Explore the vast range of titles available.

One of the main factors of the increased eutrophication level of surface waters is the high anthropogenic loads of biogenic substances discharged into water bodies. Municipal wastewaters, containing large amounts of nitrogen and phosphorus play one of the key roles in the acceleration of eutrophication intensity. The main direction in the prevention of eutrophication caused by wastewater discharge has become the reduction of nutrient loads introduced to wastewater receivers in accordance with strict legal requirements achievable only in advanced technologies. The treated wastewater quality standards are actually developed for total nitrogen and total phosphorus content, disregarding the fact that eutrophication potential of treated wastewater is determined by the content of non-organic nutrient forms directly bioavailable for water vegetation. That is why the currently used energy-consuming and expensive technologies do not always guarantee effective protection against eutrophication and its consequences. The goal of the study was to analyze the most widely used wastewater treatment technologies for enhanced biological nutrients removal in treated wastewater eutrophication potential. For this purpose, an analysis of the operation of 18 wastewater treatment plants based on different technologies in Finland, Canada, Poland, Russia and the United States was realized. The analysis concluded that the eutrophication potential of treated wastewater to a large extent is conditioned by the applied technology. The results of the research concluded that the eutrophication potential can serve an important criterion for decision-making regarding the proper selection of wastewater treatment technologies aimed at eutrophication mitigation.

Municipal wastewater treatment plants (WWTPs) have been identified as a key source of microplastics (MPs) release into rivers and oceans. Varied extents of MPs pollution have been observed at different WWTPs with limited information in Thailand. This research aimed to study the occurrence of MPs in municipal WWTPs in Thailand by measuring MPs of three WWTPs which employ different treatment process. The WWTPs were selected to represent MP pollution from urbanized and suburbanized areas with different treatment set-ups, i.e., sequence batch reactor (WWTP-A), oxidation ditch (WWTP-B), and conventional activated sludge (WWTP-C). Water and sludge sampling was performed at the inlet and outlet of primary and secondary treatment units. The results indicate that the average MPs removal efficiency of the WWTPs was ca. 84%, with the aeration tank as the main removal unit by transferring MPs from the water phase to sludge. Primary treatment comprising of screening and grit chambers could not remove MPs effectively. Most of the MPs observed in the WWTPs were fibers (32–57%), mostly made of polyester, polyethylene, polyacrylate, and polypropylene. From these results, it is suggested to implement tertiary treatment options to improve MPs removal efficiency in WWTPs, and to apply post-treatment to the WWTPs’ raw sludge to prevent the MPs’ release into the environment when the sludge is applied to agricultural land.

Population growth and water scarcity necessitate alternative agriculture practices, such as reusing wastewater for irrigation. Domestic wastewater has been used for irrigation for centuries in many historically low-income and arid countries and is becoming more widely used by high-income countries to augment water resources in an increasingly dry climate. Wastewater treatment processes are not fully effective in removing all contaminants, such as antimicrobial resistant bacteria (ARB) and antimicrobial resistance genes (ARGs). Literature reviews on the impact of wastewater irrigation on antimicrobial resistance (AMR) in the environment have been inconclusive and mostly focused on treated wastewater. We conducted the first systematic review to assess the impact of irrigation with both treated or untreated domestic wastewater on ARB and ARGs in soil and adjacent water bodies. We screened titles/abstracts of 3002 articles, out of which 41 were screened in full text and 26 were included in this review. Of these, thirteen investigated irrigation with untreated wastewater, and nine found a positive association with ARB/ARGs in soil. Out of thirteen studies focused on treated wastewater, six found a positive association with ARB/ARGs while six found mixed/negative associations. Our findings demonstrate that irrigation with untreated wastewater increases AMR in soil and call for precautionary action by field workers, their families, and consumers when untreated wastewater is used to irrigate crops. The effect of irrigation with treated wastewater was more variable among the studies included in our review, highlighting the need to better understand to what extent AMR is disseminated through this practice. Future research should assess factors that modify the effect of wastewater irrigation on AMR in soil, such as the degree and type of wastewater treatment, and the duration and intensity of irrigation, to inform guidelines on the reuse of wastewater for irrigation.

Municipal wastewater treatment plants (MWWTPs) are considered to reduce the amount of pollutants that enter water reservoirs as a result of wastewater disposal. An assessment of the occurrence and removal of pharmaceutical compounds, mainly nonsteroidal anti-inflammatory drugs (NSAIDs), in wastewater from the Kavoor MWWTP (southwest monsoon region), India, is presented in this paper. The performance of the MWWTP was monitored in the summer (May) and monsoon (September) periods. The highest inlet concentrations of diclofenac, naproxen, ibuprofen, ketoprofen, and acetylsalicylic acid in the wastewater were observed in May and were 721.37, 2132.48, 2109.875, 2747.29, and 2213.36 μg/L, respectively. The ketoprofen content was found to be higher than that of other NSAIDs in the influent in both seasons, whereas the diclofenac content was found to be the lowest. The removal efficiency (RE) of the target NSAIDs in the Kavoor secondary treatment plant varied from 81.82–98.92% during the summer season. During the monsoon season, the influent NSAID concentration level dropped, probably because of infiltration in old sewer pipes. In addition, a 100% RE was achieved for all the target NSAIDs in the wastewater of the MWWTP. The results showed that secondary treatment plants have the potential to remove NSAID compounds from municipal sewage with consistent performance. The environmental hazards caused by the accumulation of such compounds in water reservoirs are due to open discharge. The environmental risk levels of these compounds were also studied by the environmental risk assessment (ERA) using the European Agency for Evaluation of Medicines approach.

Production of polyhydroxyalkanoate (PHA) biopolymers by mixed microbial cultures concurrent to wastewater treatment is a valorization route for residual organic material. This development has been at pilot scale since 2011 using industrial and municipal organic residuals. Previous experience was the basis for a PHA production demonstration project: PHARIO. PHARIO was centred on processing surplus activated sludge biomass from the Bath full-scale municipal wastewater treatment plant in the Netherlands to produce PHA. Full-scale surplus activated sludge was fed to a pilot facility to produce PHA rich biomass using fermented volatile fatty acid (VFA) rich liquors from industry or primary sludge sources. A PHA rich biomass with on average 0.41 gPHA/gVSS was obtained with reproducible thermal properties and high thermal stability. A routine kilogram scale production was established over 10 months and the polymer material properties and market potential were evaluated. Surplus full-scale activated sludge, over four seasons of operations, was a reliable raw material to consistently and predictably produce commercial quality grades of PHA. Polymer type and properties were systematic functions of the mean co-polymer content. The mean co-polymer content was predictably determined by the fermented feedstock composition. PHARIO polymers were estimated to have a significantly lower environmental impact compared to currently available (bio)plastics.

Wastewater reuse as a sustainable, reliable and energy recovery concept is a promising approach to alleviate worldwide water scarcity. However, the water reuse market needs to be developed with long-term efforts because only less than 4% of the total wastewater worldwide has been treated for water reuse at present. In addition, the reclaimed water should fulfill the criteria of health safety, appearance, environmental acceptance and economic feasibility based on their local water reuse guidelines. Moreover, municipal wastewater as an alternative water resource for non-potable or potable reuse, has been widely treated by various membrane-based treatment processes for reuse applications. By collecting lab-scale and pilot-scale reuse cases as much as possible, this review aims to provide a comprehensive summary of the membrane-based treatment processes, mainly focused on the hydraulic filtration performance, contaminants removal capacity, reuse purpose, fouling resistance potential, resource recovery and energy consumption. The advances and limitations of different membrane-based processes alone or coupled with other possible processes such as disinfection processes and advanced oxidation processes, are also highlighted. Challenges still facing membrane-based technologies for water reuse applications, including institutional barriers, financial allocation and public perception, are stated as areas in need of further research and development.

The management of municipal wastewater sludge is a significant challenge for wastewater management, particularly the need to manage and dispose of the sludge in an environmentally friendly and sustainable manner. The emergence of stricter regulations regarding landfill disposal of wastewater sludge necessitates the need for alternative options for municipal wastewater sludge management, with thermochemical technologies potentially contributing towards achieving carbon neutrality goals and fostering sustainable development. This study sought to address these challenges through a technical and financial evaluation of a pilot-scale emerging thermochemical technology, the enhanced hydrothermal polymerization to provide adequate understanding of the technology's feasibility regarding its application for municipal wastewater sludge volarization into a multi-use hydrochar. The study findings indicated that the enhanced hydrothermal polymerization-generated hydrochar exhibited significant energy content compared to wastewater sludge, suggesting the potential use of the hydrochar as an energy source. The preliminary designs of a full-scale greenfield installation and retrofit processing 50 t/d and 35 t/d dry sludge, respectively, were evaluated to be technically feasible. Furthermore, on the basis of preliminary designs, the enhanced hydrothermal polymerization technology was determined to be the most financially feasible option, also offering other unique advantages over well-established technologies currently used within municipal wastewater services.

This study aimed to assess the potential risks posed by heavy metals in sewage sludge (SS) produced by municipal wastewater treatment plants (WWTPs) in the most industrialized region in Poland, the Silesian Voivodeship. The ecological risk was assessed using three indices: the Geoaccumulation Index ( I geo ), Potential Ecological Risk Factor (ER), and Risk Assessment Code (RAC), while the health risk was estimated by using carcinogenic and non-carcinogenic risk indices. The average concentrations of metals in the sludge samples were determined revealing that Zn was the predominant element, whereas Cd and Hg were present in the lowest concentrations. The study showed that the processes used in wastewater treatment plants influenced the overall metal content and chemical speciation. According to I geo values, the dewatered sludge samples exhibited higher contamination levels of Cd and Zn, while Cu and Pb were upon to a lesser extent. The ER values suggest that Cd and Hg present the highest ecological risk. Considering the chemical forms and RAC values, Ni (26.8–37.2%) and Zn (19.8–27.0%) were identified to cause the most significant risks. The non-carcinogenic risk for adults and children was below acceptable levels. However, the carcinogenic risk associated with Ni (WWTP1) for both demographic groups and Cr and Cd (WWTP2), specifically for children, exceeded the acceptable threshold. Ingestion was the primary route of exposure. Although the dewatered SS met the standards for agricultural use, there is still a risk of secondary pollution to the environment and possible adverse health effects.

Hydrothermal liquefaction (HTL) of algal biomass is a promising approach for renewable biofuel production. The actual study investigates the effects of reaction temperature (225–325 °C), residence time (15–60 min), algae-to-water mass ratio (1:5–1:20), and pressure on the yield and quality of biofuel derived from municipal wastewater-grown mixed algal-cyanobacterial biomass. Eleven HTL experiments were conducted, and the resulting products were separated into gas, liquid, and solid phases for thermal and chemical analyses. Selected biofuel samples were characterized using gas chromatography–mass spectrometry (GC–MS), elemental analysis, and thermogravimetric analysis (TGA). The biofuels contained complex mixtures of aliphatic hydrocarbons, aromatics, phenolics, carboxylic acids, esters, and nitrogen-containing compounds, classified into biogasoline, bio-jet fuel, biodiesel, and motor oil fractions. Optimal yields of biofuel, gas, and solid residues were 16.86%, 26.14%, and 40.43%, respectively, achieved at a 1:10 algae-to-water ratio, 30 min reaction time, and 250 °C. The biofuel composition comprised 11.37% gasoline, 29.41% kerosene, 9.71% diesel, with a heating value of 42.93 MJ·kg⁻¹. A higher fraction of gasoline, kerosene and diesel-range compounds enhances energy density and combustion stability, while lower oxygen and nitrogen content improves storage and fuel properties. Solid residues exhibited uniform physical properties but were unsuitable for high-grade biochar due to low carbon and high inorganic content. These findings demonstrate that HTL of municipal wastewater-grown microalgae is a viable route for sustainable biofuel production, integrating resource recovery with renewable energy generation, while systematically evaluating key operational parameters and characterizing the resulting biofuel for downstream applications.

We quantified presumptive extended-spectrum β-lactamase-producing Escherichia coli and Klebsiella, Enterobacter, Serratia, and Citrobacter group colonies from wastewater in Basel, Switzerland, across 3 years to represent before, during, and after the COVID-19 pandemic. Wastewater surveillance might be a noninvasive, sensitive, rapid, and cost-effective instrument for early detection and monitoring local epidemiology.