Explore the vast range of titles available.

This article describes a novel approach to the control of a powered knee prosthesis where the control system provides passive behavior for most activities and then provides powered assistance only for those activities that require them. The control approach presented here is based on the categorization of knee joint function during activities into four behaviors: resistive stance behavior, active stance behavior, ballistic swing, and non-ballistic swing. The approach is further premised on the assumption that healthy non-perturbed swing-phase is characterized by a ballistic swing motion, and therefore, a replacement of that function should be similarly ballistic. The control system utilizes a six-state finite-state machine, where each state provides different constitutive behaviors (concomitant with the four aforementioned knee behaviors) which are appropriate for a range of activities. Transitions between states and torque control within states is controlled by user motion, such that the control system provides, to the extent possible, knee torque behavior as a reaction to user motion, including for powered behaviors. The control system is demonstrated on a novel device that provides a sufficiently low impedance to enable a strictly passive ballistic swing-phase, while also providing sufficiently high torque to offer powered stance-phase knee-extension during activities such as step-over stair ascent. Experiments employing the knee and control system on an individual with transfemoral amputation are presented that compare the functionality of the power-supplemented nominally passive system with that of a conventional passive microprocessor-controlled knee prosthesis.

The biological ankle dorsiflexes several degrees during swing to provide adequate clearance between the foot and ground, but conventional energy storage and return (ESR) prosthetic feet remain in their neutral position, increasing the risk of toe scuffs and tripping. We present a new prosthetic ankle intended to reduce fall risk by dorsiflexing the ankle joint during swing, thereby increasing the minimum clearance between the foot and ground. Unlike previous approaches to providing swing dorsiflexion such as powered ankles or hydraulic systems with dissipative yielding in stance, our ankle device features a spring-loaded linkage that adopts a neutral angle during stance, allowing ESR, but adopts a dorsiflexed angle during swing. The ankle unit was designed, fabricated, and assessed in level ground walking trials on a unilateral transtibial prosthesis user to experimentally validate its stance and swing phase behaviors. The assessment consisted of three conditions: the ankle in an operational configuration, the ankle in a locked configuration (unable to dorsiflex), and the subject’s daily use ESR prosthesis. When the ankle was operational, minimum foot clearance (MFC) increased by 13 mm relative to the locked configuration and 15 mm relative to his daily use prosthesis. Stance phase energy return was not significantly impacted in the operational configuration. The increase in MFC provided by the passive dorsiflexing ankle prosthesis may be sufficient to decrease the rate of falls experienced by prosthesis users in the real world.

Standing up using one leg is a challenging task for those with a transfemoral amputation, particularly for elderly users with a low activity level. Active prostheses are generally not accessible to this group and available passive prostheses do not support standing up. This article presents the design and evaluation of the “Energy Restoring Intelligent Knee” (ERiK), which stores energy during sit-down in a pneumatic cylinder and returns it during stand-up. We hypothesized that the system would reduce the time needed to perform transitions and also enable higher load sharing by the prosthetic leg. However, the results of an experimental study with seven participants with transfemoral amputation contradict these hypotheses: the participants could neither move faster nor make more use of the prosthetic leg to share their body weight during transitions. We observed that a major obstacle to the useful functionality of the leg was the absence of ankle dorsiflexion – the foot tended to slip during stand-up initiation, such that only low pre-pressures and therefore support levels could be set. The rather binary action of the pneumatics also complicated movement initiation. The lessons learned from this study may be helpful to those seeking to create better designs in the future.

Osteosarcoma (OS) is a relatively rare tumor of bone with a worldwide incidence of 3.4 cases per million people per year. For most of the twentieth century, five-year survival rates for classic OS were very low. In the 1970s, the introduction of adjuvant chemotherapy in the treatment of OS increased survival rates dramatically. The current article reviews the various types of OS and analyzes the clinical and histological features. We also examine historical and current literature to present a succinct review of methods for diagnosis and staging, as well as treatment, and we also discuss some of the future directions of treatment.