Explore the vast range of titles available.

We report on the coupling of the emission from a single europium-doped nanocrystal to a fiber-based microcavity under cryogenic conditions. As a first step, we study the properties of nanocrystals that are relevant for cavity experiments and show that embedding them in a dielectric thin film can significantly reduce scattering loss and increase the light-matter coupling strength for dopant ions. The latter is supported by the observation of a fluorescence lifetime reduction, which is explained by an increased local field strength. We then couple an isolated nanocrystal to an optical microcavity, determine its size and ion number, and perform cavity-enhanced spectroscopy by resonantly coupling a cavity mode to a selected transition. We measure the inhomogeneous linewidth of the coherent 5 D 0 - 7 F 0 transition and find a value that agrees with the linewidth in bulk crystals, evidencing a high crystal quality. We detect the fluorescence from an ensemble of few ions in the regime of power broadening and observe an increased fluorescence rate consistent with Purcell enhancement. The results represent an important step towards the efficient readout of single rare earth ions with excellent optical and spin coherence properties, which is promising for applications in quantum communication and distributed quantum computation.

The development of quantum technologies is one of the big challenges in modern research. A crucial component for many applications is an efficient, coherent spin–photon interface, and coupling single-color centers in thin diamond membranes to a microcavity is a promising approach. To structure such micrometer thin single-crystal diamond (SCD) membranes with a good quality, it is important to minimize defects originating from polishing or etching procedures. Here, we report on the fabrication of SCD membranes, with various diameters, exhibiting a low surface roughness down to 0.4 nm on a small area scale, by etching through a diamond bulk mask with angled holes. A significant reduction in pits induced by micromasking and polishing damages was accomplished by the application of alternating Ar/Cl2 + O2 dry etching steps. By a variation of etching parameters regarding the Ar/Cl2 step, an enhanced planarization of the surface was obtained, in particular, for surfaces with a higher initial surface roughness of several nanometers. Furthermore, we present the successful bonding of an SCD membrane via van der Waals forces on a cavity mirror and perform finesse measurements which yielded values between 500 and 5000, depending on the position and hence on the membrane thickness. Our results are promising for, e.g., an efficient spin–photon interface.