Asset Details
Do you wish to reserve the book?
Study of inception point, void fraction and pressure over pooled stepped spillways using Flow-3D
Hey, we have placed the reservation for you!
By the way, why not check out events that you can attend while you pick your title.
Oops! Something went wrong.
Looks like we were not able to place the reservation. Kindly try again later.
Are you sure you want to remove the book from the shelf?
Study of inception point, void fraction and pressure over pooled stepped spillways using Flow-3D
Do you wish to request the book?
Study of inception point, void fraction and pressure over pooled stepped spillways using Flow-3D
Please be aware that the book you have requested cannot be checked out. If you would like to checkout this book, you can reserve another copy
We have requested the book for you!
Your request is successful and it will be processed during the Library working hours. Please check the status of your request in My Requests.
Oops! Something went wrong.
Looks like we were not able to place your request. Kindly try again later.
Journal Article
Study of inception point, void fraction and pressure over pooled stepped spillways using Flow-3D
2018
Overview
Purpose
While many stepped spillways geometry design guidelines were developed for flat steps, designing pooled steps might be an appropriate alternative to spillways working more efficiency. This paper aims to deal with the inception point of air-entrainment and void fraction in the different height of the pools. Following that, pressure distribution was evaluated in aerated and non-aerated regions under the effect of different heights of the pools and slopes through the use of the FLOW-3D software. Comparison of obtained numerical results with experimental ones was in good agreement for all discharges used in this study. Pools height had the insignificant effect on the inception point location. The value of void fraction was more affected in lower discharges in comparison with higher ones. Negative pressure was not seen over the crest of spillway (non-aerated region), and the maximum pressure values were obtained for pools with 15 cm height along the crest in each discharge. In all slopes, negative pressure was not formed near the step bed in the pooled and flat stepped spillways. However, negative pressure was formed in more area near the vertical face in the flat stepped spillway compared with the pooled stepped spillway which increases the probability of cavitation phenomenon in the flat stepped chute.
Design/methodology/approach
A pooled stepped spillway was used in order to evaluate pressure, void fraction, and inception point. Also, different height of the pools was used. Numerical simulation of this study was fulfilled through Flow-3D software. The obtained results indicated that pools can affect two-phase flow characteristics including pressure, void fraction and inception point.
Findings
Over the crest, negative pressure was not seen. Pressure values were different for all used heights and the maximum ones obtained for 15 cm height. Also, pooled stepped played a more effective role in reducing the negative pressure points compared with flat cases. Inception point location was more affected in nappe and transition flow regimes in comparison with skimming flow regime particularly for 9 and 15 cm heights.
Originality/value
The research results of Felder et al. (2012a) from the University of Queensland were used to numerically simulate the flow over the pooled stepped spillway.
