Explore the vast range of titles available.

Recently, research on data-driven bearing fault diagnosis methods has attracted increasing attention due to the availability of massive condition monitoring data. However, most existing methods still have difficulties in learning representative features from the raw data. In addition, they assume that the feature distribution of training data in source domain is the same as that of testing data in target domain, which is invalid in many real-world bearing fault diagnosis problems. Since deep learning has the automatic feature extraction ability and ensemble learning can improve the accuracy and generalization performance of classifiers, this paper proposes a novel bearing fault diagnosis method based on deep convolutional neural network (CNN) and random forest (RF) ensemble learning. Firstly, time domain vibration signals are converted into two dimensional (2D) gray-scale images containing abundant fault information by continuous wavelet transform (CWT). Secondly, a CNN model based on LeNet-5 is built to automatically extract multi-level features that are sensitive to the detection of faults from the images. Finally, the multi-level features containing both local and global information are utilized to diagnose bearing faults by the ensemble of multiple RF classifiers. In particular, low-level features containing local characteristics and accurate details in the hidden layers are combined to improve the diagnostic performance. The effectiveness of the proposed method is validated by two sets of bearing data collected from reliance electric motor and rolling mill, respectively. The experimental results indicate that the proposed method achieves high accuracy in bearing fault diagnosis under complex operational conditions and is superior to traditional methods and standard deep learning methods.

The motor imagery-based brain-computer interface (BCI) using electroencephalography (EEG) has been receiving attention from neural engineering researchers and is being applied to various rehabilitation applications. However, the performance degradation caused by motor imagery EEG with very low single-to-noise ratio faces several application issues with the use of a BCI system. In this paper, we propose a novel motor imagery classification scheme based on the continuous wavelet transform and the convolutional neural network. Continuous wavelet transform with three mother wavelets is used to capture a highly informative EEG image by combining time-frequency and electrode location. A convolutional neural network is then designed to both classify motor imagery tasks and reduce computation complexity. The proposed method was validated using two public BCI datasets, BCI competition IV dataset 2b and BCI competition II dataset III. The proposed methods were found to achieve improved classification performance compared with the existing methods, thus showcasing the feasibility of motor imagery BCI.

[Objectives]To analyze the influence characteristics of surface water quality by agricultural non-point sources in Guigang City of Guangxi. [Methods]The daily concentration series of water quality indicators at three state-controlled monitoring stations in Guigang City from 2019 to 2021 was analyzed by using Daubechies (db) wavelet, and Morlet wavelet was used to analyze the daily average concentration of water quality indicators. Continuous wavelet transform (CWT) was used to analyze the monthly concentration series of water quality indicators at three state-controlled monitoring stations in Guigang City from 2014 to 2021. [Results]The Daubechies (db) wavelet analysis showed that the concentrations of CODMn, TP, and TN had the maximum values during June-July and October-November, and there were spatial differences among monitoring stations (CODMnconcentration exceeding the standard was the most serious in Shizui, and DO concentration not up to standard was the most in Thermal Power Plant, and NH3-N, TP and TN exceeding the standard was the most in Wulin Ferry). Morlet results showed that principal period of wavelet variance graphs of CODMn, NH3-N, and TP was 340 d, and there was the same sub-period of 140 d, and principal period of wavelet variance graph of DO was 260 d. CWT results showed that CODCrhad similar resonance periods of about 1-2 and 5-7months; BOD5and CODMnwas dominant by the resonance period of 1-4 months (2014-2017); DO had a similar resonance period of about 1-3 months; NH3-Nwas dominant by the resonance period of 1-5 months. [Conclusions]The surface water quality of Guigang City was mainly affected by the residual nitrogen and phosphorus nutrients and pesticide residues from agricultural production activities.

Nowadays, the number of sudden deaths due to heart disease is increasing with the coronavirus pandemic. Therefore, automatic classification of electrocardiogram (ECG) signals is crucial for diagnosis and treatment. Thanks to deep learning algorithms, classification can be performed without manual feature extraction. In this study, we propose a novel convolutional neural networks (CNN) architecture to detect ECG types. In addition, the proposed CNN can automatically extract features from images. Here, we classify a real ECG dataset using our proposed CNN which includes 34 layers. While this dataset is one-dimensional signals, these are transformed into images (scalograms) using continuous wavelet transform (CWT). In addition, the proposed CNN is compared to known architectures: AlexNet and SqueezeNet for classifying ECG images, and we find it more effective than others. This study, which not only performed CWT but also implemented short-time Fourier transform, examines the success in recognizing ECG types for the proposed CNN. Besides, different split methods: training and testing, and cross-validation are applied in this study. Eventually, CWT and cross-validation are the best pre-processing and split methods for the proposed CNN, respectively. Although the results are quite good, we benefit from support vector machines (SVM) to obtain the best algorithm and for detecting ECG types. Essentially, the main aim of the study increases classification results. In this way, the proposed CNN is utilized as deep feature extractor and combined with SVM. As a conclusion of this study, we achieve the highest accuracy of 99.21% from the proposed CNN–SVM when using CWT. Therefore, we can express that this framework can be used as an aid to clinicians for ECG-type identification.

Recently, the use of portable electroencephalogram (EEG) devices to record brain signals in both health care monitoring and in other applications, such as fatigue detection in drivers, has been increased due to its low cost and ease of use. However, the measured EEG signals always mix with the electrooculogram (EOG), which are results due to eyelid blinking or eye movements. The eye-blinking/movement is an uncontrollable activity that results in a high-amplitude slow-time varying component that is mixed in the measured EEG signal. The presence of these artifacts misled our understanding of the underlying brain state. As the portable EEG devices comprise few EEG channels or sometimes a single EEG channel, classical artifact removal techniques such as blind source separation methods cannot be used to remove these artifacts from a single-channel EEG signal. Hence, there is a demand for the development of new single-channel-based artifact removal techniques. Singular spectrum analysis (SSA) has been widely used as a single-channel-based eye-blink artifact removal technique. However, while removing the artifact, the low-frequency components from the non-artifact region of the EEG signal are also removed by SSA. To preserve these low-frequency components, in this paper, we have proposed a new methodology by integrating the SSA with continuous wavelet transform (CWT) and the k-means clustering algorithm that removes the eye-blink artifact from the single-channel EEG signals without altering the low frequencies of the EEG signal. The proposed method is evaluated on both synthetic and real EEG signals. The results also show the superiority of the proposed method over the existing methods.

This article analyses the possibility of using the Analytic Wavelet Transform (AWT) and the Convolutional Neural Network (CNN) for the purpose of recognizing the intrapulse modulation of radar signals. Firstly, the possibilities of using AWT by the algorithms of automatic signal recognition are discussed. Then, the research focuses on the influence of the parameters of the generalized Morse wavelet on the classification accuracy. The paper’s novelty is also related to the use of the generalized Morse wavelet (GMW) as a superfamily of analytical wavelets with a Convolutional Neural Network (CNN) as classifier applied for intrapulse recognition purposes. GWT is used to obtain time–frequency images (TFI), and SqueezeNet was chosen as the CNN classifier. The article takes into account selected types of intrapulse modulation, namely linear frequency modulation (LFM) and the following types of phase-coded waveform (PCW): Frank, Barker, P1, P2, and Px. The authors also consider the possibility of using other time–frequency transformations such as Short-Time Fourier Transform(STFT) or Wigner–Ville Distribution (WVD). Finally, authors present the results of the simulation tests carried out in the Matlab environment, taking into account the signal-to-noise ratio (SNR) in the range from −6 to 0 dB.

The radar sensor described realizes healthcare monitoring capable of detecting subject chest-wall movement caused by cardiopulmonary activities and wirelessly estimating the respiration and heartbeat rates of the subject without attaching any devices to the body. Conventional single-tone Doppler radar can only capture Doppler signatures because of a lack of bandwidth information with noncontact sensors. In contrast, we take full advantage of impulse radio ultra-wideband (IR-UWB) radar to achieve low power consumption and convenient portability, with a flexible detection range and desirable accuracy. A noise reduction method based on improved ensemble empirical mode decomposition (EEMD) and a vital sign separation method based on the continuous-wavelet transform (CWT) are proposed jointly to improve the signal-to-noise ratio (SNR) in order to acquire accurate respiration and heartbeat rates. Experimental results illustrate that respiration and heartbeat signals can be extracted accurately under different conditions. This noncontact healthcare sensor system proves the commercial feasibility and considerable accessibility of using compact IR-UWB radar for emerging biomedical applications.

Left and right hand motor imagery electroencephalogram (MI-EEG) signals are widely used in brain-computer interface (BCI) systems to identify a participant intent in controlling external devices. However, due to a series of reasons, including low signal-to-noise ratios, there are great challenges for efficient motor imagery classification. The recognition of left and right hand MI-EEG signals is vital for the application of BCI systems. Recently, the method of deep learning has been successfully applied in pattern recognition and other fields. However, there are few effective deep learning algorithms applied to BCI systems, particularly for MI based BCI. In this paper, we propose an algorithm that combines continuous wavelet transform (CWT) and a simplified convolutional neural network (SCNN) to improve the recognition rate of MI-EEG signals. Using the CWT, the MI-EEG signals are mapped to time-frequency image signals. Then the image signals are input into the SCNN to extract the features and classify them. Tested by the BCI Competition IV Dataset 2b, the experimental results show that the average classification accuracy of the nine subjects is 83.2%, and the mean kappa value is 0.651, which is 11.9% higher than that of the champion in the BCI Competition IV. Compared with other algorithms, the proposed CWT-SCNN algorithm has a better classification performance and a shorter training time. Therefore, this algorithm could enhance the classification performance of MI based BCI and be applied in real-time BCI systems for use by disabled people.

This article aims to propose an algorithm for the automatic recognition of selected radar signals. The algorithm can find application in areas such as Electronic Warfare (EW), where automatic recognition of the type of intra-pulse modulation or the type of emitter operation mode can aid the decision-making process. The simulations carried out included the analysis of the classification possibilities of linear frequency modulated pulsed waveform (LFMPW), stepped frequency modulated pulsed waveform (SFMPW), phase coded pulsed waveform (PCPW), rectangular pulsed waveforms (RPW), frequency modulated continuous wave (FMCW), continuous wave (CW), Stepped Frequency Continuous Wave SFCW) and Phase Coded Continuous Waveform (PCCW). The algorithm proposed in this paper is based on the use of continuous wavelet transform (CWT) coefficients and higher-order statistics (HOS) in the feature determination of selected signals. The Principal Component Analysis (PCA) method was used for dimensionality reduction. An artificial neural network was then used as a classifier. Simulation studies took into account the presence of noise interference with signal-to-noise ratio (SNR) in the range from −5 to 10 dB. Finally, the obtained classification efficiency is presented in the form of a confusion matrix. The simulation results show a high recognition test accuracy, above 99% with a signal-to-noise ratio greater than 0 dB. The article also deals with the selection of the type and parameters of the wavelet. The authors also point to the problems encountered during the research and examples of how to solve them.