Explore the vast range of titles available.

The acidocalcisome is an acidic organelle in the cytosol of eukaryotes, defined by its low pH and high calcium and polyphosphate content. It is visualized as an electron-dense object by transmission electron microscopy (TEM) or described with mass spectrometry (MS)–based imaging techniques or multimodal X-ray fluorescence microscopy (XFM) based on its unique elemental composition. Compared with MS-based imaging techniques, XFM offers the additional advantage of absolute quantification of trace metal content, since sectioning of the cell is not required and metabolic states can be preserved rapidly by either vitrification or chemical fixation. We employed XFM in Chlamydomonas reinhardtii to determine single-cell and organelle trace metal quotas within algal cells in situations of trace metal overaccumulation (Fe and Cu). We found up to 70% of the cellular Cu and 80% of Fe sequestered in acidocalcisomes in these conditions and identified two distinct populations of acidocalcisomes, defined by their unique trace elemental makeup. We utilized the vtc1 mutant, defective in polyphosphate synthesis and failing to accumulate Ca, to show that Fe sequestration is not dependent on either. Finally, quantitation of the Fe and Cu contents of individual cells and compartments via XFM, over a range of cellular metal quotas created by nutritional and genetic perturbations, indicated excellent correlation with bulk data from corresponding cell cultures, establishing a framework to distinguish the nutritional status of single cells.

•The future of bone grafting materials lies in osteoinductive capabilities.•Bone requires a variety of important ions to maintain healthy functionality.•The addition of important ions to calcium phosphate (CaP) materials can have beneficial effects. General trends in synthetic bone grafting materials are shifting towards approaches that can illicit osteoinductive properties. Pharmacologics and biologics have been used in combination with calcium phosphate (CaP) ceramics, however, they have recently become the target of scrutiny over safety. The importance of trace elements in natural bone health is well documented. Ions, for example, lithium, zinc, magnesium, manganese, silicon, strontium, etc., have been shown to increase osteogenesis and neovascularization. Incorporation of dopants (trace metal ions) into CaPs can provide a platform for safe and efficient delivery in clinical applications where increased bone healing is favorable. This review highlights the use of trace elements in CaP biomaterials, and offers an insight into the mechanisms of how metal ions can enhance both osteogenesis and angiogenesis.

The international GEOTRACES program has been instrumental in demonstrating how marine sediments are a critical source of dissolved Fe to the world's oceans. Here, we present dissolved iron (dFe) from the GEOTRACES North Pacific GP15 section, which, alongside other sediment‐source tracers (including dissolved δ56Fe, Mn, 228Ra, and particulate Fe), allows for identification of the dFe provenance of three distinct dFe depth maxima at the Alaskan margin. Two of these (shelf and abyssal depths) are of local Alaskan sedimentary origin. The third, a mid‐depth dFe maximum with an absence of 228Ra, is an advected signal that, based on tracer data from Western Pacific GEOTRACES transects and circulation models, must be advected from sedimentary sources on the Asian margin, ∼5,000 km away. This study illustrates the importance of measuring diagnostic sedimentary tracers like radium when assigning local margins as sedimentary sources of marine trace metal budgets. Plain Language Summary Iron is an essential, yet limiting, micronutrient for marine primary producers, and thus influences patterns of global oceanic primary productivity and carbon exchange. In recent years, the International GEOTRACES program has highlighted that marine sediments, hydrothermal vents, and atmospheric dust all supply dissolved iron to the oceans. Here, we investigated the sources of dissolved iron to the Eastern North Pacific Ocean, using samples collected on the U.S. GEOTRACES GP15 Pacific Meridional Cruise that sailed from Alaska to Tahiti in 2018. We identified three elevated dissolved iron features close to the Alaskan continental margin, with two originating from local sedimentary sources (shelf and abyss). The third, an intermediate depth dissolved iron plume that extends south into the gyre, is not of local sedimentary origin, but instead results from long‐distance transport of dissolved iron from Asian marginal sediment sources. A critical aspect of this study is the use of multiple chemical tracers such as radium, iron, and manganese, coupled with ocean circulation models, to correctly attribute the sources of trace metals to the ocean. Key Points Three distinct dFe maxima were identified close to the Alaskan margin at different depths. Two are of local origin (shelf and abyssal) An intermediate depth dFe plume with an absence of Mn and Ra, is a distal advected signal from Asian margin sedimentary sources (5,000 km away) A multiple tracer approach of Fe, Mn, and Ra was necessary to rule out what appeared to be a local margin source

With the ever-growing concern for human health and wellbeing, the prenatal period of development requires special attention since fetuses can be exposed to various metals through the mother. Therefore, this study explored the status of selected toxic (Pb, Cd, Ni, As, Pt, Ce, Rb, Sr, U) and essential trace metals (Mn, Co, Cu, Zn, Se) in the umbilical cord (UC) sera, maternal sera, and placental tissue samples of 92 healthy women with normal pregnancies. A further aim focuses on the potential transplacental transfer of these trace metals. Based on the obtained levels of investigated elements in clinical samples, it was observed that all of the trace metals cross the placental barrier and reach the fetus. Furthermore, statistical analysis revealed significant differences in levels of toxic Ni, As, Cd, U, Sr, Rb, and essential Mn, Cu, and Zn between all three types of analyzed clinical samples. Correlation analysis highlighted As to be an element with levels that differed significantly between all tested samples. Principal component analysis (PCA) was used to enhance these findings. PCA demonstrated that Cd, Mn, Zn, Rb, Ce, U, and Sr were the most influential trace metals in distinguishing placenta from maternal and UC serum samples. As, Co, and Cu were responsible for the clustering of maternal serum samples, and PCA demonstrated that the Pt level in UC sera was responsible for the clustering of these samples. Overall, the findings of this study could contribute to a better understanding of transplacental transfer of these trace metals, and shed a light on overall levels of metal exposure in the population of healthy pregnant women and their fetuses.

Heavy metal pollution in marine ecosystems is an escalating environmental concern, largely driven by anthropogenic activities, and poses potential threats to ecological health and human well-being. This study embarked on a comprehensive investigation into the concentrations of heavy metals in sediment samples and evaluated their potential ecological and health risks with a focus on Eastern St. Martin’s Island (SMI), Bangladesh. Sediment samples were meticulously collected from 12 distinct sites around the island, and the concentrations of heavy metals, including Mn, Fe, Ni, Zn, Cr, Pb, and Cu, were quantified utilizing atomic absorption spectrometry (AAS). The results revealed that the average concentrations of the metals, in descending order, were Mn (269.5 ± 33.0 mg/kg), Fe (143.8 ± 21.7 mg/kg), Ni (29.6 ± 44.0 mg/kg), Zn (27.2 ± 4.34 mg/kg), Cr (8.09 ± 1.67 mg/kg), Pb (5.88 ± 0.45 mg/kg), and Cu (3.76 ± 0.60 mg/kg). Intriguingly, the concentrations of all the measured metals were found to be within permissible limits and comparatively lower than those documented in various national and international contexts. The ecological risk assessment, based on multiple sediment quality indices such as the geoaccumulation index, contamination factor, and pollution load index, indicated a moderate risk to the aquatic ecosystem but no significant adverse impact on sediment quality. Additionally, the human health risk assessment, encompassing non-carcinogenic hazard indices for different age groups, was considerably below the threshold, signifying no immediate health risk. The total carcinogenic risk was also found to be below acceptable levels. These findings underscore the current state of heavy metal pollution in Eastern St. Martin’s Island, providing valuable insights for environmental monitoring and management. While the immediate risks were not alarming, the study highlights the imperative need for sustained monitoring and the implementation of rigorous regulations to curb heavy metal pollution in order to safeguard both ecological and human health. This warrants the development of policies that are both adaptive and preemptive to ensure the sustainable utilization and conservation of marine resources.

The impact of the ethylenediaminetetraacetic acid (EDTA) on speciation image of selected trace metals (Zn, Cd, Cu, Pb) in bottom sediments was determined. The influence on the effectiveness of metal removal of extraction multiplicity, type of metal, extraction time and concentration of EDTA were analyzed. With the increase of extraction multiplicity, the concentration of EDTA and contact time, the efficiency of trace metals leaching increased. The speciation analysis revealed that EDTA not only leached metals from bioavailable fractions, but also caused the transition of the metals between the fractions. The biggest amounts of bioavailable forms were found for Cd, less for Zn. The amount of bioavailable fraction was the lowest for Cu and Pb. The two first-order kinetic models fitted well the kinetics of metals extraction with EDTA, allowing the metals fractionation into “labile” (Q1), “moderately labile” (Q2) and “not extractable” fractions (Q3).

Certification of trace metals in seawater certified reference materials (CRMs) NASS-7 and CASS-6 is described. At the National Research Council Canada (NRC), column separation was performed to remove the seawater matrix prior to the determination of Cd, Cr, Cu, Fe, Pb, Mn, Mo, Ni, U, V, and Zn, whereas As was directly measured in 10-fold diluted seawater samples, and B was directly measured in 200-fold diluted seawater samples. High-resolution inductively coupled plasma mass spectrometry (HR-ICPMS) was used for elemental analyses, with double isotope dilution for the accurate determination of B, Cd, Cr, Cu, Fe, Pb, Mo, Ni, U, and Zn in seawater NASS-7 and CASS-6, and standard addition calibration for As, Co, Mn, and V. In addition, all analytes were measured using standard addition calibration with triple quadrupole (QQQ)-ICPMS to provide a second set of data at NRC. Expert laboratories worldwide were invited to contribute data to the certification of trace metals in NASS-7 and CASS-6. Various analytical methods were employed by participants including column separation, co-precipitation, and simple dilution coupled to ICPMS detection or flow injection analysis coupled to chemiluminescence detection, with use of double isotope dilution calibration, matrix matching external calibration, and standard addition calibration. Results presented in this study show that majority of laboratories have demonstrated their measurement capabilities for the accurate determination of trace metals in seawater. As a result of this comparison, certified/reference values and associated uncertainties were assigned for 14 elements in seawater CRMs NASS-7 and CASS-6, suitable for the validation of methods used for seawater analysis.

With the expansion of industrial activities, the escalation of pollution by trace metals poses an increasing threat to bees. While the effects of metals on adult bees have been extensively studied in ecotoxicological research, a critical gap persists concerning their impact on bee larvae. Here, we conducted the first study exposing bumble bee larvae to field-realistic concentrations of copper via an in vitro assay, over a span of 25 days. We monitored the duration of their developmental stages, including moments of defecation, pupation, and emergence, alongside their survival rates. Additionally, we recorded their area growth as well as their adult body mass post-emergence. Despite copper exposure exhibiting no discernible influence on the overall duration of development, survival, growth, or adult mass, a significant positive effect was observed on the pupation rate. This outcome is likely attributable to heightened copper-dependent metabolic activities and disturbances in the redox balance. Furthermore, our investigation underscored the pivotal role of initial body size in developmental success, with larger larvae showing elevated emergence and survival rates. Given the efficacy of this assay, we urge regulatory institutions responsible for approving pesticides and other xenobiotics for market use to embrace this experimental approach in future risk assessments.

The status of essential and toxic trace metals in the blood of Crohn’s disease (CD) patients is unexplained. This study aimed to provide the first elemental profiling of the most recognized essential elements (Mn, Cu, Zn, Se) and selected toxic trace elements (As, Cd, Pb, and U) in sera and cell lysate (CL) samples of CD patients (n = 84). The results were compared with sex- and age-matched samples from the control group (CG). CD sera contained significantly higher levels of Mn, As, Cd, Pb, and U than did CG sera. An identical pattern, with the added inclusion of Cu (also higher in CD patients than in the CG), was obtained for CL samples. However, the most important finding was hypermanganesemia, which indicates that Mn could act as a toxic trace metal in CD. As, Cd, and U were the most significant toxic elements that showed antagonistic effects on the extrusion of essential Mn and Cu. Circulatory system screening markers for CD are hereby proposed (Mn/Cu, Mn/As, and Mn/Pb ratios). These three metal ratios were strongly and significantly correlated with F-Calprotectin levels, and deserve consideration as new markers of CD. The target metals and metal ratios should be taken into consideration as novel initiating and/or modifying factors for CD.