Asset Details
Do you wish to reserve the book?
Surface characterization of laser-induced molten area in micro-grooving of silicon by ultraviolet (UV) laser
Hey, we have placed the reservation for you!
By the way, why not check out events that you can attend while you pick your title.
Oops! Something went wrong.
Looks like we were not able to place the reservation. Kindly try again later.
Are you sure you want to remove the book from the shelf?
Surface characterization of laser-induced molten area in micro-grooving of silicon by ultraviolet (UV) laser
Do you wish to request the book?
Surface characterization of laser-induced molten area in micro-grooving of silicon by ultraviolet (UV) laser
Please be aware that the book you have requested cannot be checked out. If you would like to checkout this book, you can reserve another copy
We have requested the book for you!
Your request is successful and it will be processed during the Library working hours. Please check the status of your request in My Requests.
Oops! Something went wrong.
Looks like we were not able to place your request. Kindly try again later.
Journal Article
Surface characterization of laser-induced molten area in micro-grooving of silicon by ultraviolet (UV) laser
2021
Overview
The objective of this research is to understand the fundamental mechanisms that govern the formation of laser-induced molten area during the micro-grooved fabrication on silicon material. In this research work, micro grooves were fabricated on silicon wafer by using ultraviolet (UV) laser of 248nm wavelength. Influence of lasing parameters such as pulse duration, laser pulse energy and scanning speed on the surface of micro-grooved was characterized. It is found that, the width of the micro grooves become wider with increasing laser pulse energy when ultraviolet laser was irradiated on silicon material. On the other hand, heat affected zone (HAZ) can be found at the surface of micro groove line at high pulse energy, high pulse repetition rate and lower scanning speed irradiation condition. This is considered due to the excessive heat input of the laser irradiation condition. It is concluded that proper selection of laser processing parameters of pulse energy, E , pulse repetition rate, R p , and scanning speed is necessary to achieve high quality micro-grooves.
Publisher
IOP Publishing
Subject
