Asset Details
Do you wish to reserve the book?
Impact of the Vehicle Environment on the Thermal Behavior of the Electrical Wiring
Hey, we have placed the reservation for you!
By the way, why not check out events that you can attend while you pick your title.
Oops! Something went wrong.
Looks like we were not able to place the reservation. Kindly try again later.
Are you sure you want to remove the book from the shelf?
Impact of the Vehicle Environment on the Thermal Behavior of the Electrical Wiring
Do you wish to request the book?
Impact of the Vehicle Environment on the Thermal Behavior of the Electrical Wiring
Please be aware that the book you have requested cannot be checked out. If you would like to checkout this book, you can reserve another copy
We have requested the book for you!
Your request is successful and it will be processed during the Library working hours. Please check the status of your request in My Requests.
Oops! Something went wrong.
Looks like we were not able to place your request. Kindly try again later.
Journal Article
Impact of the Vehicle Environment on the Thermal Behavior of the Electrical Wiring
2022
Overview
The thermal behavior of wires within the electrical distribution system (EDS) has a strong impact on the conductor cross section, the type of insulation, the derating, and the fusing system, and therefore on weight, cost, and reliability. Consequently, significant efforts have been made to develop sound static and dynamic thermal models for single wires and wire bundles. However, these models are based on the simplifying assumption that the object is completely surrounded by air, where, with the exception of free convection, airflow can be neglected, and where no interaction with other objects is considered.
The approach presented in this paper takes into account the actual environment and routing within a vehicle, where some objects such as metal sheets can be considered as heat sinks and other objects, e.g. a motor block, as heat sources. For this reason, measurements were performed using an experimental set-up that allows any desired positioning and alignment of the DuT (device under test, here: wire, cable, bundle) and of two temperature-controlled heat source/sink objects. These objects are a large rectangular surface and a small sphere, in order to be able to emulate as many spatial configurations as possible. The overall set-up is protected against externally-induced airflows. Because the exact modelling of the heat transfer processes (radiation, conduction, and free/forced convection) would require time-consuming FEM calculations for the investigated complex geometries, a simplified and partially data-driven model is proposed. The paper describes the theory and the modeling approach, and presents initial simulation and measurement results.
Publisher
SAE International,SAE International, a Pennsylvania Not-for Profit
Subject
