Journal Article

Development of a Flexible MEMS Sensor for Subsonic Flow

Ichikawa, Yoshiyasu, Shiraishi, Daiki, Mizumi, Shunsuke, Oya, Yoshiko, Motosuke, Masahiro, Omura, Naoto, Shibata, Takanori, Murakami, Koichi

2022

Overview

Detection and control of flow separation is a key to improving the efficiency of fluid machinery. In this study, we developed a flexible MEMS (microelectromechanical systems) sensor for measuring the wall shear stress and flow angle in subsonic airflow. The developed sensor is made of a flexible polyimide film and a microheater surrounded by three temperature sensor pairs. The sensor measures the wall shear stress from the heater output and the flow angle from the temperature gradient around the heater. The geometry and design of the heater and temperature sensors were determined based on numerical simulations. To evaluate the validity of the sensor, we conducted an experiment to measure the wall shear stress and the flow angle in a wind tunnel in different velocities ranging from 30 m/s to 170 m/s, equivalent to Mach numbers from 0.1 to 0.5. The heater output was proportional to one-third power of the wall shear stress. Additionally, the bridge output correlating the temperature difference between two opposing temperature sensors showed sinusoidal variation depending on the flow angle. Consequently, we have clarified that the developed sensor can measure both the wall shear stress and flow direction in subsonic flow.

• Publisher: MDPI AG,MDPI
• Subject: Air flow / Design and construction / flow direction / flow rate / Flow separation / Flow velocity / Fluid dynamics / Greenhouse gases / Heat / hot-film / Mechanical properties / MEMS flow sensor / Microelectromechanical systems / Polyethylene terephthalate / Sensors / Shear flow / Shear stress / Simulation / Subsonic flow / Temperature / Temperature gradients / Temperature sensors / Turbulence models / Wall shear stresses / Wind tunnels