Explore the vast range of titles available.

Heart rate variability (HRV) is frequently applied in sport-specific settings. The rising use of freely accessible applications for its recording requires validation processes to ensure accurate data. It is the aim of this study to compare the HRV data obtained by the Polar H10 sensor chest strap device and an electrocardiogram (ECG) with the focus on RR intervals and short-term scaling exponent alpha 1 of Detrended Fluctuation Analysis (DFA a1) as non-linear metric of HRV analysis. A group of 25 participants performed an exhaustive cycling ramp with measurements of HRV with both recording systems. Average time between heartbeats (RR), heart rate (HR) and DFA a1 were recorded before (PRE), during, and after (POST) the exercise test. High correlations were found for the resting conditions (PRE: r = 0.95, rc = 0.95, ICC3,1 = 0.95, POST: r = 0.86, rc = 0.84, ICC3,1 = 0.85) and for the incremental exercise (r > 0.93, rc > 0.93, ICC3,1 > 0.93). While PRE and POST comparisons revealed no differences, significant bias could be found during the exercise test for all variables (p < 0.001). For RR and HR, bias and limits of agreement (LoA) in the Bland–Altman analysis were minimal (RR: bias of 0.7 to 0.4 ms with LoA of 4.3 to −2.8 ms during low intensity and 1.3 to −0.5 ms during high intensity, HR: bias of −0.1 to −0.2 ms with LoA of 0.3 to −0.5 ms during low intensity and 0.4 to −0.7 ms during high intensity). DFA a1 showed wider bias and LoAs (bias of 0.9 to 8.6% with LoA of 11.6 to −9.9% during low intensity and 58.1 to −40.9% during high intensity). Linear HRV measurements derived from the Polar H10 chest strap device show strong agreement and small bias compared with ECG recordings and can be recommended for practitioners. However, with respect to DFA a1, values in the uncorrelated range and during higher exercise intensities tend to elicit higher bias and wider LoA.

Carbon fiber-reinforced polymer (CFRP) materials have been effectively used as externally bonded sheets to repair damaged steel structures such as airplanes and ships. In this study, a series of double strap joints with different bonding lengths are considered and examined to experimentally and theoretically assess the effective bond length. Various models exist in the literature which are used to predict the strength of steel and CFRP joints under various loading conditions. Non-linear Lagrange stress method (NLS) which is a novel stress-based method for predicting the failure load values is presented for the first time. This approach is based on 2D and 3D linear elastic finite element analysis. Relying only on two experimental tests, the new approach proposed here can quickly and easily predict the failure load in steel/CFRP samples. In this methodology, it is assumed that the adhesive joint will fail as the normal stress along the adhesive mid-line reaches a predetermined value at a critical distance. In addition, experimental data on steel/CFRP joints gathered from the literature are compared to predictions using the NLS method. It was found that results from the theoretical predictions (NLS) were in good agreement with experimental tests conducted on double strap joints. It was also revealed that the average accuracy of the NLS method is superior to other methods such as cohesive zone model and Hart-Smith. The results revealed that under the best conditions, the NLS model is 5 times more accurate than existing models.

Hyperfluorescence shows great promise for the next generation of commercially feasible blue organic light-emitting diodes, for which eliminating the Dexter transfer to terminal emitter triplet states is key to efficiency and stability. Current devices rely on high-gap matrices to prevent Dexter transfer, which unfortunately leads to overly complex devices from a fabrication standpoint. Here we introduce a molecular design where ultranarrowband blue emitters are covalently encapsulated by insulating alkylene straps. Organic light-emitting diodes with simple emissive layers consisting of pristine thermally activated delayed fluorescence hosts doped with encapsulated terminal emitters exhibit negligible external quantum efficiency drops compared with non-doped devices, enabling a maximum external quantum efficiency of 21.5%. To explain the high efficiency in the absence of high-gap matrices, we turn to transient absorption spectroscopy. It is directly observed that Dexter transfer from a pristine thermally activated delayed fluorescence sensitizer host can be substantially reduced by an encapsulated terminal emitter, opening the door to highly efficient ‘matrix-free’ blue hyperfluorescence. Suppressed Dexter transfer is needed to achieve efficient and stable hyperfluorescence, but complex matrices must be involved. A molecular design strategy has been proposed where Dexter transfer can be substantially reduced by an encapsulated terminal emitter, leading to ‘matrix-free’ hyperfluorescence.

The waist belts also carry a small pouch that functions as a percussion cap box and a frog holding a removable leather scabbard for the bayonet, with brass collar and tip. Prominently featured in the photograph, resting on Tweed's knees, is a black canvas knapsack with white stencil marks identifying it to Company F of the 44th M.V.M. Fuller and Osborne have their knapsacks on their shoulders, and all three knapsacks include a wool blanket wrapped with a gum blanket with two straps holding it to the top. From 1869 to 1879, Cyrus studied and practiced law in Boston, but he gave up the law and returned to art after a decade, achieving significant acclaim as a sculptor, while Darius focused more on painting and portraiture.

In order to evaluate the attitude accuracy of the TT&C’s SINS under dynamic condition, a new method of using theodolite’s observation data of fixed star to evaluate SINS’s attitude accuracy based on time-delay compensation is proposed. The detailed design is given, and the influence of the time delay is analyzed based on real data experiments. The data analysis and experimental results shows that the new method can improve the computation accuracy, and it is valuable for engineering application of evaluating SINS’s attitude accuracy under dynamic conditions.

Sports bras have been reported to be a hindrance to the effective workout of females. This study elucidates the pressure distribution in eight different sport bra types of different sizes during shoulder workout activities to address this hindrance. The upper body moves in horizontal, vertical, and circular directions. An observational survey was carried out at the Zhejiang Sci-Tech University gyms, and among 300 females, the majority focused on shoulder workouts. The experiment used pressure sensors to analyze the most significant sports bra for females with a bra size of 34C, 36C, and 38C during three body movements. We conclude the in-depth width of the neckline has an impact on strap comfortability as well as the back design and structure also influence the performance of the back band. Additionally, racerback bras produce less pressure for bra size 34C. In addition, crossing back with thicker and broader straps produces less pressure for females with a bra size of 36C. For bra 38C, a racerback with thicker straps generated less pressure.

Background circular RNAs (circRNAs) have been reported to exert important effects in the progression of numerous cancers. However, the functions of circRNAs in intrahepatic cholangiocarcinoma (ICC) are still unclear. Methods circPCNXL2 (has_circ_0016956) were identified in paired ICC by circRNA microarray. Then, we assessed the biological functions of circPCNXL2 by CCK8, EdU, clone formation, transwell, wound healing assays, and xenograft models. RNA pull-down, mass spectrometry, and RNA immunoprecipitation (RIP) were applied to explore the interaction between cirrcPCNXL2 and serine-threonine kinase receptor-associated protein (STRAP). RNA pull-down, RIP and luciferase reporter assays were used to investigate the sponge functions of circPCNXL2. In the end, we explore the effects of circPCNXL2 and trametinib (a MEK1/2 inhibitor) in vivo. Results circPCNXL2 was upregulated in ICC tissues and cell lines, which promoted the proliferation and metastasis of ICC in vitro and in vivo. In terms of the mechanisms, circPCNXL2 could directly bind to STRAP and induce the interaction between STRAP and MEK1/2, resulting in the tumor promotion in ICC by activation of ERK/MAPK pathways. Besides, circPCNXL2 could regulate the expression of SRSF1 by sponging miR-766-3p and subsequently facilitated the growth of ICC. Finally, circPCNXL2 could partially inhibit the anti-tumor activity of trametinib in vivo. Conclusion circPCNXL2 played a crucial role in the progression of ICC by interacting with STRAP to activate the ERK signaling pathway, as well as by modulating the miR-766-3p/SRSF1 axis. These findings suggest that circPCNXL2 may be a promising biomarker and therapeutic target for ICC.

The main task of the technological process in existing spinning systems in the processing of natural, artificial and synthetic fibers into yarn is to obtain a ribbon, rovings and yarn uniform in structure and properties by folding and drawing. The article studies analytical dependences for calculating the angle of flow around the exhaust cylinder by the lobe on the spinning line of ring spinning machines. Analysis of the results of the experiment allows us to conclude that ensuring a constant clamping of the straps in the exhaust zone reduces the unevenness of the product during stretching.

Exterior beam-column joints are the most vulnerable part of substandard reinforced concrete (RC) buildings and are often the first to be damaged during earthquakes. This article presents an experimental and numerical investigation into the behaviour of exterior RC beam-column joints repaired and strengthened using Post-Tensioned Metal Straps (PTMS) for active confinement. The study focused on full-scale beam-column joints with an inadequate core zone detailing, thus emulating the deficiencies found in existing substandard RC buildings. Initially, four “bare” joints were subjected to cyclic tests to induce substantial damage within the core zone. Subsequently, the damaged core of the joints was repaired and recast with new concrete, and PTMS were applied to strengthen the joints, followed by another round of cyclic testing. The experimental findings were compared with predictions generated through established models from existing literature. The results revealed that ASCE/SEI 41–17 guidelines accurately predict the shear capacity of the bare joints. It is shown that recasting the core with new concrete significantly increased the joint’s shear capacity by up to 42% compared their bare counterparts. The use of PTMS strengthening further enhanced the capacity by up to 25%. A “scissors model” was employed for numerical simulations of both bare and PTMS-strengthened joints using DRAIN-2DX, which proved effective at predicting their nonlinear load-displacement envelope response. This article contributes towards the development of new cost-effective post-earthquake strengthening techniques for beam-column joints, with the potential to reduce the vulnerability of substandard RC buildings in developing countries.

This study reviews the scientific use of chest-strap wearables, analyzing their advantages and limitations, following PRISMA guidelines. Eligible studies assessed chest-strap devices in adults and reported physiological outcomes such as heart rate, heart rate variability, R–R intervals, or electrocardiographic waveform morphology. Studies involving implanted devices, wrist-worn wearables, or lacking validation against reference standards were excluded. Searches were conducted in PubMed, Scopus, Web of Science, and ScienceDirect for studies published in the last 10 years. The quality of the studies was assessed using the Mixed Methods Appraisal Tool, and results were synthesized narratively. Thirty-two studies were included. The most frequently evaluated devices were the Polar H10 and Zephyr BioHarness 3.0, which showed strong correlations with electrocardiography at rest and during light-to-moderate activity. Reported limitations included motion artefacts, poor strap placement, sweating, and degradation of the skin–electrode interface. None of the devices had CE or FDA approval for clinical use, and most studies were conducted in controlled settings, limiting generalizability. Ergonomic concerns such as discomfort during prolonged wear and restricted mobility were also noted. Overall, chest-strap sensors showed good validity and were widely used in validation studies. However, technical refinements and large-scale field trials are needed for broader clinical and occupational application. This review is registered in PROSPERO and is part of the SIREN project.