Explore the vast range of titles available.

A wideband circularly polarized rectangular dielectric resonator antenna (DRA) fed by a single feeding mechanism has been studied theoretically and experimentally. The purpose of the study is to determine how adding a parasitic strip next to the flat surface metallic feed would affect various far- and near-field antenna characteristics. Initially, the basic antenna design, i.e., the T-shape feed known as antenna A, produced a 4.81% impedance matching bandwidth (|S11| −10 dB). Due to the narrow and undesirable results of the initial antenna design, antenna-A was updated to the antenna-B design, i.e., Yagi-Uda. The antenna-B produced a decent result (7.89% S11) as compared to antenna-A but still needed the bandwidth widened, for this, a parasitic patch was introduced next to the Yagi-Uda antenna on the rectangular DRA at an optimized location to further improve the results. This arrangement produced circular polarization (CP) waves spanning a broad bandwidth of 28.21% (3.59–3.44 GHz) and a broad impedance |S11| bandwidth of around 29.74% (3.71–3.62 GHz). These findings show that, in addition to producing CP, parasite patches also cause the return loss to rise by a factor of almost three times when compared to results obtained with the Yagi-Uda-shape feed alone. Computer simulation technology was used for the simulation (CST-2017). The planned antenna geometry prototype was fabricated and measured. Performance indicators show that the suggested antenna is a good fit for 5G applications. The simulated outcomes and measurements match up reasonably.

In this research article, a single-fed dual-band circular polarized (CP) dielectric resonator antenna (DRA) for dual-function communication, such as GPS and WLAN, was made. Initially, the proposed design process was initiated by designing a linearly polarized singly fed-DRA. To attain CP fields, the cross-shape conformal metal strip was optimized to excite the fundamental and the high-order mode in the two frequency bands. The metallic strip (parasitic) was utilized on top of the rectangular DRA to improve and widen the impedance and axial ratio (AR) bandwidth. This step led to a 2.73% improvement on the lower band and an impact of 6.5% on the upper band while on the other side a significant improvement was witnessed in the AR bandwidth in both frequency bands. A prototype was designed and fabricated in order to validate its operations. The measurement outcomes of the proposed antennas authenticated wideband impedance bandwidths of 6.4% and 25.26%, and 3-dB axial ratios (AR) of 21.26% and 27.82% respectively. The prototype is a decent candidate for a global positioning system (GPS) and wireless local area network (WLAN).

This paper describes a singly-fed circularly polarized rectangular dielectric resonator antenna (RDRA) for MIMO and 5G Sub 6 GHz applications. Circular polarization was achieved for both ports using a novel-shaped conformal metal strip. To improve the isolation between the radiators, a “S” shaped defective ground plane structure (DGPS) was used. In order to authenticate the estimated findings, a prototype of the suggested radiator was built and tested experimentally. Over the desired band, i.e., 3.57–4.48 GHz, a fractional impedance bandwidth of roughly 36.63 percent (−10 dB as reference) was reached. Parallel axial ratio bandwidth of 28.33 percent is achieved, which is in conjunction with impedance matching bandwidth. Between the ports, isolation of −28 dB is achieved Gain and other far-field parameters are also calculated and found to be within their optimum limits