis in cardiomyocytes.

Pseudomonas aeruginosa PAO1 contains gshA and gshB genes, which encode enzymes involved in glutathione (GSH) biosynthesis. Challenging P. aeruginosa with hydrogen peroxide, cumene hydroperoxide, and t-butyl hydroperoxide increased the expression of gshA and gshB. The physiological roles of these genes in P. aeruginosa oxidative stress, bacterial virulence, and biofilm formation were examined using P. aeruginosa ΔgshA, ΔgshB, and double ΔgshAΔgshB mutant strains. These mutants exhibited significantly increased susceptibility to methyl viologen, thiol-depleting agent, and methylglyoxal compared to PAO1. Expression of functional gshA, gshB or exogenous supplementation with GSH complemented these phenotypes, which indicates that the observed mutant phenotypes arose from their inability to produce GSH. Virulence assays using a Drosophila melanogaster model revealed that the ΔgshA, ΔgshB and double ΔgshAΔgshB mutants exhibited attenuated virulence phenotypes. An analysis of virulence factors, including pyocyanin, pyoverdine, and cell motility (swimming and twitching), showed that these levels were reduced in these gsh mutants compared to PAO1. In contrast, biofilm formation increased in mutants. These data indicate that the GSH product and the genes responsible for GSH synthesis play multiple crucial roles in oxidative stress protection, bacterial virulence and biofilm formation in P. aeruginosa.

Aim of the study was to assess the suitability of the combined use of microwave radiation and sodium cumene sulfonate under optimized process conditions for the preparation of maize stillage biomass as a raw material for the production of cellulosic ethanol. The key parameter guaranteeing a high level of lignin removal from biomass (ca. 44%) was concentration of hydrotrope. Even at high biomass concentration (16% w/v) and a cellulase enzyme dose of about 4 filter-paper units/g, maize stillage biomass subjected to microwave-assisted hydrotropic pretreatment was highly susceptible to enzymatic degradation, which resulted in 80% hydrolysis yield. It is possible to obtain a fermentation medium with a very high glucose concentration (up to 80 g/L), without fermentation inhibitors and, as a consequence, to reach a very high level of sugar conversion to ethanol (concentration above 40 g/L), even as much as 95% of theoretical yield. Microwave hydrotropic treatment with sodium cumene sulfonate is a very effective way to prepare waste maize stillage biomass for the production of cellulosic ethanol. The degradation of the lignocellulose structure by the simultaneous use of microwaves and hydrotropes ensured a high degree of conversion of structural polysaccharides to bioethanol. The method provides a high level of enzymatic degradation of cellulose, leading to a medium with high content of released sugars suitable for bioconversion, which is in line with assumptions of the second-generation ethanol production technology.Key points• Microwave-assisted hydrotropic pretreatment is a new way to cellulosic ethanol production.• Microwave-assisted hydrotropic delignification removes 44% of lignin from biomass.• No fermentation inhibitors are obtained after microwave-assisted hydrotropic pretreatment.• High ethanol concentration (above 40 g/L) and fermentation yield (95% of theoretical yield) from biomass after microwave-assisted hydrotropic pretreatment.

This paper demonstrates that OH radicals are formed by photolysis of secondary organic aerosol (SOA) material formed by terpene ozonolysis. The SOA is collected on filters, dissolved in water containing a radical trap (benzoic acid), and then exposed to ultraviolet light in a photochemical reactor. The OH formation rates, which are similar for both α-pinene and limonene SOA, are measured from the formation rate of p-hydroxybenzoic acid as measured using offline HPLC analysis. To evaluate whether the OH is formed by photolysis of H2O2 or organic hydroperoxides (ROOH), the peroxide content of the SOA was measured using the horseradish peroxidase-dichlorofluorescein (HRP-DCF) assay, which was calibrated using H2O2. The OH formation rates from SOA are 5 times faster than from the photolysis of H2O2 solutions whose concentrations correspond to the peroxide content of the SOA solutions, assuming that the HRP-DCF signal arises from H2O2 alone. The higher rates of OH formation from SOA are likely due to ROOH photolysis, but we cannot rule out a contribution from secondary processes as well. This result is substantiated by photolysis experiments conducted with t-butyl hydroperoxide and cumene hydroperoxide which produce over 3 times more OH than photolysis of equivalent concentrations of H2O2. Relative to the peroxide level in the SOA and assuming that the peroxides drive most of the ultraviolet absorption, the quantum yield for OH generation from α-pinene SOA is 0.8 ± 0.4. This is the first demonstration of an efficient photolytic source of OH in SOA, one that may affect both cloud water and aerosol chemistry.

Medicinal herbs are nature’s gift to humanity, contributing crucially to the preservation, maintenance and improvement of our health. In order to explore the hepatoprotective potential of prevalent medicinal plants, nine species were selected from different genera based on their ethnomedicinal records in treating different liver-related pathological conditions in South Asia. Besides, the available information was critically analyzed to gain new insights and directions for future investigations towards establishing such natural products as potent hepatoprotective agents or dietary supplements. The hepatoprotective activities of the species have been investigated in a wide variety of in vivo experimental models including carbon tetrachloride-, paracetamol-, iron-, mercuric chloride-, thioacetamide-, cyclophosphamide-, β- d -galactosamine-, cumene hydroperoxide-, α-naphthyl-isothiocyanate-, physical stress- and alcohol-induced hepatotoxicity in rats and mice. All the plants were consistent in their ability to possess hepatoprotective properties. As well, three bioactive isolates namely, schaftoside, echinocystic acid, and eclalbasaponin II were found to have promising hepatoprotective potential. However, extensive comparative studies are warranted in future to establish the relative hepatoprotective potentials of the nine species under discussion. Preparation of poly-herbal formulations from these plants and identification of hepatoprotective phytoconstituents from these plants might open up new avenues in the development of therapeutic hepatoprotective agents.

The kinetics of cumene oxidation in the presence of Mg, Ca, Sr, Ba 2-ethylhexanoates is studied experimentally. It is established that the Mg 2-ethylhexanoate exhibits the highest catalytic performance. It is shown by the PBEPBE-GD3/def2TZVP method that the intermediate adducts of cumene, cumene hydroperoxide ( gauche- and trans- conformers), and dimethyl phenyl carbinol with Mg 2-ethylhexanoate are thermodynamically possible. The data on the structure of intermediate adducts and electron density distribution were obtained by conducting PBEPBE-GD3/def2TZVP quantum chemical calculations. The totality of structural data, energy parameters of the adducts, nature of the electron density distribution, and the strength of the O–O bond show that the intermediate adduct of cumene hydroperoxide ( trans- conformer) with Mg 2-ethylhexanoate most rapidly decomposes into free radicals. A mechanism of catalytic activity of Mg 2-ethylhexanoate in cumene oxidation is proposed based on the results of quantum chemical simulation.

Molecules with hydroperoxide functional groups are of extreme importance to both the atmospheric and biological chemistry fields. In this work, an analytical method is presented for the identification of organic hydroperoxides and peroxy acids (ROOH) by direct infusion of liquid samples into a positive-ion atmospheric pressure chemical ionization–tandem mass spectrometer ((+)-APCI-MS/MS). Under collisional dissociation conditions, a characteristic neutral loss of 51 Da (arising from loss of H2O2+NH3) from ammonium adducts of the molecular ions ([M + NH4]+) is observed for ROOH standards (i.e. cumene hydroperoxide, isoprene-4-hydroxy-3-hydroperoxide (ISOPOOH), tert-butyl hydroperoxide, 2-butanone peroxide and peracetic acid), as well as the ROOH formed from the reactions of H2O2 with aldehydes (i.e. acetaldehyde, hexanal, glyoxal and methylglyoxal). This new ROOH detection method was applied to methanol extracts of secondary organic aerosol (SOA) material generated from ozonolysis of α-pinene, indicating a number of ROOH molecules in the SOA material. While the full-scan mass spectrum of SOA demonstrates the presence of monomers (m∕z = 80–250), dimers (m∕z = 250–450) and trimers (m∕z = 450–600), the neutral loss scan shows that the ROOH products all have masses less than 300 Da, indicating that ROOH molecules may not contribute significantly to the SOA oligomeric content. We anticipate this method could also be applied to biological systems with considerable value.