Explore the vast range of titles available.

Background To evaluate condylar morphology, ramus height, and asymmetry indexes in patients with different vertical skeletal patterns and to determine the association between condylar and ramal measurements with the mandibular plane angle. Methods Dental panoramic radiographs of 60 patients with different skeletal patterns were evaluated. According to the cranial base (Sella-Nasion)-mandibular plane (SN-MP) angle, the patients were divided into three groups: normal angle (NA), low angle (LA), and high angle (HA). The condylar area, condylar perimeter, condylar heights, and ramus height were measured, and the asymmetry index value of each measurement was calculated. A one-way analysis of variance as well as a post hoc Tukey and Kruskall-Wallis tests were used to determine intergroup differences. Pearson’s correlation coefficient was used to determine the relationship between all measurements and SN-MP. Results The intergroup comparison of condylar area, condylar perimeter, condylar heights, and ramus height measurements showed that the patients in the LA group have statistically significantly greater values compared to those in the HA group. A statistically significant difference was detected between the NA and LA groups only in the condylar area measurements. There was no statistical difference only in the ramus height measurements between the NA and HA groups. Asymmetry index values of the groups were similar. The negative correlations were found between all measurements and the SN-MP angle. Conclusion HA individuals have lower ramus heights and smaller condylar morphologies than NA and LA individuals. In addition, as the SN-MP angle increases, the condyle dimensions and ramus height decrease, and this is a clinically important finding.

Background: In the age of individualised arthroplasty, the question arises whether currently available standard implants adequately consider femoral condylar morphology (FCM). Therefore, physiological reference values of FCM are needed. The aim was to establish physiological reference values for anterior (ACO) and posterior condylar offset (PCO) as well as for the length of the medial (LMC) and lateral femoral condyles (LLC). Methods: The knee joints of 517 patients (mean age: 52.3 years (±16.8)) were analysed retrospectively using MRI images. Medial (med) and lateral (lat) ACO and PCO, as well as LMC and LLC, were measured. All FCM parameters were examined for association with age, gender, side and osteoarthritis. Results: Mean ACOmed was 2.8 mm (±2.5), mean ACOlat was 6.7 mm (±2.3), mean PCOmed was 25.7 mm (±4.6), mean PCOlat was 23.6 mm (±3.0), mean LMC was 63.7 mm (±5.0) and mean LLC was 64.4 mm (±5.0). Except for PCOmed, the mean values of all other FCM parameters were significantly higher in male knees compared to female knees. ACOmed and PCOmed showed significant side-specific differences. There were no significant differences in relation to age and osteoarthritis. Conclusion: The study showed significant differences in FCM side- and gender-specifically in adult knees. These aspects should be considered in the discussion of individual and gender-specific knee joint replacement.

The temporomandibular joint (TMJ) constitutes a bilateral ginglymoarthrodial joint, wherein each condyle interacts with its corresponding glenoid fossa of the temporal bone. There is a critical need to understand better and accurately characterize the temporomandibular joint’s diverse and variable morphological features, which can reveal significant variability across individuals, genders, and age groups. Within this study, we present an innovative condyle detection technique harnessing the potential of deep learning and feature selection (FS) models. Our approach encompasses a multi-stage process, commencing with using YOLOv8 to identify the region of interest (ROI). Subsequently, leveraging a sophisticated deep learning model, we extract salient features from the identified ROI. We modified the Energy Valley Optimizer (EVO) as an FS technique. To substantiate the efficacy of our developed method, a comprehensive dataset of 3000 panoramic images is employed, meticulously classified by two experienced maxillofacial Radiologists into four distinctive types: flat, pointed, angled, and round. The evaluation and comparison results confirm the efficiency of the proposed method in detecting condyle based on various evaluation performance indicators.

Background: Little is known about the clinical characteristics of idiopathic condylar resorption (ICR). The aim of this study was to examine the signs and symptoms of temporomandibular dysfunction (TMD) and evaluate the morphological characteristics of the condyles in patients with ICR. Methods: Sixty patients with ICR (41 in the bilateral ICR group and 19 in the unilateral ICR group) and forty-one healthy controls were examined. Signs and symptoms of TMD were described, and three-dimensional models of the condyles were measured and analyzed. Results: In total, 81.7% of ICR patients had self-reported symptoms and 78.3% of ICR patients had objective-found signs. The anteroposterior diameter, transverse diameter, height, maximal sectional area, volume of the condyles, axial angle, and the distance from the posterior point of the condyle to the Saggittal standard line were significantly smaller in the ICR condyles compared with the controls (p < 0.05). The condylar neck angle was significantly larger in the ICR condyles compared with the controls (p < 0.05). Conclusions: Most patients with ICR had signs and symptoms of TMD. The prevalence of clicking and opening–closing deviation was significantly different between the bilateral and the unilateral ICR groups. In patients with ICR, the size of the condyles decreased significantly; the condyles also rotated inward, moved forward, and inclined posteriorly.

Background This study aimed to determine the differences among various volumes of condylar osseous patterns and the corresponding dentoskeletal characteristics based on the risk of temporomandibular disorder. Methods Craniofacial spiral computed tomography data of 60 Class II hyperdivergent female adults were divided into normal, resorptive, flattened, and osteophyte groups based on condylar osseous forms. The condylar volumes of each group were compared, and their correlations with the dentoskeletal characteristics were assessed in three dimensions. Pairwise least significant difference tests were used to examine individual pairwise differences between groups, and one-way analysis of variance was used to measure differences among multiple groups. Pearson correlation and Spearman rank correlation analyses were used to determine the correlation between condylar volume and dentofacial characteristics. Statistical significance was established at p  < 0.05. Results The condylar volume in the normal group was significantly greater than that in the changed groups, with no significant differences between the subgroups. The decrease in condylar volume was associated with a retruded and clockwise-rotated mandible with shorter rami. Condylar volume was negatively correlated with overjet, the alveolar height of the lower anterior and posterior teeth, sagittal inclinations of the lower teeth, intermolar width of the mandibular first molars, and width between the corresponding alveolar crests. Conclusion Multiple three-dimensional dentoskeletal characteristics of Class II hyperdivergent female adults are correlated with condylar bony changes, regardless of the form. These results could be helpful in indicating potential pathological changes in the temporomandibular joint and in making proper treatment plans for these patients.

Parafunctional habits like bruxism may have a deleterious effect on the temporomandibular joint. It can lead to the alteration of condylar morphology which can further lead to temporomandibular joint disorders. The early three-dimensional evaluation may help detect morphological changes in the condyle and reduce the risk of developing temporomandibular disorders. It will also help to make patients aware of the condition and encourage prompt treatment of parafunctional habits. To do a 3-Dimensional comparative evaluation and correlation of condylar morphology in bruxers and non-bruxers. 90 patients with parafunctional habits will be evaluated on cone beam computed tomography in two groups (control group, study group) of 45 each, for alteration in condylar morphology based on the suggested classification. Results will be formulated based on the classification of condylar morphology. Evaluation of condylar morphology will be done on cone beam computed Tomography based on the amount of variation in condylar morphology in bruxers as compared to non-bruxers. Thorough clinical examination and early evaluation of condylar morphology on cone beam computed tomography will help early detection of changes in the morphology of condyle and prompt treatment to reduce the risk of development of temporomandibular disorders.

Introduction The shape and volume of the condyle is considered to play an important role in the pathogenesis of the mandibular deviation. Curvature analysis is informative for objectively assess whether the shape of the condyles matches that of the glenoid fossa. In this study, a three-dimensional (3-D) quantification of bilateral asymmetrical condyles was firstly conducted to identify the specific role of 3-D condylar configuration for mandibular asymmetry. Methods 55 adult patients, 26 males (26 ± 5 yrs) and 29 females (26 ± 5 yrs), diagnosed with mandibular asymmetry were included. The examination of deviation of chin point, deviation of dental midlines, inclination of occlusal plane, and depth of the mandibular occlusal plane were conducted. After the clinical investigation, computed tomography images from the patients were used to reconstruct the 3-D mandibular models. Then the condylar volume, surface size, surface curvature and bone mineral density were evaluated independently for each patient on non-deviated and deviated sides of temporomandibular joint. Results Both the condylar surface size and volume were significantly larger on deviated side (surface size: 1666.14 ± 318.3 mm 2 , volume: 1981.5 ± 418.3 mm 3 ). The anterior slope of the condyle was flatter (0.12 ± 0.06) and the posterior slope (0.39 ± 0.08) was prominently convex on the deviated side. The corresponding bone mineral density values were 523.01 ±118.1 HU and 549.07 ±120. 6 HU on anterior and posterior slopes. Conclusions The incongruence presented on the deviated side resulted in a reduction in contact areas and, thus, an increase in contact stresses and changes of bone density. All aforementioned results suggest that the difference existing between deviated and non-deviated condyles correlates with facial asymmetrical development. In mandibular asymmetry patients, the 3-D morphology of condyle on deviated side differ from the non-deviated side, which indicates the association between asymmetrical jaw function and joint remodeling.

Background Unilateral sagittal split ramus osteotomy (USSRO) is not widely used given the postoperative instability caused by the inevitable rotation of the mandibular segment during surgery. However, the influence of mandibular movement on the condylar morphology and position stability has not been completely explored. The aim of the study was to quantitatively evaluate the effect of USSRO on the condylar surface morphology changes and postoperative stability in patients with mandibular lateral prognathism and compare these findings with the classic bilateral sagittal split ramus osteotomy (BSSRO). Patients/methods This was a retrospective study involving 134 patients with mandibular lateral prognathism who received USSRO ( n  = 56) and BSSRO ( n  = 78) surgery. Here, cone beam computed tomography (CBCT) was performed before surgery (T0), immediately after surgery (T1), and 1 year postoperatively (T2). Differences of condylar sizes, condylar surface deviation, and mandibular positioning parameters (dental midline deviation, SNB, SN-MP) were calculated from T0 to T2. Comparisons were performed at the deviated side or nondeviated side of condyles between the USSRO and BSSRO groups. The relation between the dental midline deviation and condylar surface morphology changes from T0 to T2 were investigated. Results Condylar surface morphology changes at the deviated side of temporomandibular joint (TMJ) before and 1 year after the surgery were significantly different between the USSRO and BSSRO groups. The dental midline deviation was related to the changes of condylar volume, surface size and surface deviation at the deviated side of TMJ in patients following USSRO. No significant difference was noted between the USSRO and BSSRO groups for postoperative condylar surface morphology changes at the nondeviated side. In both groups, significant differences between T0 and T1 and no significant difference between T1 and T2 were noted for all of the mandibular positioning parameters. Conclusions Both BSSRO and USSRO exhibit favorable postoperative stability in the correction of mandibular prognathism. After USSRO surgery, condylar surface changes occurred at the deviated side of the TMJ, and the dental midline deviation was closely related to the changes of condylar surface morphology. USSRO represents a stable alternative for minor asymmetric mandibular prognathism correction with the advantages of reduced operating time and surgical trauma.

Orthodontic-orthognathic treatment is the standard of care for moderate and/or severe skeletal class III (SCIII) malocclusion. Following orthognathic surgery, morphological changes in the temporomandibular joint structures (TMJ) may contribute to condylar resorption (CR). This systematic review aimed to identify the morphological signs of condylar resorption (changes in the condylar head, position, neck, disk, and joint space) following orthognathic surgery in patients with SCIII compared with those with skeletal class II (SCII) malocclusion. Furthermore, surgical techniques were assessed to investigate the extent to which orthognathic surgery may be related to TMJ disorders and potential muscular changes. A systematic search was conducted using Medline, Pubmed, Scopus, Cochrane Library, Web of Science, and Grey Open literature databases [May 2023; PROSPERO: CRD42021293105)]. Articles that met the eligibility criteria were assessed for quality and the risk of bias using MINORS. A meta-analysis was also conducted. Eleven of the 1014 studies met the eligibility criteria. Of the eligible studies, 10 were considered high-quality. Our results indicated that the incidence of condylar resorption was higher in the SCII group (46.7%) than in the SCIII group (37.2%). The condylar angle was preoperatively higher in the SCII group, and this tendency did not change during the follow-up period. No statistically significant differences in condylar width (95% CI: - 0.62 to 0.43; p = 0.72), height changes (95% CI: - 0.92 to 0.46; p = 0.46), ramus angle (95% CI: - 0.63 to 2.56; p = 0.24) were found between groups. The results suggested that TMJ symptoms were similar between the groups pre- and postoperatively. However, the SCII group showed a higher incidence of anterior disc displacement. Furthermore, postoperative cross-sectional measurements of the lateral pterygoid, medial pterygoid, and masseter muscles were significantly different between the groups. CR could be related to specific skeletal pattern, and the extension of surgical movements may be a risk factor. However, the definition of CR remains vague, and no categorization system regarding SCIII patients has been reported to date.