Asset Details
Do you wish to reserve the book?
Micro-aluminum powder with bi- or tri-component alloy coating as a promising catalyst: Boosting pyrolysis and combustion of ammonium perchlorate
Hey, we have placed the reservation for you!
By the way, why not check out events that you can attend while you pick your title.
Oops! Something went wrong.
Looks like we were not able to place the reservation. Kindly try again later.
Are you sure you want to remove the book from the shelf?
Micro-aluminum powder with bi- or tri-component alloy coating as a promising catalyst: Boosting pyrolysis and combustion of ammonium perchlorate
Do you wish to request the book?
Micro-aluminum powder with bi- or tri-component alloy coating as a promising catalyst: Boosting pyrolysis and combustion of ammonium perchlorate
Please be aware that the book you have requested cannot be checked out. If you would like to checkout this book, you can reserve another copy
We have requested the book for you!
Your request is successful and it will be processed during the Library working hours. Please check the status of your request in My Requests.
Oops! Something went wrong.
Looks like we were not able to place your request. Kindly try again later.
Journal Article
Micro-aluminum powder with bi- or tri-component alloy coating as a promising catalyst: Boosting pyrolysis and combustion of ammonium perchlorate
2024
Overview
A novel design of micro-aluminum (μAl) powder coated with bi-/tri-component alloy layer, such as: Ni–P and Ni–P–Cu (namely, Al@Ni–P, Al@Ni–P–Cu, respectively), as combustion catalysts, were introduced to release its huge energy inside Al-core and promote rapid pyrolysis of ammonium perchlorate (AP) at a lower temperature in aluminized propellants. The microstructure of Al@Ni–P–Cu demonstrates that a three-layer Ni–P–Cu shell, with the thickness of ∼100 nm, is uniformly supported by μAl carrier (fuel unit), which has an amorphous surface with a thickness of ∼2.3 nm (catalytic unit). The peak temperature of AP with the addition of Al@Ni–P–Cu (3.5%) could significantly drop to 316.2 °C at high-temperature thermal decomposition, reduced by 124.3 °C, in comparison to that of pure AP with 440.5 °C. It illustrated that the introduction of Al@Ni–P–Cu could weaken or even eliminate the obstacle of AP pyrolysis due to its reduction of activation energy with 118.28 kJ/mol. The laser ignition results showed that the ignition delay time of Al@Ni–P–Cu/AP mixture with 78 ms in air is shorter than that of Al@Ni–P/AP (118 ms), decreased by 33.90%. Those astonishing breakthroughs were attributed to the synergistic effects of adequate active sites on amorphous surface and oxidation exothermic reactions (7597.7 J/g) of Al@Ni–P–Cu, resulting in accelerated mass and/or heat transfer rate to catalyze AP pyrolysis and combustion. Moreover, it is believed to provide an alternative Al-based combustion catalyst for propellant designer, to promote the development the propellants toward a higher energy.
Publisher
Elsevier B.V,KeAi Communications Co., Ltd
