Asset Details
Do you wish to reserve the book?
Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations
Hey, we have placed the reservation for you!
By the way, why not check out events that you can attend while you pick your title.
Oops! Something went wrong.
Looks like we were not able to place the reservation. Kindly try again later.
Are you sure you want to remove the book from the shelf?
Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations
Do you wish to request the book?
Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations
Please be aware that the book you have requested cannot be checked out. If you would like to checkout this book, you can reserve another copy
We have requested the book for you!
Your request is successful and it will be processed during the Library working hours. Please check the status of your request in My Requests.
Oops! Something went wrong.
Looks like we were not able to place your request. Kindly try again later.
Paper
Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations
2024
Overview
The heat flux mitigation during the Thermal Quench (TQ) by the Shattered Pellet Injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma, and is ultimately checked by the heat deposition on to the PFCs. To investigate this, JOREK simulations of neon-mixed dual-SPIs into ITER baseline H-mode and a \"degraded H-mode\" with and without good injector synchronization are performed with focus on the first wall heat flux and its energy impact. It is found that low neon fraction SPIs into the baseline H-mode plasmas exhibit strong major radial plasmoid drift as the fragments arrive at the pedestal, accompanied by edge stochasticity. Significant density expulsion and outgoing heat flux occurs as a result, reducing the mitigation efficiency. Such drift motion could be mitigated by injecting higher neon fraction pellets', or by considering the pre-disruption confinement degradation, thus improving the radiation fraction. The radiation heat flux is found to peak in the vicinity of the fragment injection location in the early injection phase, while it relaxes later on due to parallel impurity transport. The overall radiation asymmetry could be significantly mitigated by good synchronization. Time integration of the local heat flux is carried out to provide its energy impact for wall heat damage assessment. For the baseline H-mode case with full pellet injection, melting of the stainless steel of the diagnostic port could occur near the injection port, which is acceptable, without any melting of the first wall tungsten tiles. For the degraded H-mode cases with quarter-pellet SPIs, which have 1/4 total volume of a full pellet, the maximum energy impact approaches the tolerable limit of the stainless steel with un-synchronized SPIs, and stays well below such limit for the perfectly synchronized ones.
Publisher
Cornell University Library, arXiv.org
Subject
