Asset Details
Do you wish to reserve the book?
Effect of liquid nitrogen cooling on surface integrity in cryogenic milling of Ti-6Al-4 V titanium alloy
Hey, we have placed the reservation for you!
By the way, why not check out events that you can attend while you pick your title.
Oops! Something went wrong.
Looks like we were not able to place the reservation. Kindly try again later.
Are you sure you want to remove the book from the shelf?
Effect of liquid nitrogen cooling on surface integrity in cryogenic milling of Ti-6Al-4 V titanium alloy
Do you wish to request the book?
Effect of liquid nitrogen cooling on surface integrity in cryogenic milling of Ti-6Al-4 V titanium alloy
Please be aware that the book you have requested cannot be checked out. If you would like to checkout this book, you can reserve another copy
We have requested the book for you!
Your request is successful and it will be processed during the Library working hours. Please check the status of your request in My Requests.
Oops! Something went wrong.
Looks like we were not able to place your request. Kindly try again later.
Journal Article
Effect of liquid nitrogen cooling on surface integrity in cryogenic milling of Ti-6Al-4 V titanium alloy
2020
Overview
Owing to poor thermal conductivity, heat dissipation, and high chemical reactivity toward most of the tool materials, temperature elevation in the machining of titanium alloy leads to poor surface quality. Based on analyzing the variation laws of the milling forces under cryogenic cooling, the present investigation concerns the surface integrity (surface roughness, micro-hardness, microstructures, and residual stresses) in cryogenic milling of Ti-6Al-4 V alloy under the application of liquid nitrogen (LN
2
) as a cooling mode. Findings have indicated a dramatic increase in milling forces, and decreasing surface roughness was observed under variation of jet temperature (20~−196 °C). Besides an increase in cutting speed from 60 to 120 m/min, a linear increase in cutting forces, surface roughness, micro-hardness, and residual compressive stress was observed. The minimum micro-hardness decreased at cutting speed of 90 m/min and up to 30 μm in depth. A holistic comparison between obtained results under cryogenic milling and previously studied results under dry milling at same cutting conditions depicted higher micro-hardness and higher compressive residual stress under cryogenic LN
2
on the machined surface. However, the residual stress under LN
2
cooling conditions tends to decrease relatively slower compared to dry milling. Also, there are no significant differences in grain refinement and twisting under dry and cryogenic LN
2
machining. The research work proves the effectiveness of cryogenic milling in improving the surface integrity of the Ti-6Al-4 V alloy.
Publisher
Springer London,Springer Nature B.V
